Question about Mazda Protege

1 Answer

Radio was replaced now heating does not work where do the control hookup to

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 157 Answers

Back behind the radio is were all the vacum lines hook up the cables to change everything are behind the heater controls

Posted on Jan 04, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Volvo S80 - 2000 ..replaced battery and now my center panel that controls the heat/ac/radio, etc is not working ...how would I fix this


take the battery connections off hold cables together for 5 to 10 min.then replace the cables to battery use your remote to unlock car get in and start car.your security system is the problem this will reset it

Aug 26, 2012 | 2000 Volvo S80

1 Answer

No sound from radio


My FM band stopped working. AM and casset still worked. Found parts car, replaced radio, all is good. The FM display still worked-no sound.
Terry

Jun 02, 2012 | 1995 Jeep Grand Cherokee

1 Answer

Heat does not work for a catera 97 what it could be the problem


there is actuators that open up the vent doors so you can control where the air goes , Well there is also 1 that controls hot and cold air flow at the heater core, the actuator is almost impossible 2 replace without taking out the dash but you can disconnect it and open it manually. You will have 2 tie it up so it stays open , if you go this route your A/C wont work unless you shut the door or replace the actuator , even doing this manually is pretty tricky because you may have to remove the glove box radio and heater controls just 2 be able 2 feel around back there but the 1 you are looking 4 is closer 2 the floor on passenger side near the radio

Dec 09, 2011 | 1997 Cadillac Catera

1 Answer

I would like to avoid using a FM transmitter to use


There are harnesses that go inbetween the existing radio and the car that allow for an ipod hookup. The cost of these is a little high. I opted for a new radio for my 2005 Malibu for this reason, but I still needed a adpter harness because the cars computer doesn't just allow you to replace the radio with althing you want.
So for these harnesses, you pull of the connector of the back of the radio and install this new one. Check ebay for this.

Dec 29, 2009 | 2005 Chevrolet Avalanche

1 Answer

2002 Pontiac Bonneville, will not switch from a/c to heat unless you manually move the actuator over (I think that is what he called it). Has anyone had a similar problem? It will get hot or cold but will...


the vaccum control switch on the dash is bad. it is a funny looking little black thing with several hose hookups on it. remove the control knob for switching from ac top vent to floor vent.very inexpensive. not easy to replace

Sep 17, 2009 | 2003 Pontiac Bonneville

1 Answer

How do you remove the radio in a 2009 GMC Canyon?


you have to start by removing the trim around the radio. it just pulls towards you then unplug connector (if any). Remove three 7 mm bolts from the radio mounts. Radio will just pull out. Not if you replacing it with aftermarket. there is now acc wire in the harness and the ignition switch is to weak to power this wire so the use of a GMRC01 from metra electronics will work perfect to supply you with all the connections needed for the aftermarket hookup

Sep 02, 2009 | 2009 GMC Canyon

1 Answer

What are the 2 extra wires on the back of my 2001 delco radio


the purplr wire are data wires and are needed to hookup to the olds alero computer to allow it to turn on. these radios do not use acc. power wire to turn on. they get a data signal from the Body control module in the car it is installed originally. If you know what you are doing you can hookup up a BCM from a diiferent car and send the data from it to the radio. but takes alot of time and knowledge.

Jul 14, 2009 | 2001 Pontiac Grand Am SE

1 Answer

2007 Toyota Sequoia Dashboard Access to Radio console FM Antenna


Pull off the 3 knobs for the heat controls. You will see a screw under the center knob. Remove it. Look to see if there are any screws near the vent grilles, remove them, if they are there. The whole center fascia then pulls out towards you. Remove the 4 bolts, and the radio is out. Easy.

Feb 06, 2009 | 2007 Toyota Sequoia

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...