Question about Nissan Maxima

Open Question

Car has no power. it wont accelerate past 3k rpms without falling on its nose. No codes show up. New pump and filter. Today the check engine light started flashing. It did it for like 10 seconds then went out. This is weird. Any ideas?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: engine light is on ,code P0171, hesitates when start driving

If you have had a bad enough problem with the fuel filter, and it is not the fuel pump I would have to say it is the injectors. If your car is fuel injected there could be dirt in the injectors in which case they will need to be replaced. The problem is you can flush the whole fuel system except for the fuel injectors themselves. Though I am not sure how to check them myself, a mechanic could tell you if this is the problem in minutes. I cant say for sure if this is your problem but I have a 79 corrolla and it is doing the same thing and since I have replaced almost the whole fuel line except for the injectors themselves this is what I am leaning towards. Good luck!

Posted on Jun 08, 2009

  • 396 Answers

SOURCE: 2001 Isuzu Rodeo Check Engine Light flashes when accelerating.

I would change the trans flter, trans fluid, and have the linkage on the trans adjusted.

Posted on Jul 21, 2009

  • 50 Answers

SOURCE: 97 subaru outback 2.5 over heats going up hill at about 3000 rpms

Check the oil again. If the level is higher than it was after you changed it and/or is pasty again (kind of like milkshake) then you have coolant getting into it--most likely through a leaking or blown head gasket.

Posted on Feb 26, 2010

  • 14585 Answers

SOURCE: Car has no power when

Check the catalitic convertor, sounds as if it is clogging up

Posted on Nov 11, 2010

  • 3 Answers

SOURCE: P2103 throttle actuator control motor

Give me some more information about this problem. May be i can help.

Posted on Jul 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 kia rio acceleration will not go past 2500 rpms


there can be few things...first thing first
is your car missing...if yes then check plugs, any bad wire

- check for dirty fuel injectors (have u ever cleaned fuel tank) if ok then
- if u have easy access to intank fuel pump, replace its filter..
- check for bad TPS... if ok then
- check for bad O2 sensor

A bad PTS might be the culprit...
Hope this help

Regards

Dec 27, 2014 | 2007 Kia Rio 1.4

1 Answer

Lost of power


Are you running a cold air intake?? Maybe water is getting into the intake and engine.. make sure theres no way for water to get into the air intake...you know where the filter goes? Check owners manual

Apr 14, 2014 | 1997 Suzuki Baleno

1 Answer

TCS warning light is on. Check engine light is on. Reduced engine power light is on. the accelerator wont work when pressed all the time. when revving it up it will not rev over 3k in neutral.


There are literally thousands of codes that can cause the check engine light to come on. There is no way to guess why yours is on based on your symptoms. Many auto part stores will scan your engine computer and give you a print out of the codes for free, unless you live in CA. We would need to know what these codes are to give you an accurate reason you are having issues. FYI, modern engines won't rev past 3000-3500 rpm in neutral. This is to prevent engine and torque converter damage.

Feb 27, 2011 | 2005 Saturn VUE

1 Answer

My check engine light went on yesterday. Today it was on again and the car started losing power at random times. I'd be in second gear accelerating and the rpms would fall for 30 seconds then pick back...


Since your check engine light is on, you need to take it to Autozone and get a code. They will read it for free and tell you what the computer found. This will give you an idea of where the problem is. Sounds like the engine is low on compression. You might want to check your timing belt or chain. It may be slipping. Also, a simple clogged fuel filter could cause this as well. Since it has 82K miles, if you haven't ever changed the spark plugs or coils, they may need changed. If you decide to do this, go ahead and change the wires and the cap. In all honesty, this could be the reason for your loss of power. If you can, get the code read though. This will save you time and perhaps a lot of money in the end. Once you know what the computer found, you will know where to start at. What I wrote is just posssibilities because many things can cause your car to loose power like you states. Also, it gives you heads up if a mechanic tries to make some money off of you. I hope this helps you and I wish you the best of luck on your car. Take care.

Feb 07, 2011 | 2003 Saab 9-3

1 Answer

**NEW** (End of paragraph) 2005 DODGE STRATUS 2.4L DOHC -X (problem-check engine light on-code:P0016-camshaft/crankshaft sensor) WHAT HAPPENED: TIMING BELT BROKE WHILE DRIVING UNDER 35 MPH. HAD A CHEAP...


Well what i know is when the timing belt breaks the Valves get bent for most of the time like 99% And i don't know if that Mechanic checked the valves or not because if they are bent then the valves wont close properly as it should and the car wont have power and the RPM will be low even if you accelerate. and what i can say is take your car to an autopart store Like Pep boys or autozone, and ask them to scan it and erase the code and see if it back again and they should scan it for free. Good luck

Jan 12, 2011 | Dodge Stratus Cars & Trucks

1 Answer

Acceleration issue


Do you have any engine codes? It may be throttle position senso. It may also be good idea to buy new fuel filter.
Also you may want to get a multi-meter and check your fuel pump relay.
If you have a tester, you should also check fuel pressure.
If you have a check engine light on, you should have the codes read because it will pinpoint exact problem

Jun 03, 2009 | 1997 Subaru Legacy

1 Answer

05 nissan pathfinder lack of power,catalytic low flow bank 2


Have you checked fuel pressure at idle and 3k TO 4K RPMS? I once took a crown vic to a local dealer, wanted $1500 for new cats. I did a fuel pressure test, 15 lbs at idle, 0-5 at 3K RPMS and went to 0 lbs. when punched accelerator. Was a $6 fuel filter.

Apr 29, 2009 | 2005 Nissan Pathfinder

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...