Question about 1991 Honda Prelude

1 Answer

Hose???? ok i recently just had my 2.1 liter motor rebuilt and am down to the final touches but cant place ONEE single there any digram that will show me specifically where all the hoses clap to the parts?

Posted by on

  • Curt Downs May 11, 2010

    If you still need this info, post a few pictures and description of which hose you need to connect. I have 2 1991 Preludes= may be able to figure it out from your photos and info. Countrycurt0



1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Yes if you go to google and type in you want to look at a digram it will pull up some of them i have a 91 lude and it did that for me....also you can by a repair manul for your car that will have digrams in it i think

Posted on Oct 02, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

No Spark

Most likely you have the 3.4 liter. on the coil pack you should have 2 connectors on one side and a connector on the the other. they can be hard to see at times. the single connector on the drivers side will run under the the bracket for the coolant hose. hope this helps

Feb 22, 2013 | 2003 Chevrolet Venture Passanger

1 Answer

Powertrain Control Module 1993 4l60e

you probably got something wet that shouldnt have gotten wet. id park it in the sun with the hood open or take it someplace they have an air hose and hose it all down to dry it faster

Feb 28, 2018 | GMC K1500 Cars & Trucks

1 Answer

I have 90 toyota 2.4 liter pickup. Its loosing coolant and dont know where its going. Has new t stat, new radiator,new fan clutch, new water pump. Oil isnt milkie and does not smoke. Help!

i would do a compresstion test. If you cant see it loseing coolant on the ground it has to be in the motor, if the oil not milkie and you dont see smoke. ok fell the radiator up with water and let it get to warmed up dont drive it let it get warm. after it warms up open the hood look at your hoses be careful the coolent/water will be hot. first look at all the hoses see if any are swollen or cracked becareful give the motor little rpm like 2000 rpm's this will put more presher in the coolent system and you should see a leak if there is one lot of time you cant see if its leaking after you drive it some holes are very small if you cant find it let me know and i will have you try something else. theres 2 things there for you to try

Dec 08, 2011 | 1990 Toyota Pickup

1 Answer


may need to get computer reprogrammed--send dtails to a pro

Sep 22, 2011 | 1994 Toyota Pickup

1 Answer

I have 2004 chevy trailblaser i change sparpugs but motor shaking a lot whats the ploblem and solution cant enybary help

you have crossed two of the wires. 5.3 liter is 1 8 7 2 6 5 4 3.....4.2 liter is 1 5 3 6 2 4 ... If they are not crossed double check the spark plug wires for any breaks of bad plug boots and make sure the wires are not touching the minifold this will cause the spark to jump

Jun 10, 2011 | 2004 Chevrolet TrailBlazer

1 Answer

89 jetta boggin down when runs for a minute or two

Check the fuel pressure with a gauge and see if the pressure is dropping during this bog. This would be the first place to start a diagnosis.

Apr 14, 2010 | 1989 Volkswagen Jetta 2 Door

1 Answer

I have recently rebuilt the single barrel carb on my 84 ford f-150, 4.9 liter in line 6 cyl. i followed the rebuild instructions however then cvarb wants to flood and will only start with it choked. what...

Check the two screws / pins on the side connected to the air / gas flow levers. The screws go into and out of the carb and / or rods itself. Just play with it and hope you didn't leave anything out!

Mar 17, 2010 | 1984 Ford F 150

2 Answers

Theres coolant leaking from somewhere i cant see i know its not from the radiator or or hose unless there's another hose i cant see. the leak is located under the motor mount running down the tranny on...

really this could be one of several issues, does the vehicle run Hot, are you having to fill the reservoir with water or coolant, there is a hose that runs from the cap (overflow hose) to the reservoir, in addition to the upper and lower hoses, finally the water pump. the water pump is equipped with weep holes, which allow fluid to weep out when the pump is bad. finally the thermostat, hopefully one of these can solve your issue, good luck!

Sep 18, 2009 | 1995 Honda Accord

1 Answer

I need a digram for where this evoperater hose is located

There is no "diagram" The drain hose is at the lower part of the right side firewall. Shine a light down along the firewall between it and the rear of the engine and you should see a "L" shaped 2" hose sticking out.

Jun 18, 2009 | 1991 Pontiac Bonneville

Not finding what you are looking for?
1991 Honda Prelude Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides