Question about Honda Civic

1 Answer

On the Aircon, when switch is set to 1 or 2 no aircon but when switch is set to 3 and 4 aircon is felt. Thanks.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Honda Master
  • 450 Answers

Blower fan resistor block, for fan speed operation is blown on 1 & 2
needs replacing usually located near fan itself

Posted on Jan 03, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Astra aircon switch


1.remove the audio system.
2.remove cig lighter
3.remove lower compartment door and assembly under radio.
4.remove compartment under radio
5.then remove all necessary screws that hold the plastic panel on.
6.once all screws are removed and you can either lift the panel up enough or remove it total depending on you.then you will have easy access to the switchers..

Jan 04, 2014 | Holden Astra Cars & Trucks

1 Answer

2010 Vauxhall Astra H (1.4 sxi) Air con previously not working. Had car re-gassed, still no joy. In Opcom Aircon was set to not activated. Changed this to "with clutch setting" an Aircon working now:-) ...


air cont flow sensor may have failed cannot remember on 1.4 model but on 2.0 model its on the left side of the engine. it could be this. a/c dont usually have codes to store. accelerator code is the sensor on the intake on the side. prob just needs cleaning mark were it fits with a pen and take off. on op side there is a hole spray some wd40 in the hole cover it and shack it around . then tip out and leave to dry. then put back on. should be fine then.

Aug 04, 2013 | Vauxhall Cars & Trucks

1 Answer

Fault code P2106


is it the ecotec engine fitted 1.8 or 2.0./2.2l or the diesel 1.7 engine.. how long have you not used the air con for. not using it for a long time you can damage the pump the flown sensor. even the temperature sensor. but if the engine is trying to stall with the ac on then the pump may have a fault. ac should be run for 10min once a week no matter the weather. stops you having problems later.

Aug 04, 2013 | 2003 Vauxhall Vectra

1 Answer

1994 mitsubishi lancer aircon problem..is it possible to change the mitsubishi aircon motor to nissans aircon motor?


best talk to an a/con technican as there is a size/capacity requirement for compressors. While it may be feasable to fit another compressor it needs matching tx valve condensor and evaporator to work properly. He should be able to tell you if it will work or not

Jan 27, 2013 | Cars & Trucks

1 Answer

My 1996 nissan lec engine shuts down when the aircon is turned on, i already tried adjusting the idle. the aircon functions at high rpm. can you suggest a solution.


Hi,
Check the a/c actuator, round metal with rod at the bottom, vacuum hose at the side. Located beside the carburetor.
When you turn on the A/C it will push the idle up( via vacuum system ). It has an adjuster at the top to set the right rpm of your engine.
Test also the vacuum hoses and A/C vacuum switch, just follow that black 1/4" dia. hose( vacuum hose ) and check the system.
If you have no idea on repairing the vacuums and the actuator, my suggestion would be to bring your car to the nearest A/C technician to have him repair it.
Thanks for asking FixYa!

Aug 09, 2011 | 1996 Nissan Sentra

1 Answer

Car jerks when I stop only when I have air conditioner on


When the aircon is switch on it puts a substantial load to the engine: you need to get your car tuned to take into account the load from the aircon. Most car have a mechanism that increases the idle speed when the aircon is active: if you are unable to get your car tuned yet, try making the engine idle speed slighty faster while you have the aircon turn-on (the ajustment screw should be close to the accelator cable connection at your engine end). Don't make the idle speed too high and check by turning the aircon off and on to assess the best compromise idle speed to stop your car from almost stalling (e.g. jerking).

Good luck!

Jul 05, 2010 | 2000 Hyundai Elantra

1 Answer

Heater warms up in morning but over the day only gives cold air despite being set at 22degrees. VW dealership says when set at 22degrees it will warm up to 30degrees and then introduce cold air to bring...


vw fit 3 types of aircon,
1.full climate control (you set temp is stays there)
2.climatronic (as your dealer said.....)
3.aircon std (cold draft)
you cannot change whats fitted to another type.

Apr 08, 2010 | 2004 Volkswagen Eurovan

1 Answer

Aircon is not working properly if i speed up up 100kph.


The evaporator is freezing up. Check to make sure it's not low on freon.

Feb 27, 2009 | 1990 Mitsubishi Galant

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

193 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...