Cars & Trucks Logo

Related Topics:

Posted on Jan 03, 2011
Be the first to answer

Light with car & spanner on it flashes when ignition turns on then get nothing as i try to start, happens a few times then starts but orange engine light stays on, drives fine????? 2007 rodeo v6 petrol

Answer This Question

5 Related Answers

Anonymous

  • 79 Answers
  • Posted on Jul 21, 2008

SOURCE: D4 flash and won't start

Go to this site and scroll down to "cmrvi1" ( the persons forum name ) http://www.honda-tech.com/zerothread?id=962851&uid=999378256&dir=1&postid=11122854. Very helpful indeed.

Ad

Anonymous

  • 6 Answers
  • Posted on Mar 14, 2009

SOURCE: Toyota Prado V6 4.0L Petrol 2006 will not start

your starter gets its earth when bolted to engine it sounds like you have a short circuit if its clicking it could be the solenoid or the earth strap touching the positive terminal check this first if it does not work we'll go from there.

Anonymous

  • 1 Answer
  • Posted on Mar 24, 2009

SOURCE: dash light orange box with with virtical zig zag line in it

I own 2004 Laguna, advised it required a new Throttle Body this was fitted but - still lighting up two Fault lights every so often as previous to this New Part
Have to stop turn off Engine wait and restart.
Warning Lights: 1. Automatic Gearbox, 2. Preheating
Has this been the correct repair. AC

Anonymous

  • 84 Answers
  • Posted on May 16, 2009

SOURCE: 2004 V6 3.5 Rodeo

"when the fuel pump kicks....it makes a very short duration sound....you can hear it....but in seconds it will be gone......as gasoline has made its way to the engine.........

if you cant hear any noise from the fuel pump......it could be that the fuel pump realy is bad........if you happen to change the relay....and it still does not work.....then it is the fuel pump. that is fried.......

about the water.....i am not shure......unless there was water in the gasoline itself....or somebody put water in there in purpose....

hope this helps...

Anonymous

  • 1 Answer
  • Posted on Dec 30, 2009

SOURCE: locate ignition module on 1999 rodeo,3.2L V6 with coils on plug

changed timing belt on my 2000 rodeo.since then cylinders 2,3 and 5 on right side of engine will not fire.I HAVE CHECKED THE COILS AND AM GETTING SPARK.ALSO DID A COMPRESSION TEST AND AM GETTING ABOUT 150PSI FROM EACH CYLINDER.RECHECKED TIMING MARKS SEVERAL TIMES.A MECHANIC I KNOW TOLD ME THAT IT MIGHT BE THE IGNITION MODULE IS BAD.DO NOT WANT TO BUY ANEW MODULE AND FIND OUT THAT'S NOT THE PROBLEM.APPRECIATE ANY INPUT.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
3answers

Corsa utility 1.4 failing to start and it is not giving a spark. it flashes the spanner light about 5 second after turning the key on please tell me what is the problem
Hello Sibusiso,

(From the 2009 Corsa Owners Manual)

Your Immobilizer system checks whether the engine is allowed to start with the key being used. If the transponder in the key is recognised, the engine can be started.

The electronic immobiliser activates itself automatically after the key has been removed from the ignition switch. If control indicator "spanner light" flashes when the ignition is on, there is a fault in the system; the engine cannot be started.

Switch off the ignition and then repeat the start attempt.
If the control indicator continues flashing, attempt to start the engine using the spare key and seek the assistance of a workshop.

See 2009 Owners Manual at the link below.


https://www.vauxhall.co.uk/content/dam/Vauxhall/Europe/united_kingdom/nscwebsite/uk/00_Home/Owner_Services/owners_manuals/corsa/CorsaOwnersManual_Jan09.pdf
Read full answer
Jul 23, 2016 • 2006 Opel Corsa Utility
0helpful
1answer

When I turn the key nothing happens. No clicks, no crank. All of the lights work properly. No dimming or turning off when I try to start. This has happened a few times before. The first time I put the car...
Ignition switch....the electrical ignition switch. To verify, find the thick white wire in the harness coming from the switch and do two things; first, check for power at this wire, when you switch the key position to start. If nothing, power the wire momentarily with the key in the run position, and your car should start.
Read full answer
Sep 11, 2013 • 2003 Hyundai Accent
0helpful
1answer

My 2002 chevy impala wont start. When i try to crank it all the lights shut off & nothing works but the check engine light flashes. After messing with the positive post on the battery the lights come...
dirty battery terminals
they are most likely a black color inside and on the posts where they should be a shiny clean
use a wire brush or file to remobe the lead sulphate that is preventing good contact and then make sure that the terminals are tight
Read full answer
May 21, 2017 • Cars & Trucks
1helpful
1answer

2000 Olds intrigue: When i turn the key nothing happened. All the lights came on (like they would if it normally started). There was no clicking noise - nothing. I tried shifting the car from park...
if an ignition switch fails, sometimes you can jiggle the key and it will start right up. its very hard to tell. but if you can start it by bypassing the ignition switch, then its the switch itself. go to this site for more detailed info--- aa1car.com/library/1999/cm119948.htm---this page should help. click on top link.
Read full answer
Dec 22, 2010 • 2000 Oldsmobile Intrigue
0helpful
1answer

Wouldn't start. Turned ignition switch. Nothing happened. Interior lights & headlights worked.tried 2 hours later & car started.
Does your security light flash if you turn your key to the 'on' position? If so, this is a Passlock problem. It should restart after 10 minutes. Here`s a possible solution that has worked for me. Have a new key cut from origional key or best condition key you have. Buy some Electronic cleaner and spray lots into the lock cylinder. Then, put your key in the ignition and turn from off to on position several times (5 to 10 times quickly). Then remove your key and spray again and repeat key turning. Do this several times. I don`t recomend any spray that is oil based. I no longer have issues with my Passlock system and I have almost 500 000Kms on my Impala.
Read full answer
Jul 03, 2010 • 2002 Chevrolet Impala
0helpful
1answer

Car will not start. Have replaced battery in remote start. Replaced ign box behind the key cylinder. Security light flashes and car dies. Happened one time before and it just started working after a...
have u tried,,turning ignition on for 15 minuets & then turn off,,,then turn back on to start,,,
Read full answer
Feb 21, 2010 • 2001 Pontiac Grand Am SE
0helpful
1answer

2001 lumina turns on-- but doesn't turn over
When that happens again, try moving shifter harder into park, or in to neutral and also try stepping harder on brake pedal & see if it makes any difference.
Read full answer
Jul 26, 2009 • 2001 Chevrolet Impala
2helpful
1answer

Had 1st oil change on 08 4Runner @ 4980 miles. "Maint" light came on at 5000 miles indicating oil needs changed. How do I turn it off?
If you have your owners manual, should be a section in there on resetting the light. You may also want to try this method... With the ignition off press and hold the button for the trip meter reset, while still holding this, turn the ignition to the on position (don't start vehicle), you should see either the maint light start flashing (if this is what happens then it should go off after flashing a few times, then you can release button and start vehicle) or there should be a few lines where the mileage shows up, these lines will flash and start to countdown and disappear, then it should show "oil life 100%". Hope this helps
Read full answer
Jul 17, 2009 • 2003 GMC Envoy
0helpful
1answer

Engine does not start?
Make sure that the connections at the battery is clean and free of acid built up. Take the terminals of and clean them propperly

It could also be the ignition switch at the wiring end not making proper contact anymore, try and wiggle the ignition wiring if possible and see if there is any change in the status when the ignition is switch on
Read full answer
Oct 26, 2008 • 1988 Nissan Pulsar
0helpful
1answer

D4 flash and won't start
Go to this site and scroll down to "cmrvi1" ( the persons forum name ) http://www.honda-tech.com/zerothread?id=962851&uid=999378256&dir=1&postid=11122854. Very helpful indeed.
Read full answer
Jul 16, 2008 • 1994 Honda Accord
Not finding what you are looking for?

View Most Popular

Cars & Trucks

Related Question

Corsa utility 1.4 failing to start and it is not giving a spark. it flashes the spanner light about 5 second after turning the key on please tell me what is the problem

  • 2006 Opel Corsa Utility

85 views

Ask a Question

Usually answered in minutes!

Popular Questions

Fast Idle Problem With 99 Isuzu Rodeo V6

1999 Isuzu Rodeo

My 2002 isuzu rodeo transmission is slipping

2002 Isuzu Rodeo

It's a holden rodeo turbo/diesel 2005.check 4wd light on

2004 Isuzu Rodeo

Key stuck in ignition

2000 Isuzu Rodeo

2000 isuzu rodeo V6 3.2l thermostat replacement

2000 Isuzu Rodeo

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Isuzu Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

JPG Manual
1s(2).jpg. user-manual-1999 Rodeo...

1999 Isuzu Rodeo

PDF Manual
06_TF6VE-WE-0431.pdf. user-manual-2004...

2004 Isuzu Rodeo

PDF Manual
00_TFGEN-WE-0431.pdf. user-manual-2004...

2004 Isuzu Rodeo

Loading...