Question about Chrysler Town & Country

1 Answer

My power steering pump return line hose keeps busting.why?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

Are you replacing it with fuel line or oil cooler hose?

Posted on Jan 03, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Return hose on power steering keeps busting when i start car just put 1 on started an it blew


There is sometimes a filter built into the reservoir which may be clogged. A clog in the system would create abnormally high pressure in the hose upstream of the clog. any lines after the steering rack are not meant to handle high pressure.

Jan 16, 2018 | Cars & Trucks

2 Answers

How to bleed power steering pump for 2000 ford f350


Usually bleeding power steering pumps IA case of filling up the resiviuor and starting the engine and spinning the steering wheel left and right fully a couple of times topping up in between, that's it, I think you can easily find out by trying
Wish you luck, should be fine after that unless you got leak in the hoses

Vicv

Oct 08, 2017 | Ford Cars & Trucks

2 Answers

98 Ford power steering keeks bursting the high pressure hose.


it sounds like it is pumping too much pressure, you need to take the vehicle to a power steering specialist & have the pressure adjusted otherwise you will just keep bursting hoses or the seals on the steering rack......hope this helps.....cheers.

Jun 28, 2011 | 1998 Ford Windstar

1 Answer

On a 99 Olds Alero, in the return lines of the power steering hoses, which place does the high pressure hose attach to?


RETURN TURN LINE GOES TO THE LEFT OF RACK PINION AND HIGH PRESSURE HOSE GOES TO THE RIGHT OF RACK PINION.LOOKING AT POWER STEERING PUMP HIGH PRESSURE HOSE THICK HOSE SCREWS INTO POWER STEERING PUMP.WHILE LOW PRESSURE HOSE HAS A HOSE WITH A CLAMP THE LOW PRESSURE HOSE HOOKS TO TOP OF POWER STEERING PUMP.LOW PRESSURE DONT SCREW INTO POWER STEERING PUMP IT IS HELD IN PLACE BY A HOSE SMALL CLAMP.

Jun 24, 2011 | 1999 Oldsmobile Alero

2 Answers

The line that goes from my rack and pinion to my power steering box busted. what is the name of that ghose so i can go get one


There are 2 lines that service the rack and pinion. One is the high pressure line from the output side of the power steering pump, and the other is the low pressure return line to the power steering pump.

Just determine if it's the output or return line and go to your local auto parts store.

It might not be a bad idea to also pick up a vehicle specific repair manual for precise instructions on how to bleed the lines, etc.

Shouldn't be any problem at all....just a little messy from spilled fluid.

Good luck!

Jan 30, 2011 | Ford F-150 Cars & Trucks

1 Answer

Power steering pump return line hose keeps busting. why?


Was it replaced with the proper type of hose? If your using a generic hose it may not be able to handle the pressure of the pump and it could cause it to burst.

Jan 03, 2011 | 2001 Chrysler Town & Country

2 Answers

The power steering resoivoir drains out after 1-2 hours


Hi:

Check to see if you have a Power Steering hose leak ,Open Hood and Have someone inside turing Steering wheel back and Forth slow.While you have a Light and Locate your Leak.

Power Steering System is a Sealed System, Sounds like you have a Hole in 1-of your Power Steering Fluid Lines(Pressure) More that likely. or Return line.

If its leaking at the Pump where your hoses go in it might just be a Rubber Seal. But the most common problem is a Hose is Busted Open.

Please Let me Know by Voting For me on the Quality of my Solution,

Thanks for Using FixYa From: D_HUBBS

Oct 08, 2010 | 1990 Ford Taurus

1 Answer

No power steering new installation


disconnect the return line at pump put it in a jug start the engine check for cirrulation and too bleed air keep filling pump if you have no cirrulation the reconnect the return hose and discnect the supply too see if it pumping if it is then you have a blockageif not then you may have a bad pump

Mar 04, 2009 | 1993 GMC Sierra K1500

1 Answer

High pressure power steering hose - one or two?


Here is a pic.

[IMG]http://i253.photobucket.com/albums/hh43/chuck943/DG1690A.gif[/IMG]



1 3A674 Power Steering Pump 2 3A714 Power Steering Pressure Hose 3 3C510 Power Steering Hose Bracket 4 3N824 Power Steering Pressure Switch 5 3504 Steering Gear 6 3A713 Power Steering Return Hose (Gear to Cooler) 7 3D746 Power Steering Fluid Cooler 8 3493 Power Steering Return Hose (Cooler to Pump

Feb 23, 2009 | 1999 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...