Question about Chevrolet Silverado 2500HD

2 Answers

Have a 2002 Chevy Silverado. Pass. side headlight works, drivers side is very dim on both high and low beam.

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 318 Answers

Check to see if your bulb is loose in the socket - do not touch it with your fingers - use a clean rag. Sounds like it is not grounding properly. Let me know. Thanks

Posted on Jan 03, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

Find out where that headlight ground wire is bolted to the body. it may be loose or corroded. should be easy to find at the lf area under the hood.

Posted on Jan 03, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Driver side headlight goes dim on high beam while passenger side is bright


bad connection or bad earth check all connection or bulb

Jan 24, 2016 | Cars & Trucks

1 Answer

Driver side low and high beam on but dim. Passenger side low beam normal but high beam on and dim


I would check for the groundwire continuity

Driver side - dim low beams and no hi beam - Subaru Outback ...

www.subaruoutback.org > ... > General > Electrical & Electronics
Oct 11, 2014 - Hi everyone, My drivers side headlights are dim on low, (car has separate bulbs ... When the headlight switch is turned ON, but for low beams, ...

Driver-side Low beam Not Working (electrical issue not bulb ...

www.hummer4x4offroad.com/.../showthread.php?...Driver-side-Low-be...

Mar 12, 2015 - 10 posts - ‎4 authors
The high beam continues to work on both sides...I pulled the Driverside headlamp fuse and then both left and right beams lit up but very dim.

High beams ok, but not low beam - one side only - TDIClub Forums

forums.tdiclub.com > ... > VW MKIV-A4 TDIs (VE and PD)
Jan 23, 2014 - My driver's side lights are working fine - high and low beams. ... But it definitely looks like the big lamp on the driver's side gets brighter when ..... Drivers side headlight is very dim on low beam and goes out when on high beam ...

Dim driver's side headlight (low & high beam) - GrandAmGT.com Forum

www.grandamgt.com > ... > Technical Q&A

Dec 11, 2002 - 6 posts - ‎4 authors

Jan 04, 2016 | Cars & Trucks

1 Answer

99 olds bravada, DRL's inop, low beams inop, high beam normal on pass side, dim on drivers.


top middle connection is the earth on the bulb and this is faulty ,what end i couldnt tell you but its no doubt the chassis side so run another cvable to teh neg on the battery and if it brightens up then you know its a earth problem

Oct 14, 2012 | Oldsmobile Cars & Trucks

1 Answer

2000 silverado pass headlight working fine driver side dead low and high beam


Maybe i am not understanding you but have you replaced the bulb ? My drivers side went out and i replaced the bulb and everything was good.

Jul 27, 2012 | 2000 Chevrolet Silverado 1500

1 Answer

I have a 2005 chevy Impala SS and my high and low beams go on at the same time and three of them are dim.


Hello! The "Flash to pass" switch in the Headlight dimmer switch is the most probable cause...When it is activated it turns off the low beams...The dimness can be attributed to a resistive ground in that circuit...but one thing at a time...The turn signal multifunction switch contains the flash to pass switch...Therefore you would replace the multifunction switch...See picture below...Guru...saailer
6_9_2012_6_12_22_pm.jpg

OE PRO Part # SM260A ...Cost $150

Jun 09, 2012 | 2002 Chevrolet Impala

1 Answer

Have headlight problem 2002 chevy malibu v-6 on the dim side have electria current on both wires to the blub bright beams function normal


if you have power to both headlight plugs for each low and high beam filaments and the ground is good as you say the high beams function normally then you either have bad low beam bulb filaments,poor or dirty connection or you have a daytime running headlight relay on the car and that is the problem with the low beam lights.yes the high beams will work but not low beams if it is the relay.

Mar 04, 2011 | 2002 Chevrolet Malibu

1 Answer

Hi, I have a 2002 Buick Rendezvous and the high beam light will not come on on the Passenger's side headlight. The low beam works great and the high and low beams work great on the driver's side. We have...


Make sure the high beam realay under the hood fuse box is working. You can swap the hi beam relay with the horn relay to test. The hi beam filiament in the bulb can be open too.

Mar 24, 2017 | 2002 Buick Rendezvous

1 Answer

I have a 2008 f250. one headlight (driverside) low beam is not working. I have checked both fuses 10amp and they are good. The flash to pass works and both lights on bright, right and left come on. the...


I am sure that a 12 Volt bulb means it needs 12 Volts. Since you changed the bulb to the other side, why not check the voltage in the working side and see what it reads?

Sometimes the turnstalk can interfere with the lighting. Try pushing the Hazard switch several times and see if the headlights straighten out. I read that too much goes through the turnstalk and that using the Hazards can derail a contact inside the stalk.

If this does not help, you may need a headlight relay in the powerbox. One contact may be dirty or burned down for the wire it feeds. Unless you have a single wire feeding both low beams to the headlights, I would bet the left and right side come out directly through the relay.

Oct 20, 2010 | Ford F-250 Cars & Trucks

2 Answers

1993 Chevy Silverado truck headlights high beam only works no low


dimmer switch has gone bad need to change your dimmerswitch

Apr 01, 2009 | 1993 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

348 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...