Question about 2005 Chrysler Town & Country
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
First of all check the fuses.The fuse box under the dash on the driver's side of the Caravan. If fuses checked out ok then,Start by checking under the dash. Make sure the wiring harness to the cluster is tight and connected. If that is good, you may have a bad cluster. To confirm this power will need to be checked to the cluster.If the instrument cluster has power and all wires are checked proper then other possibility is fault in BCM or BCM module shorted.The Body Control Module (BCM) controls all the systems that are not functioning, or functioning improperly.
And for turn signal lights and 4 way emergency flasher light not working,check the turn signal switch and flasher unit. When a blinker flasher fails it can cause blinker lights to say on, not blink, or not go on at all. To test the blinker system flasher, remove the flasher unit and insert a jumper wire between the two terminals. If blinker stays on in both directions without blinking, replace the flasher.If both test results are positive the turn signal switch has probably failed and replacement is required.The flasher controls both turn and emergency lights. The emergency switch reroutes the wiring to run all lights through the flasher circuit.The turn signal hazard flasher relay in the upper right corner of the fuse box. It should be easy to spot as it is the biggest of the relays in the box. The turn signal switch located art the bottom of the steering wheel.Its fitted by three screws. --------------- This troubleshooting procedure will help you to confirm the fault.Thanks.Helpmech.
Posted on Jan 02, 2011
Look for a bad ground...if you have a shop manual or sometimes the dealership will print you off that page, look for the major ground going to those devices.
Posted on Oct 27, 2011
Tips for a great answer:
Jan 17, 2015 | 1998 Dodge Grand Caravan
Aug 17, 2011 | 2000 Dodge Grand Caravan
May 05, 2011 | 2005 Dodge Caravan
Apr 06, 2011 | 1996 Dodge Caravan
Mar 27, 2010 | 1999 Dodge Caravan
Mar 10, 2010 | 1999 Dodge Caravan
Nov 24, 2009 | 2006 Dodge Grand Caravan
Jun 11, 2009 | 1999 Dodge Caravan
99 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: