Question about Ford Explorer

1 Answer

Start driving will not shift till i reach a higher rpm then i have to back off the throttle till it drops into gear the i have to ease the throttle up for the next gear change.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,400 Answers

Sounds like trans filter is starting clog up. Sometimes cold, fluid needs to warm up and expand. Depending on last time you did it, trans fluid & filter change is in order.

Posted on Jan 02, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 mazda b 2300 (105,000 miles) "bucks" when i shift up (usually at about 2000 rpm or less)


The engine may misfire and/or buck while driving at freeway speeds with no fault code stored in the powertrain control module (PCM). This can be caused by an intermittent fault with the camshaft synchronizer assembly. This condition can be diagnosed by monitoring knock sensor data as per Ford service bulletin #05-22-12. Replacement of the synchronizer assembly will be required to correct this concern.
https://repairpal.com/engine-buckmisfire-at-freeway-speeds-934

I hope this helps

Oct 28, 2017 | Mazda B2300 Cars & Trucks

1 Answer

My 2008 Toyota Prius has begun occassionally surging while going uphill in cruise control. It revs to full throttle then no throttle then back to full throttle then no throttle again. I had a Toyota dealer...


the cruise control limits have been exceeded
the rad speed drops going up hill, the transmission shifts , that exceeds the rpm so it drops back the gear s shift again and the cycle is repeated
nothing really wrong , just incorrect driving practice
good practice is to turn of the cruise control when going up hills that puts the control outside parameters for the operation

Nov 09, 2017 | 2008 Toyota Prius

1 Answer

Toyota Belta (Yaris Sedan) 2007 RPM Variation


Do the throttle body cleaning and idle speed re-learning procedure.

Dec 18, 2012 | 2007 Toyota Yaris 1.3

1 Answer

Clutch pedal to floor on mini cooper


havent worked on one of these as yet so i dont know if its a cable or hydraulic ,either way you will have take it to a garage,put car in gear first and then start engine and the car will move as you start it in gear ,its easy to drive with no clutch just change the gears from getting the RPM right ,ease up on the throttle with one finger behind the stick and it come out of gear then rev angine a bit and as the engine RPM and road speed is correct it will go into gear smoothly .How do think you drove a decent truck like a seddon atkinson with no syncromesh on any gear ,showing my age here

Apr 13, 2012 | 2002 Mini Cooper

1 Answer

High RPM shifting?


seems as if the trans isnt shifting as it should and needs to be checked (could be the shift solenoid not working properly or gears are sticking)

Mar 14, 2017 | 2003 Hyundai Tiburon

1 Answer

Sticky high acceleration 1995 LE V6 camry I have a 1995 LE V6 camry with the 3.0 litre engine. Car starts and idles normally but after driving any distance idle rpm sticks up between 2000-3000 when you...


The spring that returns the throttle is getting weak. Best thing to do is clean the throttle inside and out. Clean the throttle plate front and back and as for as you reach inside, use an old tooth brush and brake clean. Once clean lube the spring area. This should help. But if it still sticks , I would be looking at the throttle cable.

Aug 14, 2011 | 1995 Toyota Camry

1 Answer

RPM is over 400 rpm higher than it should be with no gas pedal.


Could be several things.. I would suggest replace the neutral safety switch, all O2 sensors and fuel and air filters, PVC valve and if needed plugs n wires..
The issue could also be a bad throttle body.. Should be a good idea to get it hooked up to a diagnostic machine - get the codes and then you will know more of what you are dealing with..

Have a great day !!

Apr 09, 2010 | 2000 Saturn SL

1 Answer

I have a 1999 jeep cherokee that has intermitant transmission problems 1)shifting up it wind out to 2k-3k before shifting 2) at higher speed it feels as if it slips out of overdrive rpm increase but speed...


It will shift out of overdrive upon increasing throttle , pulling hills and so on. Your overdrive probably kicks in around 35 to 45mph and kicks back out as you increase throttle. Electrically controled speed sensor to control the response. Overwise the engine would bog down to a stall. Over drive is just that. It changes the gearing ratio to over drive meaning less then final gear 4 to 1 down to 4 to 3 etc more direct drive ratio to lessen consumtion of fuel with less stress on engine. Have shift speed sensor adjusted. Don't drive in overdrive in city if most driving is under 45mph

Mar 09, 2010 | 1999 Jeep Cherokee

2 Answers

WHEN YOU PUT THE CAR IN DRIVE IT WILL NOT GO ANYWHERE


Its the electronic shift control located just under the battery ontop the transmission replace or repair will solve the issue

it'll go into drive but once it reaches 1500 rpm it'll drop into neutral as a safety because at this rpm it is being told to shift gear and when it fails to do so it safely goes into neutral

it will go into reverse just fine and park and you can run all the low drive gears until you reach 1500 rpm then it'll cut it off

i pulled mine out re soldered bad components on the board to fix it but im an electronics engineer it may be easier for you to just replace it

Aug 09, 2009 | 1995 Dodge Avenger

1 Answer

Honda CR-V - 2004 - High RPM not returning to Idol RPM ????


i'am no expert on this car, but i would chk. the T.P.S. (throutle positioning sensor) there also may be carbon build up on throutle butterfly, not letting it close completely when you take your foot off the pedel.

Jan 14, 2009 | 2001 Honda CR-V

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...