Question about 1998 Chevrolet S-10 Pickup

2 Answers

It gets gas through the lines but wont turn over, put gas in carb. and it starts but wont run very long

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 144 Answers

Hi, Have you check fuel pressure,just because you have fuel coming in the lines dont mean you have enough fuel pressure for it to start the injectors have to have the right pressure before the will work. The pressure should be some were between for a 2.2 liter should be 55 - 62 psi. / for 4.3 liter should be 55 - 62 psi . If i can help anymore just re post ,also check make sure you have no blowen fuses. Thanks dodge tec

Posted on Jan 02, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,428 Answers

Have you replaced the fuel filter resently its under the drivers side door mounted to the frame this may solve your problem and its a good place to start but this may vary well be a problem with your fuel pump its around the time when you would start to have problems with it 10 to 12 years with these pumps is about it for them depending on your usage and milage good luck.

Posted on Jan 02, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Stillstill wonrFuel pump went out,wont start n run


disconnect the fuel line at the carb an put a hose on it an turn it over an see if fuel come out the line 1st.

Oct 12, 2014 | Cars & Trucks

3 Answers

My gmc sierra SLT 350 isnt getting fuel to the engine.


if your carb is a tbi (throttle body injector) then the carb is clogged

Feb 25, 2014 | Cars & Trucks

1 Answer

Ran snowmobile out of gas now wont start


try a couple of shots of Ether to get the Air out of the Line between CARB and Tank, seen it a few times also it will clean out the Jet in the Carb , put some Injector Cleaner in the tank to get rid of Varnish IN the Carb should take a few tries but within Half hour should run like New

Dec 17, 2013 | Cars & Trucks

1 Answer

My 1984 F-250 wont start


possible float sticking in carb or fuel pump not working. can you see gas spray in carb when manually operating throttle? Does it backfire when running? if so it may have jumped time,

Mar 08, 2013 | 1986 Ford F 250

1 Answer

Engine stalled out,would not start, pour gas in carb,cranks,keeps running,until idle falls below 12to1500rpm,than stalls out again and will not crank,repeat gas or starting fluid in carb,cranks runs and...


This truck is fuel injected, the problem sounds like a weak fuelpump, it runs when you pour gas into it until that gas runs out, the first thing is to test the fuel preasure, if the pump is weak it may run with gas poured into it but wont idle, also a common problem is the coolant temp sensor and the ground wires to thermostat housing bolt but i wont bet its the pump inside the fuel tank, if you put a fuel gauge on it there should be at least 55-61 psi if its a few pounds lower it can cause problems, you have everything else and it runs with gas poured so its a fuel problem check the preasure, theres a valve up top on the fuel line to connect a fuel gauge to it, start there hope this is helpful.

Dec 27, 2010 | 1993 Chevrolet C1500

2 Answers

1987 jeep wrangle will not start or run


Uncouple the fuel line coming from the pump at the carburetor, place a clean can under the line, and have someone operate the starter--you should have fuel shoot from the line in spurts as the engine turns. If it does, then the entry port on the carburetor is plugged. Remove the float assembly and pull out the float needle valve. Hook the fuel line back to the carburetor and try the starter again, there should be fuel pumping into the float bowl. If not, check to see if there is a filter on the fuel inlet path that may be plugged. If no filter, remove the float needle seat to see if something is blocking the fuel passage. If all else fails, use compressed air to blow backwards through the needle seat (remove the fuel line again). Hope some of this helps!

Feb 20, 2010 | 1987 Jeep Wrangler

1 Answer

Why wont my 96 chevy cheyenne 5.7 run unless i put


Probally needs fuel pump. Pump is in the tank. remove gas cap listen when you first turn on key it will run for a few seconds.

Sep 25, 2009 | 1996 Chevrolet Crew Cab

1 Answer

Car wont start, turns over fine but theres no feed of gas to carb


take your distributor cap off and check the ignition module for loose wires or even a ground strap thats connected to the engine to the body , you can take the module to autozone and have it checked for free, it might have a crank position sensor thats going wacky

Aug 19, 2009 | 1987 Chevrolet Blazer

2 Answers

89 jeep yj wont keep running


sounds like you need to rebuild your carb. I just had mine done for my jeep the hardest part was finding someone to do it. ps mine only cost 50 bucks so dont get ripped off. good luck and hope this helps.

Apr 19, 2009 | 1990 Jeep Wagoneer Limited

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...