SOURCE: spark plug change in a 1998 dodge intrepid
if you don t see any spark plug wires then your motor has coil packs(black colored boxwith 2 small electrical wires) located on top of motor 3 on one side,3 on the other.disconnect negative terminal on battery,then disconnect wire connector at each coil pack and remove 2 screws that hold down coil pack, pull gently straight up and plug is right there below coil pack
SOURCE: changing spark plugs 2004 dodge intrepid
First off, on this model you don't have plug wires, you have coil packs with a boot and coil connected to the pack. The boot slides on the tops of the spark plug. The good thing about this is that you don't have to mark each wire to its location.
So to replace the plugs you need to disconnect the electrical connector to the coil pack and then unbolt the two bolts that mount the pack down, then remove the pack.
Next with a ratchet, an extension and a special spark plug socket, which has an insulator inside to protect the porcelain from getting cracked, remove the spark plugs.
Next step is to replace the plug, usually I slide off the boot from the coil pack and then remove the coil from inside the boot and slide the boot over the spark plug and start to thread the plug back in. Using this method allows to you feel if you are threading the plug in right. Then with a torque wrench you would torque the spark plug to the specs for the type of engine you have.
3.2/3.5L Engine (20 ft-lbs)
2.7L Engine (13 ft-lbs)
Next reinstall the coil pack with the two mounting bolts, it is only necessary to hand tigthen the two bolts. Then plug back in the electrical connector and continue this process on the next 5 spark plugs.
SOURCE: replace spark plugs 2004 dodge intrepid
__________________
Changing Spark Plugs
First off, on this model you don't have plug wires, you have coil packs with a boot and coil connected to the pack. The boot slides on the tops of the spark plug. The good thing about this is that you don't have to mark each wire to its location.
So to replace the plugs you need to disconnect the electrical connector to the coil pack and then unbolt the two bolts that mount the pack down, then remove the pack.
Next with a ratchet, an extension and a special spark plug socket, which has an insulator inside to protect the porcelain from getting cracked, remove the spark plugs.
Next step is to replace the plug, usually I slide off the boot from the coil pack and then remove the coil from inside the boot and slide the boot over the spark plug and start to thread the plug back in. Using this method allows to you feel if you are threading the plug in right. Then with a torque wrench you would torque the spark plug to the specs for the type of engine you have.
3.2/3.5L Engine (20 ft-lbs)
2.7L Engine (13 ft-lbs)
Next reinstall the coil pack with the two mounting bolts, it is only necessary to hand tigthen the two bolts. Then plug back in the electrical connector and continue this process on the next 5 spark plugs.
__________________
Changing Dome Light
To remove the map light bulbs you need to first remove the overhead console.
To do this you need to remove the screw at the front of the overhead console (which is more towards the front windshield).
Next you need to pry down on the rear of the overhead console and then disconnect the electrical connectors.
Then, with the overhead console pulled down, pull of the map light bulbholders and replace the bulbs.
Installation is the reverse of the removal process.
SOURCE: 2000 Dodge Intrepid Wont Start
first of all, check your code to see what the car computer shows. To do that , insert the key in the ignition and switch it on three time within 2 seconds and the third time live the key in the on position. All the instrument panel lights will lite and the oddometer will display the fault code that may br the cause for your car not starting. goood luck.
191 views
Usually answered in minutes!
×