Question about Chevrolet Silverado 2500HD

Open Question

I have a 2002 Chevy silverado 2500HD. When I shift out of park the little selector on the dash just disappears and it clunks going into drive and it also is not going into first gear it is like it is starting in 2nd gear. Is there a sensor of something that i can change

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
MrScary66613
  • 1990 Answers

SOURCE: 2002 Chevy Silverado clunking noice when shift from 2wd to 4hi

It is somewhat Normal Depending on how Loud the Clunking is. This is a Common Complaint on the Chevy 4x4's. I have verified this through the Dealerships here in Oklahoma and they all say the Same thing But, I am with you, They should go into 4x4 without that Clunk for as much as we pay for them.

Posted on Jan 26, 2009

Ad
  • 217 Answers

SOURCE: 03 silverado neutral safety switch

possible but it can also be a range selecter switch problem. any work done on vehicle lately? pleas respone and i will try my best to help thanks.

Posted on Jan 31, 2009

suterman
  • 158 Answers

SOURCE: transmission

hello, your truck will not shift from second to third . If it wont shift to third it is going to need new clutchs or seals installed in the transmission that is a common problem with the 4L60e transmission.

Posted on Feb 22, 2009

csmock132
  • 4669 Answers

SOURCE: chevy transmission hangs in 2nd,

It just holds 2nd forever. Is the 1-2 shift point high?

Posted on Mar 24, 2009

  • 14036 Answers

SOURCE: 2001 chevy sylverado 2500hd power steering and power brakes quit

check power steering fluid. first. if all good . power steering is going. your hydro boost brake system depends on the power steering pump if it goes out your brake go out.

Posted on Mar 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 chevy silverado 2500 diesel automatic put in reverse but will not back up


you need to check the code that it set with a scanner and it will lead you to where to check to fix problem

Dec 23, 2012 | 2002 Chevrolet Silverado 2500HD

1 Answer

My 2003 chevy silveraco wont start dash lights flicker and says truck is 2 gear is it the neutral safety switch


look under truck at transmission selector cable if it disconnected [because of rust ] or damaged --the lever may be in park but the selector at transmission is in gear wont start big problem with gm trucks burbs replaced may friends 05 silverado and had to do same for my 08 yukon

Dec 09, 2012 | 2003 Chevrolet Silverado 2500HD

1 Answer

2003 chevy silverado 2500 HD when ingageing 4 wheel high on the fly it makes a load clunk and grinding noise


I had a similar problem and had to have the 4 wheel drive serviced. It need new grease. the grease i had was old and it was causing the gears not engage cleanly thus causing the grinding sound until they were realigned.

Feb 10, 2010 | 2002 Chevrolet Silverado 2500HD

1 Answer

02 duramax w/allison trans threw a P0776 code truck would not pull forward unless in 4 wheel drive. Made clunking noise when put in drive from park. This is apparently a b solenoid but where is it located...


nsbu switch located driverside on the tranny where the gear selector is 2 wire plugs and 2 bolts holding it on, part is about $46 at napa, very common problem with allison

Sep 10, 2009 | 2002 Chevrolet Silverado 2500HD

2 Answers

Vehicle: 2005 Chevy Silverado 2500HD 4X4 Duramax. Problem, when I trying switching the 4 wheel drive switch to 4LO, the light just blinks continuously.


You should have it put on diagnostic scanner to tell for sure. system needs to be tested. As a mechanic myself, I know these can be done fairlty easy on most vehicles but some can be slightly tricky

Aug 27, 2009 | 2004 Chevrolet Silverado 2500HD

2 Answers

2004 Chevy Silverado 2500HD 4X4 help


Go tothe libary and get one there your problem is the locking hubs are sticking and need to be lubed.

May 29, 2009 | 2004 Chevrolet Silverado 2500HD

1 Answer

2002 Chevy Silverado 4wd 2500HD noise


probaly dont have a problem your truck probaly has a gas engaged 4 wheel dr modual and what you hear is the gas modual engaging

Apr 03, 2009 | 2003 Chevrolet Silverado 2500HD

2 Answers

2002 chevy silverado 2500HD (automatic)


the power brakes are a hydrolic system ran off of the power steering pump. therefore if you have a busted power steering hose the power brakes will not work.

Feb 28, 2009 | 2002 Chevrolet Silverado 2500HD

2 Answers

2002 Chevy Silverado clunking noice when shift from 2wd to 4hi


It is somewhat Normal Depending on how Loud the Clunking is. This is a Common Complaint on the Chevy 4x4's. I have verified this through the Dealerships here in Oklahoma and they all say the Same thing But, I am with you, They should go into 4x4 without that Clunk for as much as we pay for them.

Jan 26, 2009 | 2002 Chevrolet Silverado 2500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...