Question about 2005 Ford Ranger

2 Answers

2005 Ford ranger -two wheel drive-4 cyl........wont start. no sound from ignition key....clicking sound in relay.......no lights. battery has full charge

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

It is possible that your relay is bad. To test, pull off little wire that goes to starter, and short it out with a screwdriver between the wire from the battery and the little post where the wire to the starter goes. If the truck cranks, your relay is bad.
I just replaced this part on a 1991 Ranger, it cost 12 bucks and took about 10 minutes.

Posted on Jan 15, 2011

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 40 Answers

Check to be 100% sure that you battery cables are tight.

Posted on Jan 02, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

4x4 will shift to 4 high but will not go to 4 low


Ford Ranger Questions - 4 wheel drive relay clicking under ...

www.cargurus.com > Questions > Ford > Ranger
CarGurusJun 5, 2013 - 4 wheel drive relay clicking under dash - i put my truch in 4x4 the other day and ... and watch it move (or not move) while selecting 4x4 high, low and so forth.... MY 1999 Ford Ranger 4x4 will not go in 4 wheel drive 5 answers.

Sep 14, 2015 | 1999 Ford Ranger SuperCab

2 Answers

98 ford ranger 4cyl 5 speed. When u turn the key to on position I get no warning lights on dash except battery light and seatbelt light. Nothing else.truck wont start. Dont even click.


Check the batter voltage first. If not that check fuse panel under hood for a 100 amp fuse check to see if the fuse is bad or if it has power. Also check fuseable link wire at starter to see if wire is still good. If it is bad, internal short possible on starter, take out and test it. Replace fusible link.

Mar 15, 2015 | 1998 Ford Ranger

3 Answers

Truck turns over and starts when I connect battery???? No key is even in the ignition.


Maybe the ignition is bad- or your starter solenoid stuck in engaged position?

Mar 29, 2013 | 2000 Ford Ranger SuperCab

2 Answers

Will a 87 ford ranger v6 4 wheel drive trans. fit in a 86 ford ranger 4 cyl 4 wheel drive


If automatic transmission wont work engine block's are not the same, if stander transmission you could swap out bell housing held on with four bolt's from one to the other. Good luck and hope this was very helpful.

May 19, 2010 | 1986 Ford Ranger 2WD

1 Answer

I have a 93 Ford Ranger (2.3L 4cyl 5spd manual) and the key lock cylinder is going bad, meaning the key sticks & then won't turn the ignition for 2-4 tries, but then if I turn the ignition switch...


You will need a new lock cyl. which is best purchased from ford, the tumblers are the culpret in your situation, you shouldn't need to remove the steering wheel the cyl can be removed after taking the trim bessels off, also if yours has the big black plastic key you have a transponder antitheft system so it is best to us ford cyl and code it to your original key so no need to reprogram keys, IE aftermarket cyl w. new keys.
The cyl should be about 100+ depending where you live.

Mar 23, 2010 | Ford Ranger Cars & Trucks

1 Answer

2000 Ford Ranger. No power anywhere, new battery


check the body ground and fuesable link!!!

Mar 04, 2010 | 2000 Ford Ranger SuperCab

1 Answer

I have a 1996 ford ranger. my 4 wheel drive wont


If your sure it is acually going into gear than check the auto hubs, they go bad alot. also you can with help from a 2nd person jack the truck up all 4wheels put the truck in 4x4 and drive and see if both drive shafts spin if they do its the hubs if the front one doesnt, its the transfer case

Dec 14, 2009 | 1996 Ford F250 Crew Cab

2 Answers

Starter relay clicks when you turn ignition key on


no this is either caused by a defective starter solenoid (on starter) or a defective positive battery (red) cable, both are common on this year of explorer.

Jun 21, 2009 | 1991 Ford Explorer

Not finding what you are looking for?
2005 Ford Ranger Logo

305 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...