Question about BMW 325

1 Answer

2003 bmw 325xi troubleshooting coolant light stays on after I added antifreeze may have overfilled it??

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,400 Answers

Probably have air in system, bleed at the radiator (small black plastic screw in top)

Posted on Jan 02, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can i buy coolant for my BMW 325xi anywhere besides the dealership


You can go to just about any auto parts store and tell them your vehicle information and they can suggest the proper coolant for your car. Spending money on BMW branded fluids is not needed. They are simply over the counter fluids that BMW slaps their name on.

Semper Fi,
Z

Jan 29, 2018 | BMW Cars & Trucks

1 Answer

The coolant light is on for 2005 bmw 325xi


Either your coolant is low or the coolant level sensor is bad. You should see the overflow resevroir next to the radiator under the hood. Open the cap when the engine is cool and fill with a 50/50 mix of antifreeze to the cold level. If you are already at the level, you will see a sensor mounted on the bottom of that tank. Can probably get it through autozone or definately through Pelican Parts. Easy change..

Mar 06, 2013 | 2003 BMW 325

1 Answer

Car is running hot added coolant runs fine for a while today I was adding coolant to the reserve tank and saw a hose that is loose but can't find where it should be connected. When adding coolant it...


  • There are two hoses on an Antifreeze reservoir tank.
  • One is to allow escape in case of unexpected back pressure or overfill of the reservoir.
  • The other will be a hose that clamps on to the radiator right below the cap on a little spout coming off the fill neck of the radiator. This hose is the actual path the antifreeze takes when the radiator is low pressure pulls the antifreeze out of the reservoir to use.

  • Hope this helps and thank you for using FixYa.
Regards, Tony

Jul 04, 2011 | 2002 Chrysler PT Cruiser

1 Answer

2003 saturn ion adding antifreeze every 2 weeks cannot find leak


There should be a radiator cap as it controls what goes into the overfill tank. You might consider replacing it. If there are no leaks in the radiator or hoses, there are only 3 places the coolant can go (water pump leak, blown gasket, or out throught the radiator cap). Hope its the cap because that's the cheapest. Good luck!

Mar 10, 2010 | 2003 Saturn ION

3 Answers

2003 BMW 325xi won't start, dashboard and radio go on.


My 2003 325xi died on the highway a few weeks ago, and I thought it was the battery. It turned out to be the alternator, which was an expensive problem to repair. If your battery is new, it could be the alternator, or a problem with the electrical system. I find the BMWs to be too complicated electrically, which often leads to problems! I'd check your alternator...

Aug 08, 2009 | 2003 BMW 325

1 Answer

Changing headlamps on 2003 bmw 325xi


I am assuming that you have a burned out head light bulb.
1) Open hood.
2) Working in back of headlight assembly, grasp rear of bulb socket (harness connector) and turn counterclockwise 90 degrees. Pull bulb out of headlight assembly.
3) Disconnect harness connector from bulb (gently pry, it's plastic)
4) Installation is reverse of removal. (Do not touch halogen bulb with bare skin-oils from hand will cause bulb to burn out.) Align tabs on bulb base to cutouts on rear of lens assembly. (Note bottom tab is wider than other two) Secure bulb by rotating clockwise 90 degrees.
Low beam bulb H9006
High beam bulb H9005

Jan 07, 2009 | 2003 BMW 325

1 Answer

Bmw 325xi 2003


You 're looking for this:

item No. 07 CLIP 2EA Part No. 34211157046

These come in pairs at a BMW parts store for a decent price.

Aug 15, 2008 | 2001 BMW 325

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Anthony Jones
Anthony Jones

Level 2 Expert

128 Answers

Chris Bowser

Level 1 Expert

18 Answers

Nyte_Ryder

Level 2 Expert

102 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...