Question about 1995 Honda Civic

1 Answer

I need a picture of the wireing to a distributor

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 170 Answers

My suggestion is to purchase a Haynes Repair Manual for $25 or so from Auto Zone, or online: They have complete instructions and pictures of step by step repairs based on a complete teardown and rebuild. Good investment for those of us with any age used cars.

Posted on Jul 09, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I need 1988 mercury cougar v6 spark plug wire diagram!!!..thank you...

If your talking about the firing order? I didn't know if you had distributor or coil pack, so here is both. I don't like using a picture to show number 1 spark plug tower, that can be misleading, with a distributor. The firing order is 142536.

May 16, 2015 | 1988 Mercury Cougar

1 Answer

I need Spark plug wiring diagram wire to distributor for 2000 mercury mountaineer

You don't have a distributor but a coil pack, according to my info. The info is 4.0L sohc

I hope the picture works.

Nov 14, 2014 | 2000 Mercury Mountaineer

1 Answer

Diagram or picture of where the spark plug wires go into the distributer on a engine number 318-1

For this you have to determine when the #1 cylinder is at TDC (Top Dead Center) - when it would be firing. Take the distributor cap off and look at the rotor - it would be pointing at the #1 spark plug wire on the distributor. The wires would be connected it order around the distributor cap starting at 1. The sequence is 1-8-4-3-6-5-7-2 in a clockwise fashion.

Jul 13, 2014 | 1983 Dodge Pickup

1 Answer

95 Nissan Altima 4 pin electrical connector to the distributor.

You could potentially short circuit something, but most likely if it's wrong you'd blow a fuse. Google 95 Altima distributor connector and see if a picture shows the wire colors, and plug them back in matching the picture, or check ebay/amazon for a new one. Could be called Distributor connector, distributor wiring harness, distributor pigtail, distributor electrical connection, ect.

Oct 27, 2017 | Nissan Altima Cars & Trucks

1 Answer

Lost diagram of coil wiring on 74 type 1 VW bug

The standard wiring is like this. From the Ign. switch, when the key is on you have the hot coil wire, this wire will connect to the positive terminal on the coil. The negative side of the coil will go down to the distributor points connector where the condenser will also be wired. See #1 in this picture. mcneb_7.gifHere is also a picture of how to wire your distributor. Now this picture shows a resistor wired to the positive side of the coil it is not necessary. It is used to save the points in some older systems. Some may not run with it. Hope this helps Fix Ya up. mcneb_8.gif

Aug 23, 2011 | Volkswagen Beetle Cars & Trucks

1 Answer

How to replace ignition coil

there are 2 types of ignition coil: in the 1st picture (the red one), you just need to remove the screws attached to the vehicle, remove the 2 smaller wires, then remove the high tension wire. REMEMBER to mark the wire for the positive(+) terminal of the ignition coil. for the 1nd picture, this requires some skill. this type of ignition coil is placed directly under your distributor. so if you are not familiar with ignition timing (timings dictated by the angle of your distributor), do not replace the ignition coil by yourself

Aug 05, 2011 | 2002 Mercury Sable

2 Answers

I need a diagram for the spark plug wiring on a 1980 F100 6 cyl

Hello kat801931,

The firing order is:

1 5 3 6 2 4

Below is a picture of the cylinder order and the distributor. Number 1 cylinder is at the "white" location on the distributor. Good luck.



Apr 02, 2011 | Ford F-100 Cars & Trucks

2 Answers

Need to replace distributor on 99 honda civic lx

How do you install a distributor on a 1999 Honda Civic?

Feb 17, 2010 | 1999 Honda Civic

1 Answer

I need to see a picture of spark plug wiring and distributor for a 1992 chevy 1500 with a 350 motor.

Firing order is:
on the stock intake manifold. It is 1,8,4,3,6,5,7,2 (i.e. 18436572, 1-8-4-3-6-5-7-2 at 4 degrees before top dead center). 1,3,5,7 is on the left bank ,4,6,8 is on the right bank. Clockwise distributor rotation. #1 is identified on the distributor cap, the wire clockwise is #8, etc.
1992 Chevrolet C 1500 P/U 2WD
5.7 liter V-8 VIN "K" 41894093.gif

Oct 13, 2009 | 1992 Chevrolet K1500

Not finding what you are looking for?
1995 Honda Civic Logo

Related Topics:

227 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides