Question about 2004 GMC Envoy

1 Answer

My 2004 Envoy gaas the speed monitor needle stuck at zero and this has been since September where it was bouncing from one speed to another.\r\n Milage72,900

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 1,201 Answers

Replace the stepper motor on the back of gauge.

Posted on Jan 02, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 envoy back door won't closew just bounces back help !


Hey Susan,
Sounds like the latch/lock mechanism in the door is stuck in the "locked" position...you can look at the door lock, if the latch piece is in the way of the vehicle latch piece, you can move it out of the way with your hand/fingers. There should be nothing blocking the door latch mechanism..I hope this is clear enough...

Sep 10, 2017 | Cars & Trucks

1 Answer

Had a flat tire,reduced engine power light came on


Either the tire pressure monitoring system detected excessively low or zero tire pressure and the computer has been programmed to set the vehicle into limp mode when that happens or a wheel speed sensor or another sensor detected an issue when the tire deflated and the computer sent the vehicle into limp mode.

One way or the other, once in limp mode there would have been fault codes generated and could have be read with a scan tool. They have probably cleared now.

Jan 15, 2016 | 2004 GMC Envoy

2 Answers

How To Fix The Speedometer On My 04 GMC envoy


GM went to electronic (as opposed to mechanical) speedometers many moons ago, so your most likely culprit is either the sensor unit at the transmission or the wires to the speedo, or (as happened to me) the gear in the trans that drives the sensor is bad (I had to pull the tailpiece on my '91 Corvette to replace it)...the speedometer itself could be bad, too, but that's not very likely...

Jan 01, 2015 | 2004 GMC Envoy

1 Answer

The car is an automatic.


When you say the speedometer does not work, do you mean the needle is stuck at certain speed or is at zero all the time.. If it is at zero all the time, replace your meter. If it's stuck at certain speed, give it a knock with your fingers. And if that do not work, drill a pin hole with a fine drill just above the position where the needle is stuck and using a fine thin wire, push the needle back to zero position.

Dec 09, 2014 | 1996 Honda Civic

1 Answer

Rpms rough


That kind of engine speed change is usually caused by a vacuum leak, most likely around the intake manifold.

Dec 28, 2012 | 2004 GMC Envoy

1 Answer

Speedometer needle not accurate. It shows a higher speed than the actual speed


Did you perhaps change your tires to a different size or recently swap out the transmission or rear end?

Oct 30, 2011 | 2004 GMC Envoy

1 Answer

I have a 1997 dodge grand caravan and the speedometer is stuck on 120 mph! I was traveling and the alternater went, so I got a new one and a new battery. The car is running fine, but the speedometer and...


you may have to take a magnet and put it over the speedometer needle and move the needle back to zero,this some times happens when a battery is connected as the voltage surge causes the needle to bounce some times to far and its not able to return to zero.you may need to have the system checked for proper charging,the voltage could be borderline causing the light to come on.you can try disconnecting the battery as it may reset the light.

Mar 28, 2011 | 1997 Dodge Caravan

1 Answer

Speedometer needle bounce when turn signal is on.


The speedometer sensor - VSS - vehicle speed sensor is a input to the PCM - powertrain control module -engine computer . The signal from the PCM to the instrument cluster for speed info. is sent on a serial data communication network (class 2 ) I would think it would be an instrument cluster problem . Get a used one from a auto salvage yard 15 - 20 bucks an see if it fixes it . If it does ,send your's out an have it repaired .

Nov 07, 2017 | Buick Regal Cars & Trucks

1 Answer

2004 Buick Rendezvous 6 cyl Front Wheel Drive speed and rpm issue


you have a connection problem going to your intrument cluster unless your real handy working on auto`s better take it to a mechnic

Oct 25, 2009 | 2004 Buick Rendezvous

Not finding what you are looking for?
2004 GMC Envoy Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...