Question about 2001 Chevrolet S-10

1 Answer

Where to find the fuel pressure sensor on a 2000 gmc jimmy?, I am trying to replace a fuel pressure sensor that the auto parts told me needed replacing for the light to go off that says service engine soon, but they couldn't tell me where it goes? I have already replaced the cap to the gas tank, two sensors , changed oil and air filter but the service engine is still on and I also tried diconnecting the batter , neg but that didn't help either. I really need help. Thankyou

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 3,230 Answers

Are you talking about fuel tank pressure sensor? Hope you can read it?
where to find the fuel pressure sensor on a 2000 - fuel tank pressure sensor-ucfez04znayxcwbifhs0k5mi-1-0.jpg

Posted on Jun 06, 2017

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

shanat
  • 359 Answers

SOURCE: Got a 96 gmc jimmy auto shifter stuck in 3rd gear goes in 1 and 2 but nut n r or p so it wont start?

check yr gear linkages

Posted on May 23, 2008

emissionwiz
  • 75051 Answers

SOURCE: Fuel level sensor in tank bad????

Yes it is all one unit, and yes that is what the problem is. don't use aftermarket parts, use OEM, (Delco Remy) they are much better quality.

Posted on Sep 08, 2008

  • 1 Answer

SOURCE: 2000 chevy blazer, truck cranks

Does your battery go dead?

Posted on Dec 18, 2008

  • 43 Answers

SOURCE: service engine soon light on 2002 chevrolet tahoe stays on

That normally means that you have a issue with your gas cap try replacing your gas cap first then diconnect the negative terminal of the battery for about three minutes to clear the memory and start the truck again

Posted on Apr 11, 2009

dennymulford
  • 1055 Answers

SOURCE: GMC Jimmy just dies

its vapor locking,try leaving the gas cap a little lose

Posted on Jun 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My cylinder is misfiring on my 2000 gmc jimmy


replace fuel filter, air filter, spark plugs, wires, distributor cap /rotor, if you have one. new oil with your filter ? just thought I'd ask, have a auto parts store pull code to see why your service engine soon light is on. this will tell you what sensor needs replaced, I'll bet its the oxygen sensor !

Feb 23, 2013 | 2000 GMC Jimmy

1 Answer

2000 GMC Jimmy, starts up every time, but only runs for 10 seconds then dies. Restarts every time but will not stay running. Replaced fuel pump, fuel filter, CAM position sensor, crank position sensor,...


you say fuel pressure is good, but what is it? what is the fuel pressure when it stalls out? Spec is 60-66 psi and it wont run if its 55 psi. the fuel pump relay should be good if the pump runs. Make sure the ground for the pump is good , G402 should be on left frame rail. you may have had it off to replace the pump? maybe? it may be time to stop guessing and have a repair shop diagnose it for you. You sure have replaced a lot of good parts.

Sep 07, 2011 | 2000 GMC Jimmy

2 Answers

2000 GMC Jimmy 4.3L CSEFI won't crank. Fuel pressure is 50psi and should be between 55 to 60psi. Fuel filter 1yr old and fuel pump is probably stock & needs replaced but never had problem before...


Check your starter and check your connections to make sure they are clean and tight. The low fuel pressure won't cause a no crank. Too low could cause a no start but not a no crank. I've had starters be bad right out of the box. But if that starter motor isn't turning either the starter motor is bad or the solenoid attached or the wiring to it is at fault.

Oct 06, 2010 | 2000 GMC Jimmy

1 Answer

2000 jimmy wont start. replaced flow mass senser cuz when we tapped it it idled better. turns over but wont start. fuel pump putting out 60psi. has fuel in the tank. check engine lite is on.


have truck scanned most auto stores such as auto zone / advanced do this service for free check ur local area the code will give u what the problem is so u can repair ur vehicle tapping the sensor and working better shows more of a connection problem than the sensor it self usually the mass sensor can be cleaned

May 05, 2010 | 2000 GMC Jimmy

1 Answer

Starts then it shuts off


Take the battery to Sears or another large auto parts store and ask them to check the condition of the battery. They do it for free. Other than that the ignition switch could be worn out. Not the key, the electric switch.

Nov 10, 2009 | 2000 GMC Jimmy

2 Answers

2000 Jimmy running one second and just won't start the next. Will crank but no fire. Changed fuel filter and while doing so turned key and swa fuel pump working.


If no check engine light is on, I would check the ign-distributor cap and rotor, also check the crank and crank sensor. There is also a ign-mod located in the distributor assembly under the rotor. They will fail when hot.

Jul 20, 2009 | 2000 GMC Jimmy

3 Answers

2000 GMC Jimmy won't start


i had the same problem and replaced the fuel pressure regulator. Cost about $45 at advance auto store or about $90 at napa auto stores. Once i replace that my truck started right yup and runs like a champ

Jun 13, 2009 | 2000 GMC Jimmy

2 Answers

My 2000 gmc jimmy will not start. It will turn


Have you hooked up a fuel pressure gauge to the test port on the rear of the intake, drivers side. You can get a fuel pressure tester for about 40 dollars at a part store. It is a real good tool to have in your toolbox. If your Jimmy can't build 55 psi, it won't start.

Mar 06, 2009 | 2000 GMC Jimmy

1 Answer

Can't find Fuel pressure regulator on 2000 Jimm


you need to remove the upper intake manifold to get to the FPR

Dec 14, 2008 | 2000 GMC Jimmy

Not finding what you are looking for?
2001 Chevrolet S-10 Logo

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...