Question about 1985 Toyota Celica Supra

1 Answer

I have a 1983 Toyota Supra. Yesterday I started the car and the automatic antenna raised and the radio turned on. I pushed the stop button and the radio shut off and the antenna retracted. However, a few seconds later the antenna again raised and the radio turned on. How do I resolve thsi issue.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

I think it's a problem with the radio itself. The antenna only responds when the radio is turned on / off. So the antenna sounds like it's working properly.

Posted on Jan 03, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why my 1983 supra has no spark?


Check the coil, the distributor, points (if it has points - not sure if that one's electronic or not), cap, rotor. Check the voltage going to the coil when the key is turned to "on", and again when the key is turned to "start".

Jul 26, 2014 | 1983 Toyota Celica Supra

1 Answer

No engine power driving


Is it automatic or manual...?
-If automatic>>> Make sure trasmission fluid is level.
-If manual>>>> Clutch won out.

Mai lor

Feb 25, 2013 | 1983 Toyota Celica Supra

1 Answer

Where is the fuel filter on a 1983 toyota celica supra


ITS UNDER THE INTAKE (REAR) AND A ***** TO CHANGE

Oct 19, 2010 | 1983 Toyota Celica Supra

1 Answer

How to replace thunderbird antenna


please rate service.

Automatic Electric Antenna
Removal
  1. Lower electric antenna (18850) .
  1. Remove rear retaining screws of RH front wheel splash shield for access to antenna lower retaining bolt.
  1. Remove lower retaining bolt.
  1. Remove radio antenna nut (18865) from top of motor tube and remove electric antenna through fender/splash shield access.
  1. Disconnect signal cable and motor wire connector(s).
Installation
  1. To install, reverse Removal procedure.
  1. Tighten top radio antenna nut to 6-8 Nm (54-70 lb-in).
  1. Tighten lower electric antenna retaining bolt to 5.8-7.8 Nm (51-69 lb-in).
  1. Check operation of electric antenna and radio chassis .

    Automatic Electric Antenna


    1faf511.gif

mast
Mast, Power NOTE: A power antenna mast which is bent or broken can be replaced without replacing the motor and tube assembly.
Removal
  1. Remove radio antenna nut (18865) and radio antenna stanchion (18919) .

    ssd~us~en~file=l6389b.gif~gen~ref.gif

  1. Loosen retaining nut inside tube using 14 mm (9/16 inch) socket, and slide nut part-way up mast.
  1. Raise antenna to run plastic drive wire at bottom of mast out of motor. Note direction of teeth on plastic drive wire.
  1. Saw off damaged portion of antenna mast. Remove burrs from mast and slide nut and contact tube off stationary tube.
Installation
  1. With the teeth on the plastic drive wire facing toward motor on antenna, push end of plastic drive wire of replacement mast assembly down into tube. Push it around curve at bottom of tube until end enters drive mechanism.
  1. Run motor down while pushing on plastic drive wire until about 305 mm (12 inch) of wire has been drawn into the tube. Stop motor and insert bottom of antenna mast into tube. Lower mast.
  1. Slide contact tube and radio antenna nut down antenna mast. Tighten nut to 0.45 Nm (4 lb-in).

  2. Raise and lower antenna several times to ensure proper operation.
651247a.gif

Jul 09, 2009 | 1995 Ford Thunderbird

2 Answers

I have no ignition spark on my 1983 Toyota supra


is the timing belt ok? there is also an igniter that controles the spark shoud be by the coil

Dec 11, 2008 | 1983 Toyota Celica Supra

2 Answers

1992 toyota supra


you might be better off with a repair manual but you wil only be able to find owner's manual from dealer or posbly ebay

Dec 05, 2008 | 1992 Toyota Supra

1 Answer

Removal of power steering pump on 1983 toyota supra


its very easy just unhook the lines and take the bolts thats connected to the exhast manifold

Nov 15, 2008 | 1983 Toyota Celica Supra

1 Answer

Radio Wiring Help


Never heard of that, Just saw a switch like that on a Honda accord. Raised it and lower whenever you wanted. If you got an aftermarket radio, connect a switch between the Antenna power wire and the receiver antenna power of the radio, you can get the switch at radio shack. A 3-way jump switch should be your option.

Aug 06, 2008 | 1995 Toyota Camry

Not finding what you are looking for?
1985 Toyota Celica Supra Logo

234 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...