Question about 2000 Plymouth Grand Voyager

1 Answer

How to change the alternator on my 2000 grand voagear

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 112 Answers

This is for a 3.3L motor
Hope this helps, it it does please leave feedback and vote Thank You and Good Luck

REMOVAL

  1. Release hood latch and open hood.
Removal/Installation of Battery Cables how to change the alternator - 81929864

  1. Disconnect battery negative cable.
  2. Remove windshield wiper housing, refer to the Windshield Wipers and Washers for proper procedures.
  3. Remove accessory drive belt.
Generator Mounting Bracket 81929870

  1. Remove bolt holding top of generator mount bracket to engine air intake plenum.
  2. Remove bolts holding outside of generator mount bracket to generator mount plate.
  3. Remove bolt holding top of generator to mount bracket.
  4. Remove generator mount bracket from vehicle.
  5. Rotate generator toward rear dash panel.
Generator how to change the alternator - 81929868src="http://i.fixya.net/uploads/images/81929868" alt="81929868" class="h_mi" />

  1. Disconnect the push-in field wire connector . from back of generator.
  2. Remove nut holding B+ wire terminal to back of generator.
  3. Separate B+ terminal from generator.
how to change the alternator - 81929871nerator Pivot Bolt 81929871

  1. Remove bolt holding bottom of generator to lohow to change the alternator - 81929872t bracket.
Generator 81929872

  1. Remove generator from vehicle
INSTALLATION

  1. Place generator in position on vehicle.
  2. Install bolt to hold bottom of generator to lower pivot bracket.
  3. Place B+ terminal in position on generator.
  4. Install nut to hold B+ wire terminal to back of generator.
  5. Connect the push-in field wire connector into back of generator.
  6. Rotate generator forward away from dash panel.
  7. Place generator mount bracket in position on vehicle.
  8. Install bolt to hold top of generator to mount bracket.
  9. Install bolts to hold outside of generator mount bracket to generator mount plate.
  10. Install bolt to hold top of generator mount bracket to engine air intake plenum.
  11. Install accessory drive belt.
  12. Install windshield wiper housing, refer to the Windshield Wipers and Washers for proper procedures.
  13. Connect battery negative cable.
  14. Verify generator charge rate.

Posted on Jan 02, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Do you have to replace an alternator for a 2000 Mercury Grand Marquis GS with a factory authorized alternator? We bought one at the auto parts store and it said you may have to replace the pulley and our...


Take that alternator back,and try another parts store.Bring the old alternator with you,and do NOT pay for the part unless they find you an alternator with the right pulley,or allow you to swap the pulley on sight to verify it will work.In extreme cases,you may be able to send your alternator to be rebuilt and get the same one back,but I don't think this is the only solution.

Oct 07, 2012 | 2000 Mercury Grand Marquis

1 Answer

Battery warning light is on after a new battery and alternator on a 2000 grand voyager


There should be a fuse or fuseable link between the battery and the alternator.
Check the voltage at the battery wire on the back of the alt - should be 12 volts or more.
The alternator is turned on by the ASD relay and the computer.
If the engine is running I will assume the relay is working.
If you have battery voltage on the big wire and the alternator is not charging, you could have a problem with the computer.

Jul 16, 2012 | 2000 Plymouth Grand Voyager

1 Answer

I've replaced the battery and alternator in my


you could of got a bad alternator i have had that problem before

Apr 06, 2012 | 2000 Pontiac Grand Am GT

1 Answer

2000 grand am se not charging, what could be the problem? changed battery and alternator, checked #49 fuse in the fuse block.


check the voltage at the alternator, then the wire going to the battery, you should be getting 14.4 volts or thereabout, inspect the grounda at the battery and frame and engine, then make sure the alternator is grounding on the engine

Jul 29, 2010 | 2000 Pontiac Grand Am GT

1 Answer

How to change an alternator?


I don't know if you have the job done since your posting. It's a very easy job. I did replace mine few days ago. Let's say 30 minutes job with right tools and an inside work area. 1- disconnect battery terminals 2-remove the air filter assembly giving more room to work. 3- disconnect the wire connection to the back of the alternator 4- using a wrench key (14 or 15 milimiter dont remember) release the tension on the strap swinging the bender wheel (located at your left) to the right. Maintaining the binding wheel at this position get the strap out of the alternator pulley. Try to keep the strap in place on all the other pulleys and rollers to save you reinstall work. 5- Unscrew and remove the 3 bolts retaining the alternator (14 or 15 milimeters ?) remove and replace the alternator. Maybe you will have to use a prybar to get it out of its seat. 6- Do the reverse step by step to complete the job. Just make sure that the strap is sitting properly over the pulleys and rollers. Once complete, start the engine and check if everything is in line in regard to the strap. If the alternator was really the root cause of your problem now the meter in your dash should indicate between 13.5 and 14 volts with all the demand turned on ( front beam, defrost, heater fan, wiper). Within these bondaries you're in business. Good luck Sorry for my poor english language. Dan

Nov 24, 2009 | 2000 Jeep Grand Cherokee

1 Answer

I own a 2000 grand am gt v6, and how do i change my drive belt.


you can use belt tool or 3/8 long arm ratched place your tool on tensioner (on pulley side has housing to place your tool in , tensioner between alternator and ps pump one bolt arm and plastic pulley on it stand front of the vehicle and push your tool to firewall to relase the belt tensioner and use other hand and remove belt from the alternator then easly let the tensioner go and remember place the new belt on all the pulleys and leave alternator pulley on last place) front of steering pump reservoir have label that shows the belt assembly make sure new belt in correct position on all the pulleys and push the tensioner and place to belt on correct position and make it tight. before start to vehicle fallow the all belt for make sure no missing pulley and belt is placed straight on all the pulleys no missing lines.

Oct 24, 2009 | 2000 Pontiac Grand Am GT

2 Answers

I need to replace the alternator on my wife's 2000 dodge grand caravan sport. How do I go about this?


moz-screenshot.jpgmoz-screenshot-1.jpg Removal & Installation

3.0L Engine
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:

    Negative battery cable Wiper module Accessory drive belt Alternator mounting bolts Alternator harness connectors Alternator

To install:
  1. Install or connect the following:

    Alternator Alternator harness connectors Alternator mounting bolts. Tighten the bolts to 40 ft. lbs. (54 Nm). Accessory drive belt Wiper module Negative battery cable
  2. hope this helps let me know if you need more. dc

Jun 24, 2009 | 2000 Dodge Grand Caravan

1 Answer

Changing alternator, 2000 grand caravan


disconnect battery, remove belt, take off wipers, remove tray holding wiper drive parts, there is a plug, 2 drains,and washer hose to disconnect, remove trianglar plate on top of the ALT, including the top ALT bolt, push ALT to the back, remove wires, remove lower ALT bolt, rotate ALT to the spot between the engine,strut tower, AC line, and fuel line, it will come out through this spot. The hook shaped bracket stays in place and in the way. This was a 2000 grand caravan 3.8 with AC. all bolt/screws are fairly accesible

Apr 28, 2009 | 2000 Dodge Grand Caravan

1 Answer

I can not figure out how to remove the alternator from a 2000 caravan w/3.3l engine. Alternator is free but I can not contort it out of the engine compartment? Any help please! Thanks Greg


I have recently done this twice to my 2000 Grand Caravan with the 3.3l engine.
1) Remove the top plate which is attached to the alternator mounting bracket held in by 3 bolts.
2) remove the alternator bolts securing the altenator to the mounting bracket.
3) pry the alternator off the bottom mounting bracket
4) turn the alternator around show you can easily see the power wires on back of the alternator and remove the 11/32 nut holding the wire to the alternator. Be careful not to drop the nut behind the engine, because you probably will never find it (experienced).
5) Disconnect the wires from the alternator
6) Remove the black cooragated tube running vertical in front of the alternator and remove the tubes hold clip from the suspension wall.
7) Slide the alrernator pully first up through the opening. You may need to rotate the alternator a little so it fits up through.


Chris

Mar 21, 2009 | 2000 Dodge Grand Caravan

Not finding what you are looking for?
2000 Plymouth Grand Voyager Logo

427 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...