Question about 2007 Suzuki XL-7
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2007 xl7
Brake lights were easy... open hatch you will see 2 lil circle covers with a notch out of the bottom for removal... i used a flat head to remove these then used a phillips head screw drive to remove the two screws behind the covers... pull out unit and you will see where the bulb goes... pull that out and just put the bulb in. It was sooo very easy... thanks Kim
Posted on Jan 26, 2009
Unplug the connector running to the back of the headlamp bulb. Remove the rubber ring that is on the back of the headlamp. It just pulls off. After the rubber is removed, you will see the clip to release the bulb.
Posted on Oct 07, 2008
open the hook and you going to find a black rub cover the bulb then, pull the rub slowly to not
break it. Then, you will see the cross wires on top of the bulb. Then check it for small opened at the end of the wire push down and open to let the bulb free and pull the old bulb out in the space of the opening wire. Take the new bulb and fallow the instructions backboard.
Posted on Nov 21, 2008
You change it like you'd change any headlamp bulb. There is an access cap behind the headlamp assembly -- remove it, then remove the connector to the bulb, then remove the retaining clip/spring holding the bulb in place. Then install/insert the new bulb in the same 'ORIENTATION' as the old one. Reinstall in reverse order... ALAKAZAM!... .done!
Posted on Jun 25, 2009
At the rear of the headlight under the hood, you will see the nylon bulb holder. Squeeze the tab to unlock it, and turn it counterclock wise. Pull it out, and, with out touching the bulb with naked fingers, pull the old bulb out, and put the new one in. The natural oil on your fingers, the stuff that makes finger prints, will cause the bulb to fail prematurely, so, use a paper towel or gloves to handle the new bulb.
Posted on Jul 11, 2009
Tips for a great answer:
Oct 26, 2012 | Cars & Trucks
Feb 12, 2012 | 2003 Jaguar X-Type
Aug 03, 2011 | 2007 Chevrolet Suburban Three-Quarter-Ton...
Jun 18, 2011 | 2003 Oldsmobile Alero
Jun 15, 2011 | Kia Amanti Cars & Trucks
Apr 26, 2011 | 2002 Toyota Tundra
Aug 19, 2010 | 2000 Volkswagen Beetle
Feb 11, 2010 | 2007 GMC Acadia SLE
Mar 04, 2009 | 2001 Mitsubishi Galant
Jun 08, 2008 | 1995 Honda Odyssey
366 people viewed this question
Usually answered in minutes!