Question about 2001 Ford Expedition

1 Answer

I have a Ford Expedition 2001. When I put the vehicle on Drive, I give it gas and it doesnt move, like I have it on neutral. I just bought a code reader and it gives me 10 codes stating solenoid. Please help

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 81 Answers

Assuming your vehicle has an automatic transmission, and if it just started doing this,your probably low on transmission fluid. if this has been going on for some time....there's a good chance the transmission has been damaged permanently. That is to say....if you have repeatedly put the car in gear and revved the engine and or driven it while it is slipping badly, it doesn't take too much of this to burn up your transmission. If the former is your case, with a warm engine in park, emergency brakes set, level ground...check your transmission fluid level on the dipstick ( it should be labeled) the checking xxxx mark at the top represents full when the fluid level is covering it. Unlike the engine oil, the xxxx represents 1 pint, not 1quart.

Theroadisalover

Try to post back and let me know If I helped you solve your problem. It will help me with my rating....!! Thanks

Posted on Jan 02, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is 2001 ford expedition jerky at 40 mph?


I need a little more information to give you an answer. There are a number of things that can cause your vehicle to do this. Is it hard to start, how does it idle, how does it act above 40,and how does the exhaust smell, is there any black suite coming out of the exhaust when you get on the gas, what engine is it V8, or V6. The item that can cause this are, fuel pressure relief valve, mass air flow sensor, throttle position sensor and the oxygen sensor.. If you can answer these for me it will help me give you a better answer. Thanks.

Feb 25, 2015 | 2001 Ford Expedition XLT

3 Answers

How do i put my 4x4 on my 95 yukon......on park or neutral. and do i have to put my foot on the brake?


You can shift between 2Hi and 4Hi when the truck is moving. Just let off the gas and shift it. But in order to shift to Neutral or 4Lo you need to stop the truck and shift the transmission into neutral then shift the transfer case.

Dec 06, 2010 | GMC Yukon Cars & Trucks

1 Answer

Hi my 2001 ford expedition code read po304 my neutral kicks in but does not move back when pushing only forward and my reverse kicks in but does not move and the over drive light is flashing and when in...


A code p0304 is a number 4 clyinder missing causing the rough run condition, last cylinder on the passenger side ,coil or spark plug the transmission problems and overdrive light on is a transmission problem.

Apr 07, 2010 | 2001 Ford Expedition

1 Answer

2002 ford expedition wont start after being towed. Have tried restarting in ten minute incriments, as well as unhooking the battery, and the fuel reset switch..


Do you hear the fuelpump when you first turn the key?
Check the fuse panel if not.

Or try to start it in neutral instead of Park. With the vehicle being moved the starter lockout may be out of adjustment that although it cranks the other terminals are not lining up to give it an ignition pulse.

If you have Keyless you may have to enter the Security code in the Keypad to reboot the antitheft.

Nov 09, 2009 | 2002 Ford Expedition

Not finding what you are looking for?
2001 Ford Expedition Logo

226 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...