Question about 1991 Buick LeSabre

1 Answer

Trying to install an aftermarket deck wireing harness adapter dose not fit wireing direct unable to figure out some of the wires 2 black blackégrey with some kind of sensor white 2 dark green with a purple all the rest i think i have amtched up according to a diagram i found just the other wires werenèt listed so i wanted to check on what they are and how to wire them or do i need to the car is the limited edition with all the bells and whistles

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 85 Answers

1991-93 Buick Lesabre Stereo Wiring Constant 12V+ Orange Switched 12V+ Yellow Ground Black Illumination Gray Dimmer Brown Antenna Trigger Pink Antenna Right Front Front Speakers 4" x 6" Dash Left Front (+) Tan Left Front (-) Gray Right Front (+) Light Green Right Front (-) Dark Green Rear Speakers 6" x 9" Rear Deck Left Rear (+) Brown Left Rear (-) Yellow Right Rear (+) Dark Blue Right Rear (-) Light Blue

Posted on Jan 01, 2011

  • Anonymous Jan 02, 2011

    still dont know what the extra wires are for.... i have the above wires all connected as they should be but im still trying to figure out what the extra wires are for mainly the sensor and does it have to be somewhere special also its the limited edition and has a power antenna i have the antenna trigger wire hooked up but ièm assuming the 3 togeter 2 dark green and a purpleÉ grey and black is goin to the sensor and then there is another black and white spare unless there is 2 grounds maybe if i can find a master wireing diagram it would indicate what they all belong too but all were orignally hooked up to the ac delco deck and the sensor was just hooked onto a clip on the back

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need a radio wiring diagram for a 2003 ford windstar


Which diagrams do you need?...if it is to install an aftermarket deck, get an adapter so u dont cut into the factory wiring harness..the adapter plugs into the factory plug and allows u to solder the aftermarket radio wires to the other side of it.I have attached a link to where u can get the adapters...unfortunatly this wont allow me to send u my radio schematics that are in PDF format.
Car Stereo Installation Parts for2003 FORD WINDSTAR

Mar 08, 2015 | 2003 Ford Windstar

1 Answer

Is there a wiring harness adapter for an aftermarket stereo in 96 fleetwood


Usually Someone That Sells That Exact Model Stereo Has Adapter Harness Available--Problem If No Longer Sold. WALMART Has Adapters For What They Sell.

Feb 27, 2015 | 1996 Cadillac Fleetwood

1 Answer

I totaled my 01 Nissan Sentra, I was able to take out my aftermarket stereo with the wireing harness already attached - I had te deck professionally installed because I did not trust myself to connect all...


I can't answer your question, but i can give you a suggestion. What I did, was go to eBay and buy a radio wiring harness for the vehicle I was going too install the radio into (I think this one is for you vehicle eBay auction # 330605601746, I have nothing to do with said auction. You can also try Amazon.com, but eBay for me was cheaper) You hook the radio up to the harness and just plug it into the car's radio plug. Since the car currently has an aftermarket radio installed, they may have cut the cars plug off and installed it directly. You would have to pull the radio out to check first.

Jun 25, 2012 | Cars & Trucks

2 Answers

How to connect aftermarket radio into 2002 toyota camry JBL radio (the standart wiring doesn't work).Thanks


Your aftermarket radio should have color-coded wires which identifies power, ground, speakers, etc. most depaetment stores carry a radio harness adapter kit. This will connect to your radio's exact color coded wires, and will plug right in to your factory's wiring plug. And don't forget electrical tape.

Aug 28, 2011 | 2006 Toyota Camry

1 Answer

05 grand what do i need to install a aftermarket radio


Get a wiring harness adapter kit (about $10) from a stereo shop. It has harness plugs that will plug directly into your harnesses in the dash, and has color-coded wires that you will color-match to the wires on the aftermarket deck's harness. You may need an antenna adapter as well. If your stock stereo face is taller than the aftermarket one, you'll need a dashboard adapter kit to take up the extra space.

Dec 10, 2009 | 2005 Pontiac Grand Am

2 Answers

2004 civic, aftermarket deck installed... no am/fm reception


Is your rear window tinted? If so the metal in the tint is causing your reception problem.

May 04, 2009 | 2004 Honda Civic

1 Answer

Remove audio deck from 2003 Astro


It is very easy: With parking brake applied, shift to 1st gear, then remove the dash panel that goes around the instrument cluster and the stereo. Once the panel is off, you there is a black tab on both of the side of the unit that you push down, and then pull the unit out.
To install an aftermarket deck, I recommend a specific wiring harness adaptor, that you splice onto the connector included with the new deck - so that you can reinstall the original one if/when you want to sell the vehicle. If you don't, you have to cut the original harness wires, and connect them in the correct orentation (which is tough, as there is about 20 wires!)

Apr 29, 2009 | 2003 Chevrolet Astro

1 Answer

Wiring difference


If your installing a stock radio/cd player from another Dodge the wiring plug is the same and will fit.If your installing a aftermarket radio/cd player(JVC,Pioneer,etc)you will need to buy a adapter plug that wires up to the radio and is a direct fit to your factory wire harness,so your not cutting your wires.When you buy the adapter plug it comes with a wire diagram of which wire is what.Your aftermarket radio should have a diagram also,either on it or in the manual.Hope this helps you.

Mar 04, 2009 | 2002 Dodge Caravan

2 Answers

Cut harness from stereo in 1990 corolla dx sedan


did u know that they make a harness for your car that plugs into your factory harness and then adapts to your aftermarket radio? for the lights, you have blown the interior light fuse, it may be the same fuse as the cigar lighter.Below is your radio wire colors and what they do.
1990 Toyota Corolla Car Stereo Radio Wiring Diagram.
Radio Constant 12V+ Wire: Blue/Yellow
Radio Switched 12V+ Wire: Gray
Radio Ground Wire: Brown
Radio Illumination Wire: Green
Radio Dimmer Wire: N/A
Radio Antenna Trigger Wire: N/A
Radio Amp Trigger Wire: N/A
Front Speakers Size: 4′
Front Speakers Location: Dash
Left Front Speaker Wire (+): Pink
Left Front Speaker Wire (-): Purple
Right Front Speaker Wire (+): Purple
Right Front Speaker Wire (-): Light Green
Rear Speakers Size: 4′
Rear Speakers Location: Rear Deck
Left Rear Speaker Wire (+): Black
Left Rear Speaker Wire (-): Yellow
Right Rear Speaker Wire (+): Red
Right Rear Speaker Wire (-): White
-->

Dec 19, 2008 | 1990 Toyota Corolla

1 Answer

2002 CHEVY BLAZER


Can purchased an adapter kit at Best Buy or Circuit City that is color cordinated with the factory wires for about 12.00. This will go right into the factory plug.

Radio 12v orange + radio harness
Radio Ground black - radio harness
Radio Ignition dk. green + radio harness
Radio Illumination gray (dimmer) + radio harness
Factory Amp Turn-on N/A
Power Antenna N/A
LF Speaker +/- tan - gray +,- radio harness
RF Speaker +/- lt. green - dk. green +,- radio harness
LR Speaker +/- brown - yellow +,- radio harness
RR Speaker +/- dk. blue - lt. blue +,- radio harness
Immobilizer Bypass Module: Required: Yes Type: Passlock 2 Part #: 457G, 555L, or 555T
Notes: The Passlock 2 wire colors are yellow, orange/black, and red/white (not used).

Sep 21, 2008 | 2002 Chevrolet Blazer

Not finding what you are looking for?
1991 Buick LeSabre Logo

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...