Question about 1984 Ford F 150

1 Answer

Runs smooth but has no power and diesels when you shut it down.has new rebuilt carb, new plugs and wires.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Have you looked at your muffler some times when your muffler is plugged you will lose power runs smooth but has no power and diesels when you - badmachanic.jpeg

Posted on Jan 29, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

86 4.3 4BC 1500 Chevy Die rolling up to light Started up and ch of fuel and it died 3 times now no start smell fuel and quit yellow spark Have replaced cap rotor plugs wires EGR coil ECM Rebuilt carb


It sounds more like a fuel problem to me then a bad coil or spark ign the spark should be blue but its hard to see in daylight
You say you rebuilt the carb are you sure your main mixture jets are at least 2 to 3 turns out off the stops .
Try pouring fuel down the barrel fill the float bowl if it runs then dies its fuel don't let it catch unfire you should have 45 sec. of run time then adjust the the mixture screws 2 turns is base but when its is running good turn them in 1 at a time and give it 30 sec. to adjust until it starts to stumble then back it out a 1/4 two 1/2 turn then repeat on bank 2

Nov 23, 2016 | Chevrolet Cars & Trucks

1 Answer

Erractic timing


did you check the plug wires are in the correct position ,and with the distributor if they are misplaced it 'll sound like erratic timing harbor tools have worked for me.

Apr 21, 2014 | 1987 Dodge Dakota

1 Answer

Runs rough all speeds rebuilt carb, new points plugs and plug wires distributor cap new


ill tuned carb, points gap (dwell angle) set incorrectly, bad coil?

Sep 06, 2013 | Cars & Trucks

1 Answer

Ford ranger not pumping diesel after engine rebuild


check fuses and wiring to pump shut off silonoid on the pump. run a jumper wire to the pump from battery if it runs then check the relay and fuses

Feb 19, 2013 | Cars & Trucks

1 Answer

How do I shut down EGR system on 1986 toyota 22r 4x4 truck


I am original owner of 1986Toyota Pickup 2wd caRB. 4SP MAN. SHORT BASE MFG.IN JAPAN. I NEVER HAD ANY PROBLEMS WITH ANYTHING UNDER THE HOOD OR IDLE OR ACELLERATION. iT RUNS JUST LIKE THE DAY i BOUGHT IT IN oCT. 1986. i NEVER ADJUSTED CARB OR CHOKE OR CLEANED IT iT HAS ALL ORIGNIAL PARTS EXCEPTTHE STARTER, BATTERY AND WATER PUMP GASKET.

May 25, 2012 | Toyota Cars & Trucks

1 Answer

Spark plug # 1 ONLY fouls out after a few minutes of running compression o.k., timing o.k.,leak down test good, all new parts except springs and heads, different plugs,wires,distributor cap,rotor coil...


Try and find, first of all, a hotter plug. Second of all, I'd watch your dipstick very close. Add a hotter (210F) thermostat, get it hot quicker. Finally, if all else fails, you may need to put on new valve guides, or check your rings.

Dec 18, 2010 | 1992 Chevrolet K1500

1 Answer

Same problem in my Golf 3, 1.4 petrol, 1993


carb?? electric pump ¿¿ something not right here or you havent got a carb and you just cleaned the mono point injection ,if its monopoint injection then take the little box thingy off the right hand side of the (carb) as you call it and inside is a carbon track path ...check it ,this will cause the pulse in the gas pedal as for the alarm ,sounds like a weekend mechanic boy racer thing ,best advice here is to cut it right out out and put it on the garage shelf where it belongs to collect dust

Aug 08, 2009 | 1999 Volkswagen Golf

1 Answer

1998 chvy 1500 loses power


check the intake gaskets. in the middle front and middle rear. If they are oily, it more than likely sucked part of the gasket in. When it warms up the leak gets bigger. The easy way to check is to get some carb cleaner and spray all around the intake while idling and warm. DO NOT SPRAY ANY EXHAUST PARTS , carb cleaner is combustible. The truck should stumble or even shut off when spraying with the carb cleaner if there is a leak.

May 03, 2009 | 1998 Chevrolet K1500

1 Answer

1997 Mazda dies when warm - runs smooth when cool


possibly a bad module------cracked---or???? In any case you may get expansion as engine compartment warms up----module shuts you down. Sometimes really hard to diagnose and just putting in a new module is "spendy"----especially if it turns out not to solve the problem!

Apr 21, 2009 | 2001 Mazda MX-5 Miata

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...