Question about 1999 Isuzu Rodeo

1 Answer

Where is the oil pan located; I can see the oil filter

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 45 Answers

At the bottom of the engine block

Posted on Jan 01, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replacing oil pan gasket 1998 chevy silverado 305 cu.in.


REMOVAL PROCEDURE
  1. Remove the oil level indicator tube.
  2. Raise the vehicle.
  3. Remove the engine oil and the engine oil filter.
  4. Remove the oil filter adapter.
  5. Remove the starter.
  6. Remove the flywheel inspection cover.
  7. Remove the engine mount through bolts.
  8. Raise and support the engine.




  1. Remove the oil pan nuts and bolts. Note the location of any studs to assist reassembly.
  2. Remove the engine oil pan and the gasket.
  3. Clean all sealing surfaces. Refer to Oil Pan Clean and Inspect under Engine Unit Repair.
INSTALLATION PROCEDURE


  1. Install the engine oil pan and a NEW gasket. Refer to Oil Pan Installation under Engine Unit Repair.
  2. Lower the engine onto the mounts.
  3. Install the engine mount through-bolts.
  4. Install the starter.
  5. Install the flywheel inspection cover.
  6. Install the engine oil filter and the engine oil.
  7. Install the oil filter adapter.
  8. Install the oil level indicator tube.

May 04, 2015 | 1998 Chevrolet Chevrolet silverado

1 Answer

How do you change the oil on a 2011 sonata?


Changing the oil in a Hyundai Sonata is an easy task that should be performed every 3,000 miles. Follo the below steps to change the oil on your Hyundai Sonata:
1) Ensure the car is parked on a flat surface. Place a drain pan under the engine. Locate the oil pan directly under the engine. The oil pan will be at the very bottom. Now, unscrew the drain plug at the front of the oil pan with a socket wrench. Allow all the oil to drain out into the oil pan. Tighten the drain plug back into the oil pan with a socket wrench.
2) Locate the oil filter in front of the engine. There will be a cut-out in the protective shield where the oil filter is located. Unscrew the oil filter with a strap wrench. Allow the oil to drain into the oil pan. Place the old filter in with the waste oil.
3) Fill the oil filter with fresh engine oil. Screw the filter on to the filter housing by hand. Do not wrench tighten, which could strip the threads of the filter or filter housing. Open the hood for access to the engine compartment. Unscrew the oil cap on the top of the engine.
4) Pour in three quarts of engine oil. Pull the engine oil dipstick out of the dipstick tube and wipe it clean. Push the dipstick back into the dipstick tube. Pull back out and look at the engine oil level. If the oil on the dipstick does not stop between the two marks on the dipstick, pour in a half quart of oil and check the level again. Do not overfill.
5) Start the car and allow it to run for few minutes. Turn the car off and check the oil level once again. Add another half quart of oil if necessary. Ensure the oil cap is back on the engine and the hood is closed. Hope this helps and if you need any parts for your sonata, this site looks like it has cheap prices, free shipping and great reviews http://www.buyautoparts.com/carmodels/Hyundai/Sonata.html

Jun 13, 2013 | Cars & Trucks

1 Answer

Where is transmission filter located in 2001 mitsubishi diamante located and how do i change it?


transmission filter in the bottom of transmission bolted to valve body.you need a large drain pan.place drain plug under transmission oil pan.remove transmission oil pan drain plug.let all transmission fluid drain out then screw back drain plug in oil pan.then you need to remove transmission oil pan then remove filter and replace pan gasket also.make sure you have right amount transmission fluid on hand.buy extra because if you short of fluid you cant drive car if fluid level too low.make sure you get the right amount fluid.torque pan bolts to 96 inch pounds.

Nov 10, 2011 | 2001 Mitsubishi Diamante

1 Answer

My car is leaking oil. i dont know if its the oil pan or the oil filter came loose? need to know where the oil filters located.


if it leaves small spots the chances are its the pan gasket but the oil filter should be located up in front of the engine on the right hand side... depending on the size of motor

Mar 13, 2011 | Mitsubishi Lancer Cars & Trucks

1 Answer

Where's the oil filter located at?


That has a canister style fuel filter. The cap is located right next to the oil pan on the passenger rear corner roughly of the oil pan. It will be black and made out of plastic. You will need a filter cup to remove the cap. Once the cap is removed you will be able to replace the oil filter.

Oct 03, 2010 | 2001 Oldsmobile Intrigue

2 Answers

Where is the oil pan drain plug on a 2005 sunfire


A 2003-05 Sunfire most likely has the Ecotec 2.2 motor. The filter is a cartridge element type which is located on the forward side of the engine on the drivers side; (below and slightly left of the power steering reservoir).

The oil filter is located under (inside) a black cover about 3-4 inches around and has a large hex head nut molded on top of it, to fit a socket on it. When replacing the oil filter element, press the tipped O-ring side of the filter down into the filter cavity until it locks in place. Then place the cover on top and tighten it.

The cover will automatically lock onto the top section of the oil element as it is being tightened. The drain plug is pretty standard and on the oil pan. However, most people are accustomed to a metal oil pan, and when viewing the Ecotec motor they confuse the metal TRANSMISSION pan as the motor oil pan.

The motor oil pan is actually aluminum, and looks like a continuation of the upper motor. For that reason, you don't "see" an oil pan. Knowing this fact, the oil drain plug is now easy to locate. Look at the far passenger side of the metal transmission oil pan. Now look at the very front of that section of the transmission oil pan and follow that ''line of sight'' until you reach the bottom of the aluminum motor (''oil pan''). The oil drain plug is right there, with it's head facing towards the transmission oil pan.

The drain plug (on a 2005 Sunfire) requires a 15mm wrench/socket; and has a built in rubber seal, which should be lubricated with oil before tightening.

Sep 18, 2010 | 2005 Pontiac Sunfire

1 Answer

Oil pump ,,,where is the oil pump located on a 1997 dodge caravan


Hello
Welcome!
Oil pump is located on the oil pan.
Parts needed,,,oil,,,, oil filter,,,, oil pan gasket,,, oil pump,,,, oil pump pickup tube..
time to do this,, about 3 hours
Instructions,
Raise van place on 2 jack stands
drain oil remove oil filter fill new filter install.
remove bolts from oil pan,
remove oil pan..
remove 2 bolts that hold oil pump and tube.

install new pump and tube tork bolts to 45 fp
replace oil pan gasket and install oil pan
tork pan bolts to 35" pounds
install drain plug
fill with oil
start and check for leaks

let me know if i can help more

Jul 17, 2010 | 1997 Dodge Caravan

1 Answer

Can't locate reserve oil drain plug on 1994 Ford E350


It only has 1 oil pan which is call a dual resreve. One oil plug is a the bottom of the pan the other is at the front of the oil pan. Look at the front of the oil pan for the other drain plug. Make sure on how many quarts of oil it takes. ( I know 5.0 take 5 quarts including oil filter. But then again its a van double check)

Mar 22, 2009 | 2002 Ford E350

5 Answers

Cannot locate transmission filter or instructions to replace


ok, here's the deal. there are 2 types of transmissions one with an external oil filter( kinda looks like the oil filter for the engine) and then there is the other type of transmission that was produced later on the 4 cylinder engines that doesnt have a removable filter. it does have a screen that is not servicable, it can only be replaced during the rebuild of the transmission. this design is supposed to be "back flushed" to remove all debris. Most good transmission shops have this type of system that pressureizes the system and does this.

If your gonna do this on your own, what you will need to do is buy 4-5 quarts of transmission fluid, drain the oil from the pan on the front of the engine, reinstall it, add the fluid, drive for 30 min, and then repeat the process.

Sep 01, 2008 | 2003 Mitsubishi Galant

Not finding what you are looking for?
1999 Isuzu Rodeo Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...