Question about 2000 Dodge Durango

1 Answer

Where is the drain to drain radiator for 2000 durango

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 45 Answers

The drain should be at the bottom of the rad close to a corner if all else fails take the bottom rad hose off but if your just draining it for a thermastat change just take it off up top and loose a little rather than a lot

Posted on Jan 01, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 Dodge Durango water passenger side a lot of water in floor board.

Does the water smell like coolant? Are you losing any coolant from your radiator/reservoir? If so, you have a heater core leaking. It's a large job to replace, requiring removal of the dash.
If it doesn't smell like coolant, it may be that the drain tube from your a/c evaporator is plugged, and condensation is leaking into the passenger compartment. Look for the drain tube on the engine side of the firewall, in front of the passenger and down low. It should be a rubber tube that has nothing connected to it.
Other possibilities are leaking sealant around the windshield, bad weatherstripping around the doors, and leaks from sunroof (if you have one).

Oct 25, 2016 | 2000 Dodge Durango

2 Answers

Where is the coolant drain plug in a 1999 dodge durango

remove the lower radiator hose it's safer than breaking the drain plug

make sure the engine is cooled off first

Sep 22, 2014 | 1999 Dodge Durango

1 Answer

How to change radiator 2000 dodge durango

It's actually pretty easy.
Here you go:
remove fan
remove fan shroud
open petcock and drain fluid (bottom corner of tank on engine side)
remove upper and lower hoses
remove tranny coolant lines
unbolt radiator and lift out. Reverse these steps to install the new one. Hope this helps.

Jul 15, 2014 | 2001 Dodge Durango

1 Answer

How to drain a radiator in a 98 Dodge Durango

At the bottom of the radiator you should find a drain T handel screw which is the drain port.........Hope this helps.

Nov 21, 2010 | 1998 Dodge Durango

1 Answer

Does a 2000 dodge durango have a bleeder valve for radiator

The drain valve is make of nylon/plastic.

It's not advisably to drain from this small opening.

The professional route is to let the coolant out at the lower radiator hose.

Dec 08, 2009 | 2000 Dodge Durango

1 Answer


have to go to radiator shop to even find a filler neck, then you would have to soilder it on the radiator. save your self a lot of trouble and headaches, just repalce the radiator, good luck.

Oct 23, 2009 | 2000 Dodge Durango

2 Answers

Can't find drain plug 2002 durango

you mean a 4.7 right 2003 was the first availible hemi 5.7. the drain plug on the 4.7 is on either the right or left bottom part of the rad. you will see a plastic tap on the radiator. to it counter clockwise u many need pliers to do the they sometimes stick. turn it one ful turn but don't completly remove it though. this will allow the coolant to drain slowly without making a mess by removing the lower rad hose. I hope this helps.

Jul 08, 2009 | 2000 Dodge Durango

3 Answers

Cannot drain radiator in my 2003 dodge durango to flush system

I'm guessing that you do not have a radiator drain plug. It would be located on the bottom of the radiator. If not the next best solution is to disconnect the lower radiator hose. You will only need to loosen the clamp, and slide the hose off the radiator. Don't forget to have something to use to collect the fluid. Keep it off until you are ready to refill. Hope this helps

May 10, 2009 | 2003 Dodge Durango

1 Answer


make sure engine is cool then drain coolant by opening the drain plug at bottom of radiator. remove cap from radiator so coolant will continue to drain and when coolant is down enough to pull off upper radiator hose at intake then close drain, then remove two bolts at coolant housing and remove thermostate. clean gasket material from intake and housing and replace with new gasket and thermostate tighten bolts install hose fill rad with coolant water mix 50/50 and run engine with heat on floor until gets hot and you see coolant flowing in rad, install cap

Jan 17, 2009 | 2001 Dodge Durango

Not finding what you are looking for?
2000 Dodge Durango Logo

Related Topics:

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides