Question about Chevrolet TrailBlazer

1 Answer

Electric window will not go up or down. How do I get into the door to check problem?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 376 Answers

There several screws around the outside of the older cars, and all the new ones have push in and out pins, with a large main screw near the grab handle. remove these and it should pop off, then un plug all connections and set aside. you will need a couple jumper wires and a test light. locate the motor, and unplug the harness, then jump power and ground to the correct terminals. if the motor is just weak, or in a bind this should make the motor operate a little. if it is a bad motor then it wont do anything at all whem power is applied.
good luck

Posted on Jan 01, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 impala back window stuck down


You checked fuses and relays for electrical cranked window?
Remove: internal door handle, remove window crank if manual crank, door panel, remove film/paper seal.
If is mechanical crank: check for worn out parts on gearing and racks (reinstall crank and wind window up and down). Replace worn parts.

If electrical window crank: check for power at solenoid. Try switch again and watch to see if solenoid engages and tries to crank.
Check to see if switch is broken. Try door switch and drivers door switch.
Pickup another solenoid and replace old one.

Apr 30, 2014 | Cars & Trucks

1 Answer

Power window switches on driver door do not operate


can you hear relay clicking in door handle switch assembly when pressing if yes but windows still dont go up or down its probably the electric motor, remove door trim and check for power on one of the electric motor wires when pressing the switch up and then down if power there replace motor, the relays and reverse polarity is done in the switch assembly, if no power at motor and relay switch clicks replace switch assembly

Sep 22, 2013 | 2004 Isuzu Rodeo

1 Answer

How do I pull door panel 89 regal


If you have an electric window and it is sliding up and down, there is no need to pull the door panel to "check" it. The cables are broken. It needs a window regulator.

Instructions for window regulator replacement can be found at alldatadiy.com

Apr 14, 2012 | 1989 Buick Regal

1 Answer

Windoes wont go down and it seas drivers door open when it is closed


Sounds like the electrical connections inside the door are bad, dirty or have come adrift.

1) Check all fuses are good.
2) Check micro switches & Connectors in the door.
3) Remove inside door panel, check connectors to electric window motors.

Dec 09, 2010 | 2004 Jeep Grand Cherokee

2 Answers

My drivers side window goes down when i start it.


ok, this sounds like either a faulty window switch from getting wet when it got rained on or a short in the wiring between drivers door and frame.

My guess that the wiring between the drivers door opening and frame---from opening and closing door---could have pinched or rubbed between door and frame causing it to ground out when starting the car making window switch go crazy-----even if replaced with new window switch wont solve this problem.

Check the wiring comming out of drivers door going to hole in frame toward under the dashboard and see if there is any pinched or rubbed through wiring there---move wires to avoid pinching and rubbing and tape with black electrical tape.

Alot of vehichles with electric door locks and windows had this problem.

Some vehichles are so bad that windows go up and down while driving and door locks locking and unlocking too----Just like a "Devil" posessed vehichle----lol


Jan 23, 2010 | 2002 Buick Regal

1 Answer

Electric Window on a 1999 monte carlo is in the down position and wedged in the bottom of the door. Window motor drove window down but will not drive upward. Can I drill off the 3 rivets holding the motor...


can you place a thin screwdriver down through the top of door, between the DOOR GLASS and OUTER door panel. If you can, try to raise glss electrically SLOWLY guiding it past the the binding edge. Door glass will need alignment to perrmantly repair

Apr 05, 2009 | 1999 Chevrolet Monte Carlo

3 Answers

Hey when i push the power botton for the rear window it doesn't go down,I checked the power button,and its good ! Can i replace the power motor in the rear window,and where is it located,i would like to...


  1. Raise and support the rear door window glass to the full up position.
  2. Remove the interior door handle.
  3. Remove the rear door speaker.
  4. Remove the water shield.
  5. Disconnect the rear door window regulator motor electrical connector.
  6. Remove the rear door window regulator rivets.
  7. Remove the rear door window regulator by sliding the regulator arms off of the window glass track.
  8. Installation is the reverse of the removal procedure, noting the following:
    • Cycle the door glass to make sure of engagement of the drive mechanism.
    • Remove the rear door window glass-to-regulator bolt or rivet.
    • Position the rear door window glass as necessary to access the rear door window glass-to-regulator rivet.
    • Secure the rear door window glass in the full UP position with tape.
    • Disconnect the window regulator motor electrical connector.
    • Remove the 2 window regulator nuts.
    • Remove the 3 window regulator motor bracket nuts.
    • Install the window regulator assembly. Tighten the 3 motor bracket nuts to 89 inch lbs. (10 Nm).
    • Install the 2 window regulator nuts. Tighten the nuts to 89 inch lbs. (10 Nm).
    • Connect the window regulator motor electrical connector.
    • Remove the tape securing the rear door window glass in the full UP position.
    • Position the rear door window glass as necessary to access the rear door window glass-to-regulator rivet. Tighten the bolt to 62 inch lbs. (7 Nm), or install a new rivet.
    • Install the window regulator motor
    • Remove the window regulator assembly.
Remove the window regulator motor

Feb 23, 2009 | 2001 Ford Explorer

1 Answer

FRONT DOOR WINDOW


Yes. I have fixed my driver side window several times. The window went all the way down and came off the track, usually because the window automatically went all the way down. The first step was to take the interior side of the door off: (1) I unscrewed the screws around the door and pull the plastic screws out. (2) I disconnected the thin metal rod that connects the door handle to the door frame to be able to pull the interior part of the door away from the metal frame of the door. (3) I unscrewed the speaker to see where the window meets the rubber track. (4) I kept the electrical wires connected so that I could use the electric window button to lower and raise the window. (5) I lowered the window down below the rubber track and loosened the screw holding the rubber track to the door. (6) I manually adjusted the rubber track around the window glass and pressed the electric window button up slowly, making sure the glass stayed on the track. (7) I put everything back in place, screwed in the screws, etc. Be careful not to let the window go all the way down, because it seems to fall off the track at that point. Hope this helps!

Nov 08, 2008 | 1992 Honda Accord

1 Answer

Electrical System in 2000 Chevy Silverado Truck


Should be no power to the window with the key off. check that out.
Pull the fuse for the power windows. If it still goes down look elsewhere.
Check the voltage on your charge system. 14plus engine running. Not! Have it fixed. Bad Diode would be my choice.
ps: Power window actuators a cheap these days 80 - 99 bucks.

Jul 13, 2008 | 2000 Chevrolet Silverado

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...