Question about 1997 Chevrolet S-10 Pickup

1 Answer

97 s-10 turns over, but won't start

Gages bounced all over; it stalled; re-started; stalled; turned over and started about every tird time; ran for about 15 min. fine; pulled into driveway & it stalled; did the start every third time thing for awhile, now won't start at all & when I turn the switch to run the gages do nothing & I have no warning lights. I put a used ecm in it (but I didn't have it programed) just to see if it would do anything. I didn't

Posted by on

  • jaydea Jul 09, 2008

    ignition switch wire harness

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

Yeah that definitely sounds like the ignition switch went out. Had almost the same thing happen, along with alot of transmission error codes. I replaced the ignition switch harness and she purred like a kitten.

Posted on Aug 07, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

'01 lhs stalled and wont start, very fast clicking, battery is ok.


Can you turn the crank by hand ? Did the timing belt break ?

Mar 09, 2014 | Chrysler LHS Cars & Trucks

1 Answer

Runs rough dies


change the fuel filter and check the fuel pressure

May 25, 2013 | Ford Expedition Cars & Trucks

1 Answer

Truck won't start when hot


Check fuel pressure with a gauge

Sounds like the pump is going bad & stops
mechanically or electrically

You don't need codes to have cylinder misfires,bad
egr valve or O2 Sensors with over 100,000 miles

Nov 20, 2012 | Cars & Trucks

1 Answer

Car won't start. Gages bounce quickly & make a clicking sound on 2006 ford taurus


check your battery,or not clean battery terminals,or starter motor solenoid.

Aug 22, 2012 | 1993 Cadillac DeVille

1 Answer

My 2004 would cut off at idle,but start again after a min or so. But time it ran and cut off after a mile. Now it won't start at all. Won't turn over. It will move somewhat when I turned it by


No.
The crank sensor tells the computer when number one cylinder is at top dead center to find the timing for the spark plugs.
If the engine will not crank with the starter, the starter, key switch, battery or cables could be faulty.
Some of these items could also cause it not to start.
If the engine is stuck you won't be able to turn it at all.

Jun 28, 2012 | 2004 Jeep Grand Cherokee

1 Answer

Won't turn over. The instrument cluster won't work


ok iif the instrument cluster does not work.. before i give a solution can you tell me if it have atach and temp gage not a temp gage witha idiot light but a actual temp gage.. because if temp gage and fule gage hands are not in their proper place like if yo uhave a 1/4 tank of gas and it reads way past full and the temp gage is gone out of site way past say 240 degrees then it is your speedo head .. have this trouble the other day on a chevy 2002 cavalier.. replaced the head and wahla the car started. it seems the speedo head is tied in with the computer system on these cars.. and if the tach is not working you need not worry if you cannot find a head with a built in tach.. a normal speedo head with out the tach part will also work.. just when you change the head count the pins on the old one and compare it to the new one if they match then just plug it in and car should start..

May 13, 2012 | 2002 Pontiac Sunfire

2 Answers

Fuel gage jumping around and truck stalling out


go to the battery follow the cable that dose not go to the starter the other cable will go to hard piont that is the feed for the fuse box check that connection

Jan 23, 2009 | 1997 GMC Jimmy

1 Answer

Gas Gauge


hello,
the problem could be in the sending unit. this is a wired potentiometer and if you have a broken wire in the potentiometer, then that is what would happen.

you can verify this by grounding the sending unit wire to ground. you will have a full tank reading always. then use the car and see if it will still bounce and very erratic. if does not do that, then the sending unit is the problem. if it still do the erratic reading, then there are more problems.

Dec 11, 2008 | 2004 Saab 9-3

3 Answers

98 blazer stalls


It could be your fuel pressure regulator, check this link for details:

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528022b9c4

8e44b4b.jpg That's what it looks like.

Aug 09, 2008 | 2000 Chevrolet Blazer

Not finding what you are looking for?
1997 Chevrolet S-10 Pickup Logo

Related Topics:

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

63990 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...