Question about 2002 Toyota Sequoia

1 Answer

Antena does not raise: 2002 Sequoia limited

Is there a seperate fuse for the antena motor? the radio turns on, but antenea does not raise or lower. Does not make a sound either, and cannot be manually raised or lowered.

Please advise.


Posted by on

  • Anonymous Feb 21, 2009

    I have the same problem, but the antena motor sounds



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 958 Answers

I think at the back of the radio is a blue with white stripe wire that could be labeled power antenna. test it if it has a 12 v positive as you turn the radio on. if there is, then the problem is in the antenna. if there is none then the problem is in the radio. there could be a fuse at the wire as it comes out of the radio to the antenna.

i hope i was able to solve your problem. please rate me. tnx. drcool299

Posted on Jul 09, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Rear antenna

Start by checkingthe fuse for the antena then the antena itself for motor functionality and stickiness.

Jul 08, 2013 | 1994 Toyota Camry

1 Answer

Where is the switch located to raise and lower the antena?

There is no power antenna switch. It is lowered and raised automatically when you turn the radio on and off. If it doesn't raise or lower itself, either the fuse is blown or the antenna motor or mast is bad and needs replacing.

Jan 15, 2011 | 1992 Jeep Cherokee Limited

1 Answer

Power antena after markit how to make it work with radio

on the radio there is a cable that is for Power Antena you might have to set a cable out to the area you are instslling the antena if this car already had a power antena you only need to hook up the leds from the old if not then like i said you need to get positive cable out to the antena and ground it to chassis

Apr 01, 2010 | 2000 Mercury Sable

1 Answer

How do i put the radio code in my 96 grand cherokee jeep

Jeep grand cherokee ltd, 1996 The radio is not working, when I switch the power on the antena motor makes a noise although the antena is always up, there is no sound from the radio what so ever, it says WAIT 2 1/2 hours but nothing happens, no tape radio cd, switch the radio off the antena makes a noise then the radio switches off.

Mar 14, 2010 | 1996 Jeep Grand Cherokee

1 Answer

I have a '98 4Runner and I want to disconnect the power antenna.

turn on the stereo so the antena will come up and where the antena goes in to the fender u will have to go under the hood and look through one of the holes in the inner fender to see the antena motor or u can take the plastic inner fender off from inside of the wheel well to get to antena motor then when u can get to the motor u will see a black fairley large wire wich is the antena wire it self and u should see one more small wire just unplug small wire or clip with wire cutters and tape the ends off with electricle tape as so it wont arc out any where

Aug 12, 2009 | 1995 Toyota 4Runner

1 Answer

1985 ZX300 power antena problem. When the radio is turned on the antena goes down and when it is shut off the antena goes up. Al factory parts, radio, antena and all switches. Any ideas what would cause...

im guessing the antenna has been replaced and wires were mixed up. take the rear panel off in the trunk to give access to the antenna motor and look at the wiring there should be 2 small wires and one larger black wire. the black wire is the reception wire the other two are the power wires. switch the positions on the two power wires. say wire A is in plug 1 and wire B is in plug 2. final position should be A in 2 and B in 1. that should take care of it. good luck

Jul 08, 2009 | 1985 Nissan 300ZX

1 Answer

No sound on radio

The car also has amplifiers. Check all the fuses besides the radio. That might fix your issue.

Mar 12, 2009 | 1996 Eagle Vision

1 Answer

Power antena runs but doesnt move stereo doesnt light up

likely two seperate problems: the display inside the radio is one, (is it digital?) if not, you can take the bulb out and replace it. Second is the antenna mast: There is a nylon "cord" inside the mast that connects to a spool in the motor...for some reason it has become disconnected from the spool or the spool driving gear has failed.Sometimes if you take it apart, you can fix it but in most cases it's easier to just replace it.

Jan 29, 2009 | 1995 Jeep Cherokee

1 Answer

Installing a after market stereo

most of time the antena power is blue coming from radio, locate the one in the car going to antena and conect the blue antena wire to it

Jun 19, 2008 | 1990 Mercedes-Benz 300 Diesel

Not finding what you are looking for?
2002 Toyota Sequoia Logo

Related Topics:

679 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides