Question about Pontiac LeMans

1 Answer

REPLACING MOTOR MOUNTS IN A 1966 PONTIAC LEMANS WITH A V8

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 330 Answers

1. GET THE RIGHT RUBBER MOTOR MOUNTS,

2.FIND THE MOTOR MOUNTS LOCATED UNDER YOUR ENGINE. MAYBE THREE. FRONT LEFT, RIGHT AND MIDDLE BEHIND,

3.JACK UP THE ENGINE A LITTLE BIT, PUT MOTOR MOUNT IN AND USE THE SAME SCREW TO TIGHT IT

4. CHANGE ONE AT A TIME.

5. STABLE YOUR CAR, BE SURE IT IS COMPLETELY SAFE, USE EMERGENCY BREAK AND A BLOCK TO STABLE THE CAR UNLEASE YOU HAVE HOIST.

Posted on Jul 08, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace a shift lever for a 1966 lemans


I think you mean the column shift lever which is replaced by tapping out the pivot pin from under the base of the shifter. It is a chrome colored pin and will only come out if you tap it LIGHTLY from the bottom.

Apr 12, 2015 | Pontiac LeMans Cars & Trucks

1 Answer

I bought a 1992 Pontiac Lemans and I need to know how to set the timing.


Hi Donald.

The timing belt replacement instructions for 1992 Pontiac Lemans have been uploaded here (click on the link to open).

Regards.

Ginko

Oct 23, 2011 | Cars & Trucks

2 Answers

Own 1983 buick regal, 3.8 L v6- want to install a 350 smallblock.Is this feasible? The 3.8 is a lemon, and it's very difficult to get parts for the motor.


Depends on which 3.8 you have because there were two avaliable in that car .One was the buick 231 cubic in and the distributor was on the fron of the engine.The other was the chevy 229 cubic inch engine and the distibutor was in the back just like on the small block v8.If you have the buick motor be prepared to swap everything including wiring harness and transmission.If you have the chevy v6 it not so bad but you will really need a donor car(monte carlo,cutlas,lemans)with a 305 or 350 for the wiring harness ,radiator shroud ( shorter on the v8) ,a/c lines (longer on the v8).Years ago I had a lemans wagon with the chevy 3.8 that i put a Monte Carlo ss motor in and it looked like it came with it.bought a wrecked mc( hit in the rear) and swapped everything.Including coil springs and sway bars front and rear.And yes the SS 15 inch wheels too! It was a real cool sleeper.Miss that car.

Mar 16, 2011 | Buick Regal Cars & Trucks

1 Answer

Where is the cooling fan relay located on a 1989 Pontiac Lemans?


fan relay is mounted on the fuse box under the dash on the drivers side

Jul 08, 2010 | 1989 Pontiac LeMans

2 Answers

There's a knocking sound when I turn and also when I accelerate. Just replaced timing belt and aferwards the noise began.


Sounds like your cv joint mat be bad, is there grease being slung by your drive shafts ?

Feb 04, 2010 | 1993 Pontiac LeMans

1 Answer

Torque settings for 390 v8 heads


the ford fe motor 390 heads should be torque to 90 foot pounds

Nov 11, 2009 | Ford Thunderbird Cars & Trucks

1 Answer

Specs on torquing head bolts on 1988 pontiac lemans aka daewoo lemans aka passport optima. also do i need gasket sealer anywhere or gaskets only when doing a head job on this car?


firstly tighten in sequence to 20Nm all round, then tighten to 30Nm all round,then tighten 90 degrees all round, and finally tighten a further 90 degrees all round. if you taken head off you should replace gasket or just use gasket sealer if you cant replace, just replace the head bolts, dont reuse or they may break

Jul 24, 2009 | 1988 Pontiac LeMans

1 Answer

Throwing gas from unknown part


If it looks like this it is the fuel pump,If not post a picture.
0829fc0.jpg

Please rate this a fixya

May 21, 2009 | 1988 Pontiac LeMans

2 Answers

I need to know where number one cylnder is on a 88 lamans 4 cylnder motor


i didn't even realize 1988 lemans used a 4 cylinder . but here it is .


d8e1f99.jpg

Jan 17, 2009 | 1988 Pontiac LeMans

2 Answers

Fuse layouts


need a pontiac lemans fuse box diagram and relay diagram

Jul 03, 2008 | 1992 Pontiac LeMans

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

336 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...