Question about 1985 Ford Thunderbird

Open Question

1985 ford thunderbird elan, I need advice how-to for replacement of heater blower motor control module

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Scorpedo
  • 111 Answers

SOURCE: ignition control module location for 1997 ford thunderbird?

It should be right on the side of the distributor, a small ( usually grey ) plastic type box with 4 connections on one end if i remember right.

Posted on Dec 12, 2008

Ad
chrischronic
  • 235 Answers

SOURCE: Blower fan runs high only on 2006 Ford Explorer

if you have manual control climate control then the system has a blower motor resistor . if you have automatic climate control then the system has a blower motor speed control. in eather case the part is under the dash in the heater box. depending on the system you have, buy the part and then look under the dash for like part, you will half to remove the under dash panels to be able to see. the part will be on the heater box somewhare.

Posted on Jan 22, 2009

  • 7 Answers

SOURCE: AC blower motor switch inop

You may have a vacuum line disconnected. check your engine and listen for the hissing of the vacuum line.

Posted on May 29, 2009

mkv0525
  • 358 Answers

SOURCE: heat/ac blower motor

ce the resister for blower motor.

Posted on Jun 05, 2009

wilsodfarm
  • 986 Answers

SOURCE: blower motor stuck on high! 2001 town &country

your blower resister is bad and you need to replace it.......heres how,The glove box can be lowered all the way out of the way just by pulling in the sides so the rubber stoppers come out toward you. The sides bend easily to allow that.

The glove box being out reveals the resistor in the heating duct right in front of you. Just remove the two sets of wires and two bolts (10mm socket, I think) and the resistor pack slides right out. Then bolt in the new one an plug the wires back in (they only fit in one way). Fold the glove box back up and press the stops in to get them back in place and you are done.

The resistor pack only cost $12 and change at my dealer. It is part number 1-04885583AB which was a replacement for the same number with AA at the end, so I’m guessing they had a lot of trouble with the AAs and so made a better AB.

Last Winter my heater blower fan worked only on High. I changed the front heater/AC blower resistor pack and was surprised at how easy it is, but I had to figure it out for myself since my Dealer's parts guy was no help as to where the part lived and my Haynes manual was just plain wrong. This was on a 2001 T+C. I'd be very surprised if the 2001 Caravan was any different. Don't know what other year vans would be the same. I do know some earlier generations had this resistor under the hood and Haynes had is with the blower sort of behind the instrument cluster.

Posted on Jan 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Heater fan runs when heater is off.06 ford expoler


Automatic or manual climate control ?
  • The blower motor does not operate correctly - manual climate control
  • Circuitry short
  • A/C blower motor resistor
  • A/C blower motor switch
  • Blower motor high speed relay
  • Go To Pinpoint Test O .

  • The blower motor does not operate correctly - EATC
  • Circuitry short/open
  • A/C blower motor speed control
  • EATC module
  • Go To Pinpoint Test Q .

Pinpoint Test Q: The Blower Motor Does Not Operate Correctly - EATC
Normal Operation Under normal operation, the blower motor control module receives a 1-2 volt signal from the EATC module through circuit CH218 (GN/VT) to determine the desired blower motor speed. The EATC module receives a feedback voltage from the blower motor control module through circuit VH219 (GY) to determine actual blower motor speed. When the highest blower motor setting is selected, the EATC module sends 12 volts to the blower control module through circuit CH217 (BN).
    Possible Causes
  • An open, short to voltage, ground or together in circuits CH218 (GN/VT), VH219 (GY) or circuit CH217 (BN)
  • Blower motor control module
  • EATC module
  • If automatic HVAC system i would suspect Blower motor control module .

Oct 27, 2016 | 2006 Ford Explorer

1 Answer

Where is the power blower control 1995 ford thunderbird lx


Blower motor resister should be next to blower motor 2 screws and looks like a curcuit board with a spring
11_9_2017_4_00_02_am.jpg

Nov 09, 2017 | 1994 Ford Thunderbird

1 Answer

1995 Ford Thunderbird blower motor stays on


If yours is equipped with automatic climate control, check the blower motor resistor behind the glove box.

Jul 16, 2012 | 1995 Ford Thunderbird

1 Answer

1994 ford thunderbird no power at heater blower motor control module


I've had the same problem with my 1994 Cougar XR7. It wasn't the module control. It wasn't the fan. It was a bleepin' inline fuse; a 30. Changed the fuse and everything was working fine. That's after I had purchased a new fan motor and electronic control module. None of the book or web pages I have read mentioned that fuse, which for some reason, Ford didn't put in the fuse box with the others. So, check your inline fuse, it may be just that. And it is located past the fuse box under the dash. It'll be the same thing for the T-Bird.

Dec 04, 2011 | 1994 Ford Thunderbird

1 Answer

How to replace a blower motor in a 1996 ford thunderbird lx


Removal
  1. Remove the glove compartment liner to gain access to the heater blower motor and blower motor wheel assembly mounting screws.
  1. Use a small screwdriver to remove clip retaining hydraulic damper strut.
  1. Remove four screws and remove the heater blower motor assembly and blower motor wheel assembly from the heater blower motor housing.
Installation
  1. Using a new seal, position the heater blower motor and blower motor wheel assembly to the heater blower motor housing with the flat side of the flange near the heater blower motor switch resistor (18591). Install the four retaining screws.
  1. Tape the heater blower motor power lead to the air inlet duct to keep the wire away from the blower outlet during installation.
  1. Install the heater blower motor and blower motor wheel assembly in the vehicle.
  1. Install the glove compartment liner.

Oct 07, 2010 | 1996 Ford Thunderbird LX

2 Answers

1995 Ford Thunderbird v8 lx heater fan is slow


If it is slow,on all speeds,then the blower motor is most likely the problem,replace it.

Feb 25, 2010 | 1995 Ford Thunderbird

2 Answers

Blower motor resistor


The blower motor resistor is located near the blower motor. It is held in place by 2 screws, and has a wire clip connected to it. Very simple fix.

I hope this helps you, and I wish you luck on your repair.

May 01, 2009 | 1995 Ford Thunderbird

1 Answer

1994 thunderbird no heat


the blower motor resistor that's located in the plenum. has about 4 wires and is about 2" x 3"

Feb 24, 2009 | 1994 Ford Thunderbird

4 Answers

Blower motor problem


Replaced automatic Control module in dash and module at blower and the blower Still have no heat. Original problem was smoke for vents and no blower help...1994 thunderbird

Jun 13, 2008 | 1996 Ford Thunderbird LX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...