Question about Toyota Tacoma

1 Answer

Were is the fuel pump on 1999 toyota tacoma pre runner 4cyl.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 541 Answers

It is located in the fuel tank. about 3 and a half hour to replace

Posted on Dec 31, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 08 toyota Tacoma pre runner will be running fine one minute and then itts like it dies and will not fire back up until u pull off the rd. And turn ignition off and let it set and switch it on


Ur alternator might not be charging ur battery or the battery could have a dead cell thus preventing it from holding a charge. Also there could be a problem with ur fuel pump keep it the cylinders from getting the right amount of gas needed.

Oct 08, 2016 | Toyota Cars & Trucks

1 Answer

How to test a fuel pump relay in a 1999 toyota tacoma


Most relays have a diagram on the side showing the terminals by number.
You would take a test light or meter and check the terminals in the fuse box for power and ground. You should have two power wires, one ground from the computer, and the circuit to the pump. Keep in mind the computer grounds the relay for only 3 seconds if the engine does not start.

Sep 15, 2012 | 1999 Toyota Tacoma PreRunner

1 Answer

Need diagram for installation of a serpetine belt for 2005 Toyota Tacoma P/U 4.0. Please advise. Thanks


  1. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY NO.1 (4WD AND PRE RUNNER DRIVE TYPE)
    1. Remove the 4 bolts, then remove the under cover No.1.
    2. dak408_42.gif
  • REMOVE FAN AND GENERATOR V BELT
    1. While releasing the belt tension by turning the belt tensioner counterclockwise, remove the V-ribbed belt from the belt tensioner.
  1. INSPECT V-RIBBED BELT TENSIONER ASSEMBLY
    1. Check that nothing gets caught in the tensioner by turning it clockwise and counterclockwise. If a malfunction exists, replace the tensioner.
    2. dak408_43.gif
    3. INSTALL FAN AND GENERATOR V BELT
    1. While turning the belt tensioner counterclockwise, align with its holes, and then insert a bar of 6 mm (0.24 inch) into the holes to fix the belt tensioner.
    2. Install the V-ribbed belt.
    3. While turning the belt tensioner counterclockwise, remove the bar.
    4. dak408_44.gif
    1. If it is hard to install the V-ribbed belt, perform the following procedure.
(1) Put the V-ribbed belt on all parts except the P/S pump, as shown in the illustration. (2) While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the P/S pump.
  1. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY NO.1 (4WD AND PRE RUNNER DRIVE TYPE)
    1. Install the engine under cover with the 4 bolts. Torque: 29 Nm (296 kgf-cm, 21 ft. lbs.)

Nov 21, 2010 | 2005 Toyota Tacoma

1 Answer

How to change fuel pump on 1999 toyota tacoma pre runner


I started up my truck this morning and it sounded like there was a motorcycle next to me. It was making a loud roaring noise. What could this be??

Sep 22, 2010 | 1999 Toyota Tacoma PreRunner

1 Answer

Timing belt diagram the timing belt came off timing


Click on the following free, direct Link. I realize the Link has "4 Runner, but the 4-Runner and PreRunner have the exact same Engines (2.7L & 3.4L).
The Link has the Timing Belt Diagrams for your 1999 Toyota PreRunner for either the 2.7L DOHC In-Line 4-Cylinder or 3.4L DOHC V6 Engines; including Marks and Instructional Diagrams.

Let me know if this helped...


http://www.2carpros.com/car_repair_information/year/1999/make/toyota/model/4runner/1999_toyota_4runner_timing_belt_diagram_marks.htm

Apr 12, 2010 | 1999 Toyota Tacoma PreRunner

2 Answers

1998 Tacoma V6 (Pre-runner) dies when key is released


I BELIEVE they have A BALLAST RESISTOR Close to the COIL that Will Cause this if they FAIL

Aug 12, 2009 | 1998 Toyota Tacoma

1 Answer

Tacoma 4cyl idles rough, heditates, multiple misfires


Possible fuel delivery problem, fuel pump, fuel line, clogged fuel filter, leaking injectors or injector O-rings, faulty pressure regulator etc. Check your fuel pressure.

Jun 20, 2009 | 1998 Toyota Tacoma

2 Answers

1999 toyota tacoma Sr5 won't start


Check for fuel pressure when starting. Fuel pumps have a check valve in them that keep fuel in the rail at the injectors. If the check valve fails, the pump has to pump fuel all of the way up to the engine. Same thing with hot no-restarts. Fuel pump.

Aug 08, 2008 | 1995 Toyota Tacoma

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...