Question about 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Need to know what the fuel tank looks like - 2001 Dodge Ram 1500 Truck 2WD

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 541 Answers

It the big container under the truck which is attached to the fuel filler tube i.e where you put the gas

Posted on Dec 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have 2008 ford focus. Had issues with it starting, got it started (using starter fluid) but everytime i give gas it dies.


the fuel filter is not in the tank,the fuel pump might be thats why you need the haynes repair manual to see where these items are located,fuel filters are usualy outside the tank on the fuel line and the fuel pump might be able to be accessed under your back seat or trunk,but you would need the manual to know for sure or look it up on a search engine

Jan 16, 2013 | 2008 Ford Focus

1 Answer

Need 2 know how 2 remove gas tank so i can replace fuel pump


TO REMOVE FUEL TANK FIRST YOU NEED TO MAKE SURE FUEL SYSTEM BEEN DEPRESSURIZE. YOU CAN REMOVE FUEL PUMP RELAY LET CAR RUN UNTIL DIES LACK OF GAS. THEN CRANK ENGINE OVER FEW TIMES MAKE SURE ALL GAS OUT OF FUEL LINES. THEN REMOVE FUEL CAP THEN DRAIN FUEL TANK.YOU CAN BUY A SIPHON AT ANY AUTO PARTS STORES, DONT SIPHON GAS WITH MOUTH CAN BE VERY FATAL.ONCE FUEL OUT OF TANK. SAFELY RAISE SUPPORT VECHICLE ON JACK STANDS, MAKE SURE VECHICLE SITTING ON LEVEL SOLID GROUND. LOOK UNDERNEATH VECHICLE REMOVE FUEL FILTER DISCONNECT FUEL PUMP ELECTRICAL WIRE CONNECTOR, THEN REMOVE EVAP CANISTER, VENT SOLENOID, AND VAPOR LINES DISCONNECT FUEL LINES, THEN REMOVE THE LOWER FILLERHOSE GOING INTO FUEL TANK. LOOK AROUND TANK YOU PROBABLY HAVE TO REMOVE HEAT SHIELD AROUND GAS TANK AND REMOVE EXHAUST PIPES IF IN THE WAY. GET A LARGE FLOOR JACK AND THE PLACE A PIECE WOOD ON FLOOR JACK SADDLE.THEN RAISE FLOOR JACK JUST ENOUGH SUPPORT FUEL TANK THEN REMOVE FUEL TANK SUPPORT STRAPS THEN SLOWLY LET DOWN THE FUEL TANK. TO FINISH DISCONNECTING FUEL LINES AND REMOVING FUEL PUMP. BE SURE AFTER YOU DEPRESSURIZE FUEL SYSTEM TURN OFF RADIO AND REMOVE THE NEGATIVE BATTERY CABLE.

Aug 04, 2011 | Chevrolet Cavalier Cars & Trucks

1 Answer

My Malibu's gas indicator is not working it looks like it just hangs down. It doesn't point to any level of gas. How to fix?


Hi, this is a common problem you need to get the sender unit in the tank replaced as the one you have got now is not working, the problem is to do this you need to make sure the tank is low on fuel or empty as you need to lower the tank because you need to get to the top of the tank to get the sender unit out as it comes out from the top of the tank.

have a look to see if you have an inspection panel in the boot/trunk under the carpet about the size of a saucer from cup and saucer, if you find this panel you dont need to make sure the fuel is low as the tank can stay in place but if you have no panel you need to undo all the pipes and electrics to the tank and then lower the tank to get access to the sender unit.

if you doing this yourself then the best thing to do would be to buy the new sender unit so you know exactly what your looking for when getting the old one off.

before you think about changing the sender unit check your fuse box and check every fuse and if one is blown replace it for one of the same type then check the fuel gauge as it could be a blown fuse but most of the time its the sender unit in the tank

let me know how you get on or if you need further assistance ok

please rate this solution, thanks

Dec 15, 2010 | Chevrolet Malibu Cars & Trucks

1 Answer

I am looking at putting an auxillary diesel fuel tank in my 1989 ford f250 and need to know what electric psi pump i need and also if I am able to just hook it up to the fuel lines and run power to it, or...


Get the pump from Ford that goes to truck.You will also need a fuel solonoid to switch from one tank to another.You will have to run fuel lines from both tanks to solonoid along with wires to both pumps also a dash switch to switch tanks

Dec 09, 2010 | 1989 Ford F 350

2 Answers

Need to know how to replace a fuel pump


Here is what I looked up: Fuel Pump Removal & Installation To Remove:
  1. Remove the fuel tank.
  2. Disconnect the pressure transducer connector on the top rear comer of the fuel tank.
  3. Clean the area around the fuel pump mounting flange.
  4. Remove the bolts and remove the fuel pump.
CAUTION
The fuel pump must be handled carefully to avoid damage to the float arm and the filter.
Remove and discard the fuel pump mounting gasket.
To Install:
  1. Clean the fuel pump mounting flange and the fuel tank mounting surface.
  2. Install the fuel pump mounting gasket on the mounting flange.
  3. Position the fuel pump in the fuel tank. NOTE: Tighten fuel pump bolts in a star pattern.
  4. Install the bolts. Tighten to 10 Nm (89 in. lbs.).
  5. Connect the fuel pressure transducer.
  6. Install the fuel tank.
prev.gif next.gif

Jul 05, 2010 | 2000 Mercury Grand Marquis

1 Answer

Need to know location of fuel pump relay on a Mazda mpv 3.0l v6 1997 model


The pump is in the tank. Before you consider dropping the tank. Lift the carpet in the back seat above the tank. The older MPVs had a trap door which would access the pump with out dropping the tank. It is definitely worth a look. I changed mine in half an hour.

May 11, 2010 | 1997 Mazda MPV

1 Answer

Fuel pump


Disconnect the negative post on the battery.
Support the tank with a jack with a plywood piece.
Disconnect the metal straps holding the tank.
Slowly lower the tank.
Disconnect the fuel lines from the top of the tank and plug them with a screw or something similar in size.
Remove the retainer ring holding the fuel pump/sending unit with a brass punch and hammer.
Pull the fuel pump/sending unit out and replace it.

May 21, 2008 | 1989 Ford Tempo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...