Question about 2002 Toyota Highlander

1 Answer

Water in tail light lenz need to remove How? - 2002 Toyota Highlander

Posted by Anonymous on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 39 Answers

Remove the lense. drain out what you can then blow a hair dryer in on low to evaporate the remaining. the hard part is to find how the water got in. use a clear glue or silicone.

Posted on Dec 31, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Need to change stop/tail lamp on Scenic dci 2011. I've removed the two visible screws but the light cluster will not move! Can you help please?

With the hatch open there are two T-20 torx screws on the tail light that need removed. Tail light should come out unless for some reason someone has sealed it in with a silicon or some other adhesive. May have to pry gently on tail light next to area where screws are removed to pop out tail light. Will have to unplug electrical connection from back remove light from vehicle. 3 tabs on back of tail light to manipulate to remove bulb section.

Apr 01, 2017 | Cars & Trucks

2 Answers

How do i keep water out of my trunk

New trunk seal , that rubber thing around the edge of the opening !

Nov 01, 2015 | 1998 Buick Regal

2 Answers

How to replace tail/brake light

This varies slightly per car, but it's common to look for screws or nuts near the assembly itself. Replacing bulbs is pretty self explanatory with a bit of patience and the right bulb

Aug 27, 2014 | Cars & Trucks

1 Answer

Remove tail light lens cover

remove the compleate lamp, not the lenze

Jan 04, 2014 | Cars & Trucks

1 Answer

Trunk leak-cant find the rear drains from sunroof

If water is in the trunk, then it is probably getting in through the rear tail lights. Common problem with early 90's Honda cars. To check, hose down the trunk area and tail lights, then look at the gaskets from inside the trunk. You'll probably will see some water. To fix, you need to take each tail light out and place a seal of silicon caulk between the body of the car and the tail light gasket and replace the tail lights. This should solve your water in the trunk problem.

Jan 23, 2011 | 1993 Honda Accord

1 Answer

We checked fuses and relays, bulbs and the rear lights still dont work.

the newer gms have kind of a curcuit borad type lenz assembly,i took mine apart and put screws in it to make it thighter and it worked ,check make sure you getting voltage to the connector put on 4 way flashers and tail light on ,you can buy cheapper assembly at surefit aftermarket if you dont want to try to fix it i wish you could fit the old type lense ,they were fine for many years

Nov 29, 2010 | 2003 Chevrolet Silverado 2500HD

1 Answer

Tail light water

It leaks between the red lens and the black or grey back. You can either buy a new lens or remove the old one after removing bulbs, drain it and put a thin layer of rtv (caulk) around the seam

May 12, 2010 | 2002 Chevrolet TrailBlazer

2 Answers

Water in tail lights

I had the same problem a few years ago with an 86 Volvo. I replaced the tail light assemblies but over time water was getting inside the lens again. My solution to the problem was to remove the tail light assemblies and drill a small hole (about 3/16") on the bottom of each compartment of the lens (if the tail light is sectioned off) and a 1/16" vent hole in the top or side area where it can't be seen. It worked for me and it didn't cost a dime. Hope this helps.

Apr 14, 2009 | 2005 Chevrolet Impala

2 Answers

Tail light removal

You remove the tail light by removing the nuts or bolts from inside the trunk area. This is what holds the tail light in place.

Jul 21, 2008 | 1998 Honda Accord

Not finding what you are looking for?
2002 Toyota Highlander Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides