Question about Dodge Durango

Open Question

Location of thermostat for a 1999 dodge durango 5.9L

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: THERMOSTAT PICTUREDIAGRAM OF 1999 DODGE INTREPID, 2.7 ENGINE SIZE

Thanks for your help. But I got the answer that I need.

Posted on Oct 21, 2008

Ad
  • 217 Answers

SOURCE: getting rear gears out of the difential case 1999 dodge durango

  1. Raise and support vehicle. Ensure that the transmission is in neutral.
  2. Remove wheel and tire assembly.
  3. Remove brake drum. Refer toBrakes, for proper procedure.
  4. Clean all foreign material from housing cover area.
  5. Loosen housing cover bolts. Drain lubricant from the housing and axle shaft tubes. Remove housing cover.
  6. Rotate differential case so that pinion mate gear shaft lock screw is accessible. Remove lock screw and pinion mate gear shaft from differential case
  7. Push axle shaft inward and remove axle shaft C - clip lock from the axle shaft
  8. Remove axle shaft. Use care to prevent damage to axle shaft bearing and seal, which will remain in axle shaft tube.
  9. Inspect axle shaft seal for leakage or damage.
  10. Inspect roller bearing contact surface on axle shaft for signs of brinelling, galling and pitting. If any of these conditions exist, the axle shaft and/or bearing and seal must be replaced

Posted on Feb 11, 2009

awcforever
  • 359 Answers

SOURCE: Crank sensor location 1999 dodge durango

The crank sensor is on the front of the motor on the case of the timing gear. If you want to replace it, the sensor itself isn't the problem, but you have to actually reset your timing, and get it recalibrated. If the timing isn't set, you can possibly damage your engine. But as far as location, it should be fairly easy to find. Hope all works out.

Posted on Feb 22, 2009

  • 66 Answers

SOURCE: replace thermostat in 2000 durango

If you look down on the radiator, on the left side, there is a larrge hose coming out of the radiator toward the engine. Where the hose ends there is a housing with 2 bolts. The Thermostat is found under that. Remove the 2 bolts an replace the thermostat. Unles your arms are very long and thin, you will probably need to do this from under the car.
Perfect time to flush/fill all coolant. Check and replace any needed hoses/clamps.

Posted on May 05, 2009

  • 323 Answers

SOURCE: 1999 dodge durango heater core

It's a big job. Drain the coolant down, recover the freon in the ac system and disconnect the lines and heater hoses. Lower the steering column, remove the instrument panel assembly, remove the heater housing. Split the case halves on the housing and there you are. Usually around 500 to 700 dollars at a dealership.

Posted on May 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the thermostat located on a 2005 dodge durango?


2004 Dodge Durango Thermostat change - YouTube

? 4:04
https://www.youtube.com/watch?v=jjHJK2EtfUk
Jun 25, 2012 - Uploaded by GrindTimeAuto
Replacing the Thermostat on a 2005 Dodge Dakota - Duration: 3:41. by Clint Holland 3,104 views. 3:41. 2015 Dodge DurangoLimited Start Up ...

    Dodge Durango 4.7 coolant, thermostat, and auxiliary water ...

    ? 11:25
    https://www.youtube.com/watch?v=zAqU2rxxIlY
    Dec 5, 2010 - Uploaded by lenpenn
    Auxiliary Water Pump Replacement Coolant Drain and RefillThermostat and Lower Radiator Hose Replacement. images for Where is the thermostat located on a 2005 ...


Dec 26, 2015 | 2005 Dodge Durango

1 Answer

1999 durango engine temp struggles to rise above 130 degrees driving or idling heater blows luke warm air . Is there a sensor for this ? maybe thermostat ?


Thermostat is located on the bottom of the engine. Follow the bottom radiator hose to the engine and it will end up at the thermostat housing. not hard to replace, just messy

Nov 21, 2010 | 1999 Dodge Durango

1 Answer

1999 durango magnum : Where is the thermostat located for the durango magnum SUV .Illustration would doggond fantastic!


Hello lennroi: My name is Roger and I will answer your question for you. If you follow the upper radiator hose down to the top of the engine. You will find the thermostat. This is in a hole behind the A/C compressor.It makes no difference if you have a 3.9,5.2 or 5.9 engine. They are in the same spot.e3a5d3e.jpg Should you need further help just ask. Please rate the answer. This way I know your answer was helpful. Thank You for using Fix Ya.Roger

Oct 17, 2009 | 1999 Dodge Durango

1 Answer

Fuel filter location 1999 dodge durango


the fuel filter is located on the iner driver or pasenger side frame railing inbetween the front and rear doors. yes it has filter in the tank which is more comely know as the sock or straner. the filter will look like a metal canister .

Jul 29, 2009 | 1999 Dodge Durango

1 Answer

1999 Dodge Durango NO HEAT


Bad NEW thermostat? I had the same problem on my first generation Dakota. The problem for me turned out to be the DODGE thermostat I used to replace the old Dodge part. I went and got a Stant from local auto parts store using the standard temperature spec and quit shivering the next time I drove it. I hope that helps!

Jan 17, 2009 | 1999 Dodge Durango

1 Answer

Where is the coolant temperature sensor in a 2004 dodge durango


Follow the top hose from the radiator to where it connects to the engine,(The thermostat housing)
The sensor is located on the housing.

Jan 06, 2009 | 1999 Dodge Durango

1 Answer

What size speakers are in 1999 Dodge Durango


Car speaker fit guide - DODGE DURANGO 1999
According to our database, here are the speakers types that go in your DODGE DURANGO 1999 car, along with their location:
  • Front: 6-3/4"
  • Rear: 6-3/4"
  • Front door: 6-3/4"
  • Back door: 6-3/4"

Dec 17, 2008 | 1999 Dodge Durango

1 Answer

2004 DODGE DURANGO, 5,9L ENGINE


the message is appearing because a sensor in the transmission, usually in the transmission fluid, detects higher than normal temperatures which is usually a result of increased friction which isnt good. I would get the sensor checked before you get the transmission worked on.

Oct 07, 2008 | 2004 Dodge Durango

2 Answers

Overheating


Electrical cooling fans not coming on due to bad sensor, fan relay, or bad fans. Check thermostat and coolant temperature, too....accordianman

Jun 02, 2008 | 1999 Dodge Durango

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...