Question about 2000 Chevrolet S-10
If you lift the wiper arms off the window to reduce friction and operate the wipers, do they both move? If the shaft and wiper arm doesn't move on the bad wiper, take it to a garage as it is a big job to replace the mechanism. If the shaft of the bad arm moves, the nut holding the wiper arm onto the rotating shaft should be tightened. If that does not fix the problem you should remove the nut and wiper arm and inspect the splined shaft end for wear. Clean the grooves and reattach the arm. This will normally fix most bad wipers and helps them do their "wiping thing".
Posted on Dec 31, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Mar 30, 2014 | Acura Integra Cars & Trucks
Oct 14, 2012 | 2001 Oldsmobile Intrigue
The wiper motor on a Volkswagen is located directly underneath the plastic cowl cover. The cowl cover is located directly below the windshield.
Begin by removing the wiper arms by prying off the covers at the base of the arms and removing the nuts that secure the arms to the drive shafts. Label the passenger and driver arms so they can be installed in the same positions. They are not interchangeable. Remove the rubber hood to cowl weather seal. Unscrew the plastic fasteners from the driver's side of the cowl cover, then remove this half of the cover. Remove the fasteners from the passenger's side cowl cover and remove this half of the cover. Disconnect the windshield wiper motor wiring harness by separating the plastic wiring connector. Remove the three bolts that secure the wiper motor to the vehicle's body. Pull the motor slightly away from the body, then remove the nut that connects the motor shaft to wiper linkage. Remove the motor.
Place the new wiper motor into position in the cowl and reconnect it to the wiper arm linkage. Then reinstall the three retaining bolts. Reconnect the plastic wiring connector to the wiper motor wiring harness. Place the cowl covers into position below the windshield and reinstall the plastic fasteners that retain them. Reinstall the rubber hood to the cowl weather seal. Reinstall the wiper arms in the same position you removed them from, along with the wiper arm retaining nuts and lower wiper arm covers. Turn the windshield wipers on and test for proper operation. If the wiper blades slap against the bodywork surrounding the windshield, loosen the nuts that connect the wiper arms to the shafts and adjust.
Aug 06, 2012 | 1994 Volkswagen Golf
Jun 10, 2012 | 1996 GMC Sierra
Apr 07, 2010 | 1995 Ford Aspire
Oct 14, 2009 | 2000 Oldsmobile Alero
May 02, 2009 | 1995 Honda Accord
Jan 15, 2009 | 2003 Chevrolet Impala
Dec 10, 2008 | 2005 Chevrolet Impala
198 people viewed this question
Usually answered in minutes!