Question about Dodge Caravan

Open Question

2002 dodge caravan 2.4L how do i set timing marks

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: Changing a 2002 Dodge Caravan headlight

Hello, You remove the headlamp assembly by removing the 3 bolts that hold it in place. The bolts are #1 in the following picture:

7e81e20.gif

Posted on Oct 23, 2008

Ad
  • 373 Answers

SOURCE: replacing 2000 dodge caravan timing belt - how do

rotate crankshaft in a clockwise direction until both timing marks are aligned together on both camshaft gears and the crankshaft timing mark aligns with mark on the block just behind the crankshaft gear. you may need to rotate the crankshaft gear several times before you can get all the timing marks to align. once you have done this then insert a allen wrench in the hole on the belt tensioner and a small drill bit or a small allen wrench in the smaller hole. take the largr allen wrench and apply pressure counterclockwise until the small drill bit or allen wrench slides into locking hole to hold the belt tensioner in place. install belt and release the tensioner. (note: before starting work on engine remove the negative cable from battery).

Posted on Apr 30, 2010

  • 512 Answers

SOURCE: 3.3l dodge caravan, where to set timing chain marks

the top gear timing mark points at 6oclock...crank gear at 12 oclock

Posted on Sep 27, 2008

  • 104 Answers

SOURCE: Need install instruction for starter on 2002 Dodge Caravan

This is alittle tricky getting to some of the bolts but its not too hard to do otherwise. 2 bolts hold on the starter IIRC they are 13mm bolts. make sure your battery is dissconected by the black cable. then there will be 2 nuts holding on the starter wires. one will be 8mm and the other 13mm. remove them with care cause the wires may and can break. when you remove starter check wires for corrosion or if they look fraigle. repair them if damaged.
then to put it back in is the same way you took it out. should take about 1.5 hrs total if you have never done it before.

Overall i would say skill level 3/10 only cause its trickey getting to that top bolt sometimes.

good luck,
Michael

Posted on Apr 29, 2009

  • 149 Answers

SOURCE: 2002 dodge grand caravan fuse box

The fuse box is located under the hood. There is component map printed on the inside of the cover. This tells you on your model where the fuse or relay is located

Posted on Jan 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I set the clock


If there is an "H" and "M" marking on the right side of the radio panel, push the little dot beneath each, with a ball point pen to advance the hour and minute.

Dec 05, 2014 | 2002 Dodge Caravan

1 Answer

I need the timing marks for a 2000 dodge caravan 2.4 L


The timing belt sprocket on the crankshaft is marked with an arrow as well as the block. Make sure both cam sprockets have the word "up" reading horizontal, and the horizontal marks on both sprockets are lined up with each other. The rear cam sprocket is usually set one tooth of, then rotated with belt to take up slack.

84798964

Jan 30, 2011 | 2000 Dodge Caravan

1 Answer

Timing marks for the Dodge 2.4L caravan, 2000


To align both sets of timing marks, turn engine crankshaft to the right with belt on cam and crank. Once you have done this the crankshaft alignment mark (on front of crankshaft gear) will line up with mark to the rear of gear on engine block.The two cam gear timing marks should be alines across from one another. The right cam gear is the intake side and the left side is the exhaust side. After removing the belt turn the exhaust cam down 1/2 notch. Timing mark on exhaust 1/2 notch down from the intake side. Install new belt and recheck everything to make sure it's all correct. Hope this will help you.

May 16, 2010 | 2000 Dodge Caravan

1 Answer

Replacing 2000 dodge caravan timing belt - how do


rotate crankshaft in a clockwise direction until both timing marks are aligned together on both camshaft gears and the crankshaft timing mark aligns with mark on the block just behind the crankshaft gear. you may need to rotate the crankshaft gear several times before you can get all the timing marks to align. once you have done this then insert a allen wrench in the hole on the belt tensioner and a small drill bit or a small allen wrench in the smaller hole. take the largr allen wrench and apply pressure counterclockwise until the small drill bit or allen wrench slides into locking hole to hold the belt tensioner in place. install belt and release the tensioner. (note: before starting work on engine remove the negative cable from battery).

Apr 14, 2010 | 2000 Dodge Caravan

1 Answer

I have a 2000 dodge caravan trying to time it dont know how has a 3.0 motor


set the timing mark on the crankshaft to the mark on the oil pump, then set the timing mark on the camshaft to the mark on the alternator bracket/set second camshaft mark to mark on the inner timing belt cover. line up all mark as decribed. be sure before u set anything to bring #1 piston all the way up to top. with belt on turn crankshaft 2 full turns to bring #1 piston back to top if the cams are not lined up correctly loosen belt and start over again until everything lines up correctly. you may have to do this a few times but it will work.

Mar 31, 2010 | 2002 Dodge Caravan

1 Answer

Need de pocision for the timen belt of 2002 caravan 3.3 v6


Click on the following free direct Link. It has the Timing: Belt and Mark Diagrams for your 2002 Dodge Caravan. Plus additional Instructional and Directional Diagrams.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/2002/make/dodge/model/caravan/2002_dodge_caravan_timing_belt_diagram_marks.htm

Jan 02, 2010 | 2002 Dodge Caravan

1 Answer

Dodge ram50 1992 swap 2,4L to 2,6L


Greetings!

Yes, the engine mounts and bell housings are the same.
The swap should be straight forward, however be sure to swap all the vaccum controls and emission system from the 2.6L.

Have fun!
Cheers, Jay

Apr 29, 2009 | 1992 Dodge Power Ram 50

1 Answer

Dodge Caravan 2,4l 1997 timing belt change


you will need to change the belt tencioner aswell
if you havent don a cambelt before dont see youre local mechanic ok m8

Jan 03, 2009 | 1997 Dodge Grand Caravan

1 Answer

3.3l dodge caravan, where to set timing chain marks


the top gear timing mark points at 6oclock...crank gear at 12 oclock

Sep 27, 2008 | 1996 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

311 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...