Question about 1998 Chevrolet S-10 Pickup

1 Answer

How do I bleed the manual transmision on my 1998 S-10

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 376 Answers

There is ne bleeding neded to be done, simply pull the drain plug to empty and replace, then remove the fill plug just above it, and fill it up till it starts pouring fluid out of the fill hole, then replace the plug wipe clean and done. the clutch will be bled in the same way the brakes would be done.
pump it about four to five times and hold it down on the fifth, while holding it down slightly open the bleeder valveto release the trapped air. repeat this until no air comes outand is just fluid. may take about an hour or two to complete succesfuly.

Posted on Dec 31, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Diagrama de transmision manual 4x4

necesito manual de despiese de la transmicion manual toyota land cruisser2005

Jan 22, 2013 | 1999 Toyota 4Runner

1 Answer

Where is the thing to bleed the clutch on a 1992 nissan king cab?

its by the transmision under the truck. its mounted to the side of trasns. follow the hose and you will come to this funny looking thing with a small bleeder screw.

Dec 17, 2010 | 1992 Nissan King Cab

1 Answer

I have an Isuzu Rodeo 1998 2.2L manual transmision. There is a disturbing noise while driving in a 3rd gear. It is hard to make a shift into the 2nd gear & 3rd gear. What is the problem?

This sounds like the syncros are going out but you may have a clutch on it's way out as well. This might also have a clutch resivoir under the hood like and near the brake fluid resivoir. Check the fluid level. If it was low you may need to bleed the clutch like brakes. That is hard for me to tell you how unless I am there. It is not at all difficult but ask around on here if it comes to that. I hope this helps, The Raz

Apr 17, 2010 | 1998 Isuzu Rodeo

1 Answer

I have a 2002 Passat wagon, with a1.8 l engine and a 5 speed automatic transmision. By mistake I drained the transmision. |How do do I refill the transmision so that I can take it to a shop to top it up...

Find the transmission filler tube under the hood. Get a funnel, and fill. Do not overfill, and use proper tranny fluid for your cars' specifications. Your user manual should have a capacities index, and the type of trans. fluid to use listed somewhere in the manual. Hope this helps.

Apr 02, 2010 | 2002 Volkswagen Passat

1 Answer

How to bleed a slave cylinder on a Saturn?

tyhe bleeder is down on the transmision

May 15, 2009 | 1997 Saturn SL

1 Answer

Gear oil

like most maual trans u need 80-90w thats what i use in all my vehicles you can also ask any auto parts store they can look it up on their computers

Jan 23, 2009 | 1999 Subaru Legacy

1 Answer

Installing rear manual transmision seal

Installing a rear seal on the tailshaft of a manual transmision is very easy,,you dont need a manual to do this,,just a good proper sized seal installation tool,,,(you can borrow or rent )

Dec 31, 2008 | 1994 Ford F350 Crew Cab

1 Answer

Changing gears very stiff

try 1 0f these solutions giving the cars age and not much discription.
1 check the level of your gear box oil

2 change the gear box oil or if automatic change the fluid for the transmision.( since you say changeing gears i take it that it's manual gear box.

3 if manual the gears need over hauled giving the age of your car.

4 your clutch cable needs adjusted due ware on the clutch or if hydraulic the clutch system needs bleed with new fluid.

Oct 18, 2008 | 1997 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
1998 Chevrolet S-10 Pickup Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8265 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides