Question about 2002 Nissan Xterra

1 Answer

How locate the knock sensor on 2002 nissan xterra

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 66 Answers

Your knock sensor bolts into the side of the cyclinder head opposite side of your oil cap. It has a banjo type fitting, where it has an open center where the bolt threads through and it will have a electrical connection "pig tail" coming off the sensor and running back to the engine harness. Hope that helps.

Posted on Dec 31, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
techbuster
  • 5081 Answers

SOURCE: where is the knock sensor for the 04 nissan xterra

Your knock sensor is located undernesth the air intake manifold on top of the engine block. This goes for 2000-2004 xterra V6 3.3L models.

Posted on Nov 05, 2009

chiquititas
  • 1010 Answers

SOURCE: knock sensor

Go to nissan's web-site, you will find the answer there.

Posted on Jun 17, 2008

HyeProfile
  • 35 Answers

SOURCE: Trying to replace the knock sensor in my 2000

From the service manual:457bed1.png

Posted on Aug 05, 2009

ZJLimited
  • 17970 Answers

SOURCE: Diagram available for 01 Nissan Xterra Knock Sensor location?

V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an experienced mechanic about 3-4 hours to replace.

9bd8ec7.jpg

Fig. Engine compartment component locations

Hope this help (remember rated this free help) Good luck.

Posted on Feb 08, 2010

  • 1 Answer

SOURCE: nissan xterra knock sensor

I have a 2000 Nissan Xterra my check engine light came on the scanner read knock sensor came up how to replace it and location

Posted on Mar 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bypass knock sensor on 2002 xterra


these are designed to be placed were they are so it will only pick up a knock from the engine and not other things bolted to the engine. just replace the knock sensor were it was designed to work best.

Aug 22, 2014 | 2002 Nissan Xterra

1 Answer

Knock out sensor


unless your xterra is supercharged, you really do not need to replace it. its a lot of work, because its located way down under the upper plenum and lower intake. its way down there. if it is supercharged, you do need to replace it, because it puts the supercharger into fail safe mode and truck till not run to its full potencial.

May 24, 2013 | 2002 Nissan Xterra

1 Answer

Location of 2002 nissan xterra 3.3 knock censor


Hello
There are 2 knock sensors. They are located under the intake manifold in the right and left cylinder head.

Oct 04, 2011 | 2002 Nissan Xterra

1 Answer

My 2002 nissan xterra keeps dying at low idle, I had auto zone trouble shoot this and they said it was my knock sensor. Could this part fix my issue?


it is absolutely not the knock sensor so dont waste time and money on it.your stalling condition is due to something else.

Feb 27, 2011 | 2002 Nissan Xterra

1 Answer

Knock sensor 2000 nissan xterra V6, location of sensor? how to change knock sensor?


Hello the sensor is located under your intake manifold you will need to remove the intake manifold to gain access to it here is photos of what and where your looking for thisregeetone_0.pngregeetone_21.jpg

Jan 23, 2011 | 2000 Nissan Xterra

1 Answer

Replaced the timing belt on an 02 niss xterra and starts like a champ but has a noise or knock now any suggestions??


Need to replace the Knock Sensor, Very Common issue with these vehicles, quite costly too, depending on where you are located approx. $600-$800 plus.

Dec 01, 2010 | 2002 Nissan Xterra

3 Answers

Diagram available for 01 Nissan Xterra Knock Sensor location?


V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an experienced mechanic about 3-4 hours to replace.

9bd8ec7.jpg

Fig. Engine compartment component locations

Hope this help (remember rated this free help) Good luck.

Feb 08, 2010 | 2001 Nissan Xterra

1 Answer

Where is the knock sensor for the 04 nissan xterra located?


Your knock sensor is located undernesth the air intake manifold on top of the engine block. This goes for 2000-2004 xterra V6 3.3L models.

Nov 05, 2009 | 2002 Nissan Xterra

4 Answers

Nissan xterra knock sensor


It's the valley of the engine underneath the intake manifold. It's about an $800 job because the top of the engine has to come off. However, unless you have a supercharged xterra it shouldn't effect performance. Also, the knock sensor will not trip the check engine light, as it does not indicate a primary problem, so if your light is on you should have another code that should be fixed first.

Nov 05, 2008 | 2002 Nissan Xterra

Not finding what you are looking for?
2002 Nissan Xterra Logo

851 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...