Question about 1994 Buick Roadmaster

1 Answer

Easy way to put in heater core - 1994 Buick Roadmaster

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Buick Master
  • 4,340 Answers

There is no easy heater core install on your car. This is a delicate job, and it is easy to damage hard to get pieces of your heating system. This is one job best left to a qualified shop.
It is easy to damage the new heater core during installation.
Pressure test the system when finished.

Posted on Dec 31, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

Can someone plz tell me were the block heater is an how hard is it to put on 03 fl60 mbe 900 made the mistake of buying a southern truck lol an i live up north no winter provisions

there are circular inset flat plugs on the block of your motor,you have to drain the antifreeze from your vehicle,knock out that plug and replace with the block heater

Dec 17, 2016 | Cars & Trucks

1 Answer

I have coolant leaking from the heater core inlet tube; how easy is that to fix myself and is there a temporary fix I can try if I have to have a pro do it?

Get ready to pull the dash out to replace the core, it ain't easy and paying someone who has done it before is the only practical fix. The easy fix is to pull both hoses off and put a short piece of pipe between them to remove the core from the system. Note that your defroster and heater will be no good.

Nov 15, 2010 | 2002 Dodge Stratus

1 Answer

I put coolant in radiator and I get a/c but my heat doesn't work. I think my heater hose was bypassed by the previous owner. How do I fix the problem?

You should be able to look down in between the motor and the firewall and see if the heater hoses are attached to the heater core. Most of the time when they are bypassed it is because the heater core has started to leak. Instead of replacing the heater core (not a fun or easy job) they just bypass it so they won't leak coolant. So, if it is bypassed your probably looking at replacing the heater core in order to get heat.

Nov 09, 2010 | 1995 Pontiac Grand Am

1 Answer

Rear heater core line leaking, can I fix w/ rubber hose and clamps? The leak is right below drivers side door. There are four lines that run to rear heater core but only one is leaking.

yeah hose and clamps are the cheap easy way to go there, or if your lucky, the leak is right at the spot where the hose meets the metal and you can just cut the end off and put it back with the old clamp

Jun 27, 2010 | 2004 Chevrolet Venture Passanger

1 Answer

Replace heater core is it easy or not any info

Dennis, replacing a heater core is never easy on a car unless you can access it from under the hood. More than likely you will have to remove it from inside the vehicle under the dash on the passenger side. Removing it and installing it is the easy part. Getting to it is the hard part. It is just a matter of removing enough dash parts to gain access to the core. That is the hard part. This is why this is a very expensive repair as the majority of the cost is labor. The core itself it relatively inexpensive. Look under the hood and follow the heater hoses to the firewall. You will then know the location of the core and know if it can be removed from under the hood. If you have to remove it from inside the vehicle just slowly start taking parts of the dash off and go very slow. Take photos is necessary in order to remember how to put it all back together. Some dash panels will snap off and some will be held in place with a screw or clip. Be very careful and do not break and parts. You can do this if you take you time.

May 17, 2010 | 1994 Plymouth Acclaim

2 Answers

How to install a heater core on a 2005 dodge grand caravan

Very easy if you go through the lower part near the peddles

Dec 24, 2009 | 2005 Dodge Caravan

1 Answer

91 chevrolet s10 blazer heater core access?

not really. IT is under the dash on the passenger side. You should put some plastic down or pull the carpet or it will get soaked with anti freeze

Oct 01, 2009 | 1991 Chevrolet S-10

1 Answer

How to replace heater core on my 1998 chevy blazer

pretty easy to do. go to passenger side of dash and remove glove box for working room. there is a lower panel below the dash that needs to be removed. disconnect the heater hoses under hood. once panel under dash is removed you will see the heater box remove the 6-8 bolts around the very base of it, it will able to be lowered down and you will see the heater core it has a couple of brackets that hold it in place remove these. put new one in its place and put back together.

Aug 26, 2009 | 1998 Chevrolet Blazer

1 Answer

Heater Core Replacement for 1986 Buick Electra Park Ave

there is no easy way to change out a heater have to take the bottom part of the dash loose and that takes some doing. once you get the bottom of the dash apart you will see the heater core.then you have to go under the hood and unhook both water lines that run to it, you should then be able to pull the heater core out and install the new one

Feb 09, 2009 | 1986 Buick Electra

1 Answer

Leaking heater core

Yup, I've done the same thing before. You have to just find a tube of some sort that is small enough to fit inside the hose's going to and from the heater core. Remove both hoses from the heater core, insert the tube into the hoses and put some clamps on both sides nice and tight! Good luck

Dec 30, 2008 | 1999 Ford F150 Regular Cab

Not finding what you are looking for?
1994 Buick Roadmaster Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides