Question about 2001 Chevrolet Blazer

1 Answer

Spark plg change steering column in way - 2001 Chevrolet Blazer

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,102 Answers

Your talking about the middle plug on the drivers side on a V6 right? Just did one for a customer a few days ago. I used the plug socket and then used an offset wrench on the top of the socket and turned it about 1/8 of a turn at a time. I have taken the column off at the bottom before, but didn't want to this time. It is time consuming. Be patient and it will come out.

Posted on Dec 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I changed the steering column out on my 2000 mercury grand marquis and now car won't start there's no spark at the spark plugs


Is it possible that in the transition you you did not properly reconnect the ignition wires in steering column?

Oct 20, 2015 | Mercury Cars & Trucks

1 Answer

Need to change the ignition switch


Steering Column Trim Cover Replacement
Removal Procedure
Caution: Refer to SIR Caution in the Preface section.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
  2. Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
  3. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  4. Remove the steering wheel. Refer to Steering Wheel Replacement .
  5. Remove the gap hider. Refer to Instrument Cluster Replacement in Instrument Panel, Gages, and Console.
Put the steering column in the CENTER position. Remove the tilt lever (1).
Remove the retaining screws (3) from the lower steering column trim cover. Disconnect the closeout trim cover from the lower steering column trim cover.
Remove the retaining screw (2) from the upper steering column trim cover (1).

Sep 10, 2015 | 2004 Buick LeSabre

1 Answer

How to remove spark plug from steering colum


There is no spark plug in the steering column so you don't need to change that one.

Jun 12, 2014 | 2003 Chevrolet Blazer

1 Answer

1992 gmc vandora is not getting spatk i changed the spark module under cap distributer pick up the coil and the ignition switch on steering column any suggestions


Did you change the Spark Plugs too? The coil is new you said. Might want to thing about replacing all the Spark Leads to new ones, they may be dead, just replace them all, even the main one.

Jan 04, 2014 | 1992 GMC G2500

1 Answer

How to reset warning light


unolug the battery for 30 minsor plg it in to diadnostic

Sep 29, 2012 | 2010 Toyota Fortuner 3.0D-4D

1 Answer

I can't fit my tools behind the steering column to change the middle spark plug on the drivers side. isn't there a way to disconnect the steering column to move it?


yo--bozo-----5/8 plug socket w/end wrench---also take out the rubbbbbbbbbbbbbbbber boot out of the socket for clearance---------------bozo-------yo

Apr 09, 2011 | 2000 Chevrolet Blazer

2 Answers

My 91 honda accord lx wont start, so i replaces the spark plugs, spark wires, cap, gasket valve, and it still wont start, it turns over but doesnt start?


if no fuel pressure or spark its probaly the "Main Relay" this is located under the steering column. hope this helps.

Apr 21, 2010 | 1991 Honda Accord

2 Answers

Diagram on to change turn signal arm on 1994 chevy cavalier , do u have to pull the sterring wheel


1991-94 Cavalier
See Figure 5
This procedure covers removal and installation of the headlamp, headlamp dimmer switch, turn signal and hazard switches, as well as the cruise control switch.
  1. If equipped, disable the SIR system. For details, please refer to the procedure located in of this repair guide.



0900c1528003bf08.jpg enlarge_icon.gif enlarge_tooltip.gif Fig. Fig. 5: View of the steering column showing the turn signal switch location
  1. If not already done, disconnect the negative battery cable.
  2. Unfasten the horn pad, then remove the steering wheel. For details, please refer to the procedure earlier in this section.

If necessary, using locking pliers with a piece of rubber (such as a spark plug boot) between the jaws to help prevent damage to the tilt lever during removal.
  1. If equipped, remove the tilt lever from the steering column by grasping the lever firmly and twisting counterclockwise, while pulling it from the column.
  2. Remove the upper and lower steering column covers.
  3. Remove the dampener assembly, then unfasten and remove the switch assembly from the vehicle.

To install:
  1. Position and secure the switch assembly.
  2. Install the dampener and the upper and lower steering column covers.
  3. If equipped, attach the tilt lever to the column.
  4. Install the steering wheel, then fasten the horn pad.
  5. If equipped, enable the SIR system, as outlined in of this repair guide.
  6. Connect the negative battery cable.

Nov 15, 2009 | 1994 Chevrolet Cavalier

1 Answer

83 regal keeps cutting off in traffic


its going to be something in the steering column...my regal did the same thing to me and i ended up having to put in a new column

Feb 19, 2009 | 1983 Buick Regal

1 Answer

1998 OLDSMOBILE BRAVADA SPARK PLUG #3


you can remove it with a swivel plug socket

Oct 21, 2008 | 1998 Oldsmobile Bravada

Not finding what you are looking for?
2001 Chevrolet Blazer Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...