Question about Dodge Durango

1 Answer

I have a -00 Dodge Durango and the immobilizer kicked inn. The remote works but the immobilizer wont stop. I have removed the battery (negative) + tryed to turn the key while battery disconected, what to do?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 14,036 Answers

TRY ANOTHER KEY YOUR VECHICLE SHOULD HAVE 2 PROGRAM KEYS. TRY THE OTHER KEY.PUT IN IGNITION.TURN ON IGNITION SWITCH FOR 10 SECONDS UNTIL IMMOBILIZER WARNING LAMP BEGIN TO FLASH AN ACOUSTIC SIGNAL IS EMITTED.SWITCH OFF THE IGNITION SWITCH.IF THIS PROCEDURE DONT WORK.TURN KEY ON IN THE IGNITION FOR 60 SECONDS.UNTIL IMMOBILIZER WARNING LAMP FLASHES AND ACOUSTIC SIGNAL IS EMITTED. THEN TURN OFF IGNITION SWITCH.

Posted on Jan 07, 2011

  • Jonah Oneal Jan 07, 2011

    IF YOU STILL CANT GET THE IGNITION SWITCH IMMOBILIZER TO WORK.THE IGNITION SWITCH FAULTY OR THE IMMOBILIZER CONTROL MODULE FAULTY.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replacement of headlight switch on 2002 chrysler concorde lsi


the following is the factory service manual for your car:

http://oskin.ru/pub/chrysler-dodge/manuals/Service%20Manuals/2002_LH_300M_Concorde_Intrepid/02lhe.pdf

goto page 8L- 21

  • (1) Open hood and disconnect the negative battery cable remote terminal from the remote battery post.
  • (2) Remove the left end cover, left instrument panel trim cover, and the cluster bezel. Refer to the various Removal and Installation procedures in this section.
  • (3) Remove the three screws retaining headlamp switch to cluster bezel.
  • (4) Remove headlamp switch from bezel.
a youtube of a dodge durango has a similar switch on their dash as well: except for the column shifter


Apr 12, 2015 | 2002 Chrysler Concorde

1 Answer

Radio reset 2003 durango


Dodge Durango Stereo Removal 2004-2007 - YouTube

? 3:05
www.youtube.com/watch?v=LEuFEXBZobM
Mar 23, 2013 - Uploaded by Factory Car Stereo Repair Dodge Durango Stereo Removal 2004-2007 .... an amp inside tht if stock radio is removed it will not work unless u connect an adapter tht costs ...
Search Results
    images for 2003 dodge durango wiring

Apr 05, 2015 | Dodge Durango Cars & Trucks

1 Answer

How can i know if my starter relay is bad on a dodge stratus 2001


IF STARTER RELAY BAD THE STARTER WONT MAKE NO NOISE AT ALL HEADLIGHTS WONT DIM.IF YOU CLICKING NOISE BATTERY VOLTAGE TOO LOW. MAKE SURE BATTERY VOLTS ARE 12.6 VOLTS AND USE TEST LIGHT TO SEE IF STARTER GETTING POWER.COULD HAVE BLOWED IGNITION FUSE OR FAULTY IGNITION SWITCH. TO CHECK STARTER SOLENOID FIRST TURN OFF RADIO THEN REMOVE NEGATIVE BATTERY CABLE AND POSITIVE BATTERY CABLE.THEN REMOVE STARTER BUY A REMOTE SWITCH.YOU NEED BATTERY JUMPER CABLES HOOK BATTERY JUMPER CABLES TO BATTERY PUT POSITIVE CABLE ON POSITIVE BATTERY POST THEN PUT NEGATIVE BATTERY CABLE ON NEGATIVE POST. HOOK BATTERY CABLES TO STARTER USE NEGATIVE CABLE GROUND STARTER BODY AND PUT POSITIVE BATTERY CABLE ON THE LARGE POSITIVE POST ON STARTER SOLENOID. NOW TAKE REMOTE SWITCH HOOK RED WIRE TO STARTER SOLENOID POSITIVE POST THEN HOOK BLACK WIRE TO REMOTE SWITCH TO STARTER SOLENOID SWITCH TERMINAL WITH LETTER S THEN PRESS REMOTE IF STARTER SPINS STRONG WITH A GOOD KICK STARTER GOOD.YOUR PROBLEM COULD BE CORRODED WORN BATTERY CABLES. WEAK BATTERY FAULTY IGNITION SWITCH. IF STARTER DONT WORK WHEN YOU PRESS THE REMOTE SWITCH STARTER SOLNOID BAD OR STARTER ITSELF BAD.IF ALL IS GOOD. CODE SCAN CAR FOR THEFT SECURITY FAULT CODE.

Aug 28, 2011 | 1999 Dodge Caravan

1 Answer

Where is the bcm(body control module) on a 2001 dodge durango and what does it look like? all of my electrical is going bad like my parking lights wont turn on my control pannel lights wont turn on and my...


BCM on the 2001 durango was also known as the CTM but regardless it is located on driver side kick panel where your left foot would be if you are driving. there is two screws to remove panel. its a black box with three plug ins.

Oct 06, 2010 | 2001 Dodge Durango

1 Answer

2003 dodge durango windows, headlights, 4x4 wont work


please email me answer as soon as possible to chillinonli@optonline.com thankyou

Jul 23, 2010 | 2003 Dodge Durango

1 Answer

They starter is loose but when you turn the key it kicks over but doesnt start


I guess you checked the battery condition but what you are describing can be that 1st. The cables probably need to be removed and scrubbed with a terminal brush (auto parts store). Remove the negative battery first, then the positive (to prevent welding your tools to the car), then clean battery and cables.
If that doesn't cure it, you will have to do the other ends of those same cables.
If you have no dielectric grease, use petroleum jelly liberally on all connections before reattaching them.

Dec 17, 2009 | 1999 Dodge Durango

1 Answer

A/C clutch does not kick in too charge the A/C


try and reset ac by disconecting the negative battery cable and back on againNOTE;;;; check with dodge to make sure u wont loose memory in the ecm before u proceed

Jul 06, 2009 | 2000 Dodge Durango

2 Answers

2004 durango possible electric not sure


You probably need a new brake switch. In addition to turning the brake lights on and off, it also allows you to move out of "park" since you can only shift with your foot on the brake. The switch is up in the drivers footwell and has a button on it that is controlled by the brake pedal itself. Check your fuses before you get a new switch.

Mar 25, 2009 | 2000 Dodge Durango

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

890 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...