Question about 2006 Nissan Murano
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Close all vehicle doors, LOCK doors using drivers side switch.
Insert key all the way into the ignition, (do not turn) remove key.
Repeat this step 5 times. (6 total)
Hazards should flash to indicate program mode.
Press any button on transmitter to be programmed, hazards should flash to indicate successfull program.
*For additional remotes, cycle drivers door lock UNLOCK, LOCK, press any button on remote, hazards should flash. Repeat step as necessary.
Ignition ON, (engine off) ignition OFF, UNLOCK using drivers side switch, test remotes.
Posted on Aug 06, 2008
You probably already figured this out, but you have to remove the wiper arm completely in order to replace the wiper blade.
The blades are an unusual size (somewhere around 14 1/2") and I believe they are only available from a Nissan dealership. They include printed instructions in the box but just in case, this is from the official Nissan service manual:
Posted on Jun 29, 2009
Hello windy....There are a few thing on the murano that could cause this... one is the exhaust gussets that go to the bottom of the oil pan to the exhaust, they can crack and cause a rattling noise. Also I have seen the rear exhaust heat shield spot welds come loose and cause a rattling noise, from exhaust manifold down pipe on the cat. converter. I would check them first, also the park brake cable will lose tension and rattle on the undercarriage.
A more serious problem would be the timing chain and/or chain tensioners...these are known to make noise around 50-60k. The tensioners are operated from oil pressure, the face gets worn, the chain stretches and it results in a rattle or a slapping noise
Useing a full synthetic oil with regular maintaince will help prevent premature wear.
Good luck, i hope this helps..please rate me a fixya.
Posted on Jul 31, 2009
To change the headlight bulbs, you will need to remove the wheel liner cover to gain access to the back of the headlamp assemblies. Then you can pull off the screw cap / cover that seals the bulb into the headlamp assembly for the bulb you want to change. Once the cap is off, you will need to disconnect the harness from the back of the bulb. With the harness off, you will then need to either twist a black lock ring to release the bulb, or you will need to push on a metal lever to release the bulb (this varies on models and high and low beams).
Install in the reverse order....
Posted on Nov 16, 2009
Tips for a great answer:
Aug 31, 2016 | 2004 Nissan Murano
May 23, 2014 | 2005 Nissan Murano
Feb 22, 2014 | 2003 Nissan Murano
May 27, 2013 | 2005 Nissan Murano
May 17, 2012 | Cars & Trucks
Jan 29, 2010 | 2005 Nissan Murano
Jan 20, 2010 | 2003 Nissan Murano
137 people viewed this question
Usually answered in minutes!