Question about 1994 Land Rover Range Rover County

2 Answers

Range rover v8 1994 no power to fuel pump thinking relay but there is a cut off switch under dash you have any of these problems

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had the same problem there was 2 relays under drivers seat i replaced both at a cost of £7.00 and solved the prob hope this helps

Posted on Jan 30, 2009

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 53 Answers

Some one must have press the switch to cut off the fuel pump, easy solution..
just press again on the cut off switch, to activate..

Posted on Oct 10, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

4.0 V8 range rover 96 where does the fuel pipes connect to the engine?


Undo the junction before the injectors and turn on the ignition to see if fuel is pumping. Most likely it is not but I doubt there is a broken pipe - more likely a broken power wire

The pump is in the top of the tank. Remove the carpet and cover plate to get to it. Turn on the ignition and use a multimeter to check if there is power to the connectors. The sensor wire will only show about 5 volts but the power wire should show 12 volts or more.

If no power, trace the wire under the vehicle to find the break and re-join it - preferably with solder and shrink but spade terminals and shrink will do. Alternatively run a new wire from the pump to a switched wire under the dash but this is a lot more work


May 25, 2015 | 1996 Land Rover Range Rover

1 Answer

Range rover 3,9 1990 runs on lpg but will not run on petrol


check all fuses think fuse for pump is under drivers seat on uk models. If fuse ok check for power and earth at the connection on fuel pump. if power and earth possible fuel pump.

Mar 06, 2014 | 1990 Land Rover Range Rover

1 Answer

Location of the fuel pump relay for p38 1998 range rover


Relays are located in the "under hood relay/fuse panel" on the passenger side between the radiator overflow and the battery. Remove the lid and on the underside of the lid you will find the diagram. The fuel pump relay will be indicated by a graphic of a fuel filling station pump. The relay itself is yellow. Also check the pump fuse, located in the same relay box and if needed check your inertia cutoff switch located in the passenger footewell. There is a panel to the right just under the glove box. It has a popout access door but its much easier to remover this small panel and providing clear access to the switch. Push down on the rubber cover on top of the switch. If it is engaged you are ok here. If when you push down you hear a click then the inertia cutoff was switched somehow and this cuts fuel supply. These switches have plastic internal parts and dont take much to fail. Hope this helps. Happy to provide further suggestions if you wish to repost more info. Good luck!

Apr 21, 2013 | 1999 Land Rover Range Rover

1 Answer

1994 ford explorer, new fuel pump,new fuel pump relay,no power to fuel pump


Have you checked the fuel ppm cut off switch? It should be under the passenger side of the dash. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Feb 21, 2012 | Ford Explorer Cars & Trucks

2 Answers

Air suspension inactive. Fuse ok. No light on dash switch. Ideas?


Get a kit to replace air suspension...most likely you have compressor problem like many rovers...

Jun 14, 2010 | 2004 Land Rover Range Rover

1 Answer

Fuel pump relay switch and shut off location


There is a safety switch that can be reset under the hood on the passenger side under the fuse box panel.

Jun 19, 2009 | 1998 Land Rover Discovery

2 Answers

Land rover not starting


hard wires the pump and see if the car runs ok, if so there is a problem in the power wire, possibly a dud computer or wire along the way. if this is the case an auto elec would be the best thing for it...

Feb 19, 2009 | 1987 Peugeot Liberte

2 Answers

98 Range Rover EAS pump problem


Disconnect the thin wire on the suspension pump , this is the overheat switch which sticks at times.If it's working after that use a solution of dish liquid and water and spray this all over the pipes, connectors and air springs to find your leak.

Aug 31, 2008 | 1998 Land Rover Range Rover

Not finding what you are looking for?
1994 Land Rover Range Rover County Logo

Related Topics:

255 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

61168 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...