Question about Chevrolet Camaro

1 Answer

Is there anyway to tell which pushrod goes where for a 95 v6 3.4 camaro?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

Not really.Should have been marked when removed.They are all the same.Length and thickness,Dont matter where you replace them at.If you rebuilt the motor then I would just replace them and they dont cost much either.

Posted on Dec 31, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How much does it cost to have someone replace pushrods in a 2001 Camaro v6 3.8l


About 3 hrs start to finish if only the pushrods
But the extra costs and time for the damage caused by the faulty parts could take 30-40 hrs to repair

Dec 31, 2015 | 2001 Chevrolet Camaro

1 Answer

Passanger side window on my 95 camaro wont go up


check the switch on drivers door and passage side most of the time switch goes out

Sep 04, 2011 | 1995 Chevrolet Camaro

1 Answer

RECENT ENGINE ROOM FIRE VAPORIZED ALTERNATOR HARNESS AND CONNECTOR ON THE ALTERNATOR BOUGHT CONNECTOR FOR ALTERNATOR AND REPAIRED DAMAGED WIRING IN ENGINE BAY WHAT I NEED IS A DIAGRAM OF CONNECTOR HARNESS...


Hi, this is a 2 wire Delco alternator. The wire from the terminal on the back goes to the battery or starter, and the other (excite) wire goes to the battery light in the dash. It also goes to the PCM--not sure which pin, sorry.

jturcotte_1339.gif

Mar 27, 2011 | 1995 Chevrolet Camaro

1 Answer

WHAT KIND OF ENGINE OIL IS RECOMMENDED FOR THE LE BARON COUPE,AUTOMATIC,V6,3 LITRE MITSIBUSHI ENGINE1990


Mopar 5W-30 is what the book will tell you. Any good name brand 5W-30 will work.

Feb 01, 2011 | 1990 Chrysler LeBaron

1 Answer

My 95 camaro transmission will go backward but not forward ?


governer is not working right. Get it checked at a tranny shop. Don't let them tell you its a rebuild, cause its not. Just the governer adjustment.

Jan 10, 2011 | 1995 Chevrolet Camaro

1 Answer

Is there anyway to convert my headlight on my 95 camaro to one with a screw in bulb.


The headlight system in your car is set up for that car ... There is no way to retrofit a screw in style bulb for your car... unless you have enough money and time... in which case ; Most anything can be done ....

Sep 28, 2010 | 1995 Chevrolet Camaro

2 Answers

95 chevy camaro with pass key will not start. Replaced key and it started. Later it did not start. What's going on? What are some things to try?


If it's the same as the VATS system in my 86 Corvette (resistor pellet in key) the ignition switch might need to be replaced. The contacts on the key wore low, replacing the key helped for a short time but the new contacts wore the switch down faster then it too needed to be replaced. $200!

Nov 16, 2009 | 1995 Chevrolet Camaro

1 Answer

Falling loose pushrod inside 350 chevy engine 1992


you don't really have much choice but to disassemble the motor, or at the least remove the oil pan, the push rod should be in there. if you see any part of the pushrod from the top try using a magnet to retrieve it.

Sep 02, 2009 | 1992 Chevrolet Camaro

2 Answers

Will a GM 60 degree V6 work in my '97 Rodeo LS V6 4wd


NO! Call a salvage yard, they have info. on what will fit it.

Jun 04, 2009 | 1995 Isuzu Rodeo

1 Answer

How to change plugs on 1995 camaro


It would be to hard to tell and show you over the computer.
The best way for you is to buy a Chilton manual for your car at the autoparts store. The book runs about $20
This book is a do-it-yourself bible. It will show you everything you need to know on how to do maintenance and repair on your vehicle.

Apr 07, 2009 | 1995 Chevrolet Camaro

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...