Question about 2007 Dodge Ram 1500 Quad Cab Sport

2 Answers

E.T.C. light on dash,runs tickover only,can switch engine off and back on cures problem for few mins.then back to tickover only. problem only occurs when vehicle moving, will rev all day when stationary

Posted by on

  • pmcroft Jul 08, 2008

    this is not an alternator or battery fault the electtronic throttle control light comes on and then the problem starts

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,472 Answers

Your vehicle is still under warranty. I would bring it right to the dealer as it is way too soon for a problem like that and for you to have to worry about it.
Thanks,
Lee

Posted on Jul 08, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 135 Answers

Hello sir

if the lights flicker and the motor doesn't start you have a dead battery. If everything works alright and the lights just flicker, It's the excited gas hog anticipating sucking up more gas winking at you.

thanking u

Posted on Jul 08, 2008

  • Harrish Mugundhan Jul 08, 2008

    addiitionally



    Your problem is most likely with the battery. Check your voltage or have your mechanic professionally test it with a carbon pile tester. In most cases when this happens your battery is dead, however there is a chance that your battery is fine and your altenator isnt charging the battery. Try and throw a new battery in there and see what happens! If the same thing occurs after a few days then you'll know its your altenator.Make sure you carry around some jumper cables!

  • Harrish Mugundhan Jul 08, 2008

    hello sir



    Your throttle pedal is electronic and not controled by cables anymore. So there is sensor that sense's what postion your throttle body needs to be opened or closed. The sensor probably needs to be replaced. The whole pedal assembly will have to come out and be replaced as it is all one unit. They are easy to take out.



    You can try resetting the ETC as well. Place you vehicle in the run position without starting and depress the gas pedal and release all in 2 seconds (1 down and 1 up). You should hear a confirmation "ding" if done correctly and you have know reset the sensor to know when you have open throttle.


    thank u

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

E 280 w211 runs fine. Recorded 59.3 mpg on long run at 65mph in cruise. If left on tickover for a few mins ie junction or traffic lights blue smoke from exhaust. Car does not burn oil


Bad valve stem seals will cause smoke under these circumstances. It will get worse. The reason this happens is because the higher engine vacuum present in traffic will pull oil past the worn valve stem seals into the cylinder. When you accelerate again, the engine burns this small amount of oil causing the smoke.

Sep 15, 2016 | Cars & Trucks

2 Answers

My temp gauge goes to H after driving 15 mins, my radiator & hoses are not leaking, theRes no steam , water pump works and thermostat was already removed. Anyone have idea of what it could be?


Do you see bubbles comming to the surface in the radiator as the engine is running --if you do --leaky head gasket -- if not you need to repace the sending unit for the temperature guage --- if this does not cure the problem you need to replace the cluster of guages on dash -- could be quite expensive to do the last cure

May 01, 2014 | 2002 Chrysler Sebring

1 Answer

2005 lincoln ls tool light comes on after starting and running for a few mins engine has no rpm.


the light is telling you to run the fault codes to find out what sensor/position switch has failed so that you can have it fixed.

Jan 09, 2014 | 2005 Lincoln LS V6

1 Answer

Electrical problems on 2003 H2 Hummer


there is many contacts in the ignition switch sounds like the switch is bad

Jun 27, 2012 | 2003 Hummer H2

1 Answer

I have a 91 nissan maxima and it runs find for about 15-20 min. and it truns off. I wait a few min. and it runs for an other 15-20min. and turns off. can any one help me. thanks Mr. Garcia


Sounds like an overheating component. If there is not a "check engine" light on in the dash, then you have a bad part which is not monitored by the onboard computer.

Sometimes Relays will overheat, other times a bad fuelpump will easily do this. When the exhaust starts to heatup, the feedback from the O2 sensors can reset the fuel mix and stall an engine.

About all you can do is check the test port on the fuel rail for fuel pressure when it stalls out. A pressure gauge may be borrowed from Autozone, Advance, or Oreilys tool programs.

You can get a electric diagram and fusebox layout by registering your car on Autozone.com. Then the print out is free. A fuelpump relay or ignition relay may cure it. Check your horn relay for an emergency relay if it is the same part number on its case as the fuel relay then test by switching relays.

Mar 29, 2012 | Nissan Maxima Cars & Trucks

1 Answer

90 f150 rough idle in park and neutral. drive fine.


Hi, Seems like a possible inlet air leak or to low engine revs, tickover rpm to low.outside chance engine oil to thick, try lower vicousity engine oil. this sometimes works with a rebuilt motor. Could be engine is just still tight from rebuild,1-2000 miles running in should cure this. if still low mileage.

Jan 23, 2012 | Ford Cars & Trucks

1 Answer

E52,F32,F48 codes are displayed cars stalls on the move or sitting still after running for a little time when running and stall occurs the speedometer flips back and forth a few times the check eng. and...


Sounds like an electrical problem. Check connections to battery remove & clean them , check + wires to engine, to power supply for the engine management.

May 29, 2011 | 1991 Cadillac DeVille

1 Answer

Skoda Octavia Ambiente 2004 1.9 tdi, automatic gear: Problem1: board alarm, Glow plug system remains on at starting and contiune to flush in running. Engine starts hardly second or third time. Problem2:...


problem one is the timer control for the heaters ,also check the heaters that they are working ,oil problem ? look under the rubber boot that goes over the oil switch ,pull it back and if oil under the cover renew the oil switch,these motors do suffer from heater light flashing on and i know people have spent megabucks trying to cure it ,its a fault with dash and printed circuits ,but the heaters are not coming on i know because i have driven one with the heater circuit light coming on and i had a extended light on a long wire and the heaters are not coming on ,ignore it just renew the faulty glow plugs,as for EGR valve just pull teh vacumn pipe off the ERG valve and leave disconnect ,more hassle than its worth changing it ,you could end up with a ECU computer .Still a nice reliable motor though and economical

Jan 21, 2010 | 2004 Volkswagen Golf

2 Answers

Shorting wiring in dash


check along bottom edge of dash cover for screws, sometimes there are a few at the top as well...generally once they are removed the dash face will pop off with moderate pulling. Once off, you can access the light switch easily. (you may need to remove the lower cover to locate dash screws)

May 28, 2009 | 1994 Oldsmobile Cutlass Supreme

Not finding what you are looking for?
2007 Dodge Ram 1500 Quad Cab Sport Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...