Question about 2003 Volkswagen Passat

1 Answer

Need abs wiring diagram for 2003 vw passot,abs light and traction controll light is on, wife drove in snow with traction controll on, parked car next time drove car light was on, brakes ok, fluid full, I now fluid level should not trip this light, have snap on scanner, but no abs cartridge, tryed to clear code by unhooking battery cable, hooked up cable, turned key on, light is on with out moving car, if I had good print I could test sensors and wiring at module,need help mack.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Ur blake light switch needs replaced I had same problem.

Posted on Jan 19, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2003 cadillac cts was stuck in park and abs brake and traction lights are on replaced shifter wire car is not in park anymore but abs brake and traction light is still on. Also, resurfaced rotars and...


Low brake fluid level could cause that. Bad ABS wheel sensor. Brake switch. Go to Autozone and ask them to put the scanner on and see what codes you're getting.

Jan 30, 2015 | 2003 Cadillac CTS

1 Answer

How to reset ABS sensor on a dodge 1500,2011


Have the truck checked for damage to the wheel
hub speed sensor or wiring

There is a reason the abs light is on

Jan 03, 2013 | Dodge Cars & Trucks

1 Answer

2006 cadillac abs and traction control light on and grinding when my tires spin


You can thank the Federal Govt for the Trac Control that is
imbeded into the ABS Braking System

I have that on my 2004 Lincoln LS & sorry I ordered it

On snow it cuts off injectors & slams on rear brakes

Total Waste & useless technology from my 1960's
perspective. I live in the US but grew up in Canada
so I have lots of experience in snow,more in NJ than Ont

I have yet to figure a way to disconnect it using the wiring
diagrams

Nov 30, 2012 | 2006 Cadillac CTS

1 Answer

2003 lincoln ls traction control always on


Have the ABS Braking System tested

You most likely have a Bad Wheel Speed Sensor

The Control Switch on console does absolutely nothing,I know
I have a 2004 LS

You can not disconnect a thing
I have the factory wiring diagrams &
the answer is no

You have dash lights on-- why have you not checked for
codes & resolved the problem,same procedure when
ever any dash light stays on after motor is running

An dash light on you have an OBD2 system failure

Oct 18, 2012 | 2003 Lincoln LS

1 Answer

ABS and service traction light came on while coming to a stop on an icy road.


This is probably normal as on ice or snow your wheels will slip and both the traction control and ABS will activate. Does your brake pedal vibrate a bit. It also means you are probably going to fast for road conditions

Feb 28, 2011 | 2003 Chevrolet Monte Carlo

1 Answer

ABS light is constantly on this happened after I went through some snow I had also the (((!))) sign flashing, but now it is gone Golf 4, 1.4 16V 1999 Please advise. Thank you so much


that sign is your traction controll kicking in trying to keep the car under controll by applying the brakes to the tire that is spinning it can engage the ABS too your ABS controller is more than likely damaged and needs replaced it is a common problem with VW ABS systems.

Feb 08, 2010 | 1999 Volkswagen Golf

1 Answer

2006 focus ABS and Traction control lights came on


It may have pushed one of you sensor back away from your tone wheel its a common problem,all you have to do is push the sensor back againts your wheel and it will set itself,I hope this helps you and thanks

Dec 10, 2009 | 2006 Ford Focus

3 Answers

03 Yukon Denali Traction Control/ ABS Problems


my 2000 yukon has the traction control light on and the abs light on any anwsers?

Jul 31, 2009 | 2003 GMC Yukon Denali

1 Answer

Traction system light and abs light


Traction control systems measure wheel speed differences by various methods to determine if one wheel is rotating faster than the other. A heavier buildup of ice/snow could be affecting wheel rotation speed causing the TCS to engage. ABS works by sensing slippage at the wheels during braking, and continually adjusting braking pressure to ensure maximum contact between the tires and the road. Suggest clearing out the wheel wells now and periodically throughout the winter. Also remove ice/snow build up between the wheel and the brake pads/rotor.

Jan 19, 2009 | 2003 Chevrolet Impala

1 Answer

ABS/Brake and Traction Light On-Beeping


You are loosing power Because the Computer is Shifting the Transmission in to Traction Low to get out of the Situation. The ABS Light is coming on due to Wheel spin. It is telling you that there has been an Unexpected Incident and to slow down.

Jan 10, 2009 | 2007 Volkswagen Rabbit

Not finding what you are looking for?
2003 Volkswagen Passat Logo

612 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...