Question about 1984 Dodge D150

1 Answer

'I have a 1984 Dodge D 150 and theTurn signal switch clicks while wheel is being turned in either direction. It started after I replaced the switch. What causes this?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

  • Expert
  • 65 Answers

There is normaly a clicking sound as we turn the wheel this is just the reliese system so the flasher switch will go back to center

Posted on Dec 31, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to replace an ignition switch on a 1984 dodge d 150 pickup

Thankyou for connecting me. But electroncis entertainement equipments repair is my area of expertise. I can't post a solution to your car's probelem. Sorry.

Dec 10, 2011 | 1984 Dodge D150

1 Answer

1984 ram 150 225 engine 4speed starter?; at first

have you tried to roll the pickup and put it in first gear because you have to roll the pickup to a certain speed like 10 mph or so and then put it into first gear should start the pickup. If this does not work that you have serious engine problems with that old pickup and might be inside the tramsmission problem. So let me know if this works out

Jun 09, 2011 | 1984 Dodge Pickup 4WD

1 Answer

Turn signals will not work. replaced all bulbs, fuses, turn signal switch. I still have one bulb that does not work at all ie, when hazards light are on.

sound like either a bad wire or some have a fusible link that can go bad.
A faulty hazard switch which also has a built in relay like the turn signal, can cause problems as well.

Sep 29, 2010 | 1984 Ford F 150

1 Answer

Horn, brake lights, tail lights, hazard lights, and turn signals all quit working on 1984 Ford F-150 after the ignition switch was replaced. Checked connections from installing new ignition switch, checked...


I have a 89 F-350 and had same problem. Check your turn signal switch connectot, it may have come unplugged when replacing the ignition switch, turn signal switch controls all the lights you describe. If connector is OK, check switch itself It is made out of plastic and with time, gets brittle and cracks, then the wires get loose and somethimes it shorts things out.

Don't forget to rate this solution, Good Luck!!

Apr 17, 2010 | 1984 Ford F 150

3 Answers


This could be the multifunction switch which is basically attached to your turn signal lever in that model, it could also be the bulb, or the connection to the bulb, I would start simple, just remove the bulb verify the connector is not burnt at contact points and the pigtail wire is fully connected.

Aug 27, 2009 | 1984 Chevrolet S-10

1 Answer

No turn signal, hazard lights, drl

The problem is most likely the turn signal switch located in the steering column, tough to replace without the proper experience and specialized tools. The air bag and steering wheel need to be removed to replace the switch.

Aug 02, 2009 | 1997 Dodge Caravan

1 Answer

1995 F150 the turn signals do not work, but

Look in the fuse panel and the turn signal flasher is the big round most likely yellow or silver in the corner of fuse panel. The emergency flasher is in the back side of fuse panel right directly behind the turn signal flasher.
Remove the emergency flasher and install it in place of the turn signal flasher and see if this corrects the problem and if so get a new flasher. If this does not correct it problem will most likely be the multi-function switch.

Mar 13, 2009 | 1984 Ford F 150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

80263 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides