Question about Ford Explorer Sport Trac
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Above is correct, some body panels are interchangeable some aren't...Headlights, front fenders, hood yes. Doors unsure, bed and back no (obviously). The underpinnings (suspension) are similar, but not exact...and depending on the year, the Explorer went to independent rear suspension, while the sport trac kept the solid axle differential.
Posted on May 15, 2008
Start the car
put in " N"
turn the 4X4 switch on
Then put in gear..
What do you see now?
Do the same in reverse when you take out of 4X4
Posted on Jan 19, 2009
You may want to check the relay that goes to the primary window. This will provide support to all the other windows. However, it may not just be the window relay, it could possibly be that between your window relay and your main switch there is a short or cut wire that is causing this problem. Unfortunately, you may need to visit your Ford Dealership to run a diagnostic on your wire or if you know an electronic shop that can run one to see if it is receiving and sending power. Have them check the main door fuse and window assembly to see that you are getting power.
Posted on Mar 19, 2009
Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.
The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.
Posted on Apr 02, 2009
Tips for a great answer:
Nov 03, 2016 | Ford Cars & Trucks
Nov 12, 2015 | 2005 Ford Explorer Sport Trac
Nov 13, 2013 | 2001 Ford Explorer Sport Trac
Jan 14, 2011 | Ford Explorer Sport Trac Cars & Trucks
Oct 28, 2009 | 2002 Ford Explorer Sport Trac
Jun 29, 2009 | 2006 Ford Explorer Sport Trac
Apr 02, 2009 | 2005 Ford Explorer Sport Trac
Dec 18, 2008 | 2004 Ford Explorer Sport Trac
Sep 19, 2017 | Ford Cars & Trucks
64 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: