Question about 2004 Dodge Ram 1500

Open Question

I have a 2003 Dodge Ram 1500 5.7 Hemi. I had a fault code P2106 P2108 come up saying that it was my Throttle Control module. I had a mobile mechanic come out. He confirmed that it was my Throttle Control Module, I needed a new one. He said, 4 bolts and I could replace it myself. I ordered it the whole Throttle Control Module today from the dealers, it will be in tomorrow. My question is, Do I have to get my truck Mapped or reprogrammed from the dealers once I install the New Throttle Control Module.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 412 Answers

SOURCE: Where is the throttle position sensor at on a 2005

THIS ENGINE HAS ELECTRONIC THROTTLE CONTROL..THERE ARE 2 THROTTLE POSITION SENSORS LOCATED IN THE THROTTLE BODY,COMPLETE ASSEMBLY MUST BE REPLACED IF DEFECTIVE..IT ALSO HAS SENSORS IN THROTTLE PEDAL ASSEMBLY AS WELL..WHAT TROUBLE ARE YOU HAVING?

Posted on Jul 09, 2009

Ad
  • 12 Answers

SOURCE: I have an 03 Ram 1500, engine light is on, I had

p0440 - Evap. system performance (this could be something as simple as not turning the gas cap several times after you fill up.

p0456 - Evap leak monitor Small leak detected. - Could be related to the previous code.

p2106 - Throttle Actuator Control System - Forced limited power : This one you might have noticed the vehicle running rough, overdrive not working properly and cruise control will not set.

p2175 - Throttle Actuator Control System - Low airflow detected.

What you might want to try first is have the codes cleared which most auto parts stores offer this for nothing (unless you have a programmer then you can do it yourself). Pour in some fuel injector cleaner into your gas, put a new air filter on. And when you fill up your gas tank, crank the cap several times when you put it back on.
See if the codes come back on after that.

Posted on Nov 22, 2009

  • 249 Answers

SOURCE: replace timing chain on 03 dodge ram 1500 with 5.7 hemi

i have an 02 and i purchased a repair manual from autozone

Posted on Jan 05, 2010

  • 18 Answers

SOURCE: Throttle/Pedal Position Sensor/Switch

typical problem, replace the TPS (Throttle Position Sensor) it is located directly opposite of the throttle cables on the throttle body. 2 bolts save the bolts for the love of god SAVE THE BOLTS they are "trilobal" and come verry much in handy later. but it is an easy 10 minute fix and if my memory is correct they are torx head bolts from factory.

Posted on Mar 16, 2010

emissionwiz
  • 76846 Answers

SOURCE: p2106 p1618 p0522 p172 p1793

can tell u from 30 years of experience that this problem needs to go to a dodge dealer, this requires specialized equipment to troubleshoot that you could never afford to buy, specialists at the dealer to look at this... I do call them as i see them, this problem is way over the head of a home do it yourself-er

Posted on Oct 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The electronic throttle control light is flashing in my 2004 1500 5.7 Hemi truck, won't accelerate but does turn on, where should i start?


The 1st thing that MUST be done is to have the electronic engine control system computer (called the "PCM") scanned for fault codes, this gives you the starting point for diagnosis od why the warning/fault light is on. You can get the scan for fault codes done for free at any Autozone or similar discount auto parts store in your area. Aamco Transmission does the scan for free as well.

Nov 13, 2011 | 2004 Dodge Ram 1500

1 Answer

Where is throttle position sensor located on 2003 dodge ram 1500 5.7 hemi


The 5.7L V-8 engine does not use a seperate TPS on the throttle body

Jul 29, 2011 | 2004 Dodge Ram 1500

1 Answer

P2108 fault code, Exhaust & Gas lamp on instrument panel is on,


p2108 is- TAC module performance, From what I have read cleaning is usually a temporary fix and replacing the throttle body is the permanent fix.. ( throttle actuator control ). Try cleaning your TB before you replace it. good-day !

Jul 26, 2011 | Volkswagen New Jetta Cars & Trucks

3 Answers

How many spark plug wires does a 2003 Dodge ram 1500 hemi have


Eight...

2003 Dodge RAM 1500 5.7 liter Hemi V-8 VIN "D"

zjlimited_0.gif

Dont forgetted rate this answerr. Good luck.

Nov 02, 2010 | 2003 Dodge Ram Maxi

1 Answer

What is a p0307 code on a dodge truck 1500 5.7 hemi 2004 the truck is missing on one cyl.


P0301-P0308....2T catalyst........2004-05 Ram...Cylinder 1-8 Misfire Detected Conditions: Any time engine is running and the adaptive numerator has been successfully updated. When more than 1.5% (300M, Magnum), 2% (Durango, Ram), 2.5% (Durango LEV, Ram LEV), misfire rate is measured during 2 trips, or with 10-30% misfire during 1 trip. 3 good trips required to turn off MIL. Possible Causes: ASD relay output 2 circuit fault Injector control 1 circuit fault Coil control 1 circuit fault Ignition wiring, spark plug, or ignition coil fault Fuel pump inlet strainer plugged Restricted fuel supply line Fuel pump module fault Fuel pressure leakdown fault Fuel injector is damaged or has failed Engine mechanical problems exist PCM has failed. Hope this helps you. Thank You for using fixya.If you like this solution please rate it....Thank You, iluv2fish....Ray

Jun 24, 2010 | 2004 Dodge Ram 1500

1 Answer

I have an 03 Ram 1500, engine light is on, I had


p0440 - Evap. system performance (this could be something as simple as not turning the gas cap several times after you fill up.

p0456 - Evap leak monitor Small leak detected. - Could be related to the previous code.

p2106 - Throttle Actuator Control System - Forced limited power : This one you might have noticed the vehicle running rough, overdrive not working properly and cruise control will not set.

p2175 - Throttle Actuator Control System - Low airflow detected.

What you might want to try first is have the codes cleared which most auto parts stores offer this for nothing (unless you have a programmer then you can do it yourself). Pour in some fuel injector cleaner into your gas, put a new air filter on. And when you fill up your gas tank, crank the cap several times when you put it back on.
See if the codes come back on after that.

Nov 21, 2009 | 2004 Dodge Ram 1500

1 Answer

Where is the throttle position sensor at on a 2005 Dodge Ram 1500 Hemi 5.7L v8?


THIS ENGINE HAS ELECTRONIC THROTTLE CONTROL..THERE ARE 2 THROTTLE POSITION SENSORS LOCATED IN THE THROTTLE BODY,COMPLETE ASSEMBLY MUST BE REPLACED IF DEFECTIVE..IT ALSO HAS SENSORS IN THROTTLE PEDAL ASSEMBLY AS WELL..WHAT TROUBLE ARE YOU HAVING?

Jul 09, 2009 | 2005 Dodge Ram 1500

3 Answers

Electronic Throttle Control


DTC P2106 Throttle actuator control system-forced limited power DETECTION CONDITION
• The PCM monitors the throttle actuator control current when the ignition switch is on. If the control current is less than 8 A or more than 11 A, the PCM determines that the throttle actuator control system is under forced limited power. Diagnostic support note
• This is a continuous monitor (CCM). • The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle. • PENDING CODE is available if the PCM detects the above malfunction condition. • FREEZE FRAME DATA is available. • The DTC is stored in the PCM memory. POSSIBLE CAUSE
• Throttle actuator malfunction • Connector or terminal malfunction • Open circuit in wiring harness between throttle body terminal A and PCM terminal 1B • Short to power supply in wiring harness between throttle body terminal A and PCM terminal 1B • Short to GND in wiring harness between throttle body terminal A and PCM terminal 1B • Open circuit in wiring harness between throttle body terminal B and PCM terminal 1C • Short to power supply in wiring harness between throttle body terminal B and PCM terminal 1C • Short to GND in wiring harness between throttle body terminal B and PCM terminal 1C • PCM malfunction
and for the other one

the dealers need to reflash the powertrain module ( ETC ) ...

hope i'll not get that problem on my 04 hemi...

Dec 19, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

950 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6910 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...