Question about Honda Accord

Open Question

The driver door window will not roll up straight. It drops forward after its about half ways up and it jumps out of the weather strip from the top back corner.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2920 Answers

SOURCE: Water is leaking into my 1986 el camino from the

get some clear rtv sealant and fill in the gaps...its only 3 or 4 dollars a tube

Posted on Feb 17, 2009

redbeard00
  • 957 Answers

SOURCE: driver's window won't roll up all the way

If you have power windows it should be a broken cable, If its manual then it should be the crank asm. or the white plastic trac, it may torn at the end.

Posted on Apr 26, 2009

  • 4 Answers

SOURCE: window goes up then down half way on drivers side

This worked for me on a 55 reg:

Disconnect the battery for 30 seconds. Then follow the calibrate instructions that can be found under "Windows" in the owner's manual. Took less than 5 minutes in all to fix.

Posted on Jun 01, 2009

  • 396 Answers

SOURCE: 04 Beetle Driver's side window sensor issue (maybe?)

Not likely. You have a defective window regulator. To fix remove the door panel. Peel down the warer barier. Remove the window motor and check it. If the plastic plugs are defective replace. To remove the window regulator you will need a 1/4 inch punch to punch out the rivits and 1/4 inch drill to drill out the aluminum holding in the regulator. Replace these with 1/4 inch bolts and lock nuts.

Posted on Sep 11, 2009

  • 1986 Answers

SOURCE: Electric window only goes down half way

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal. It sounds like the guide rails may be loose and snagging the window. Or your regulator may be broken (not likely)

Posted on Sep 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove and install driver window weather strip on 1985 Chevrolet el camino?


The best way is remove the door panel and take out the glass. Part of the track is bolted in and some of it just presses into the channel. Any of the seals across the top of the door, like if the window is down and your arm is resting on them. These just pry off and push back on.

Sep 22, 2014 | Cars & Trucks

1 Answer

2005 equinox left front window some times will go up and down , however most times times it seems to stick won't go up or down unless you help it to start moving. Should you stop it half way it seems to...


I have a similar problem with the same window. The window doesn't stop moving but it tilts forward until it won't close properly leaving a 1 inch gap between the top left corner of the window and the door frame from the perspective of sitting in the drivers seat. I had the motor and regulator replaced but to no avail.
I took off the door panel, everything looked fine. Took off all the weather strips and the driver side mirror. Behind the mirror there is the top portion of the metal guide the edge of the window rides up and down. it was partially cracked and bulged out beneath the crack. I gently pounded it back in and cleaned out the guides on both sides with window cleaner and WD-40. The issue will not be completely fixed until I replace the metal guide but it runs much smoother now.

Apr 30, 2011 | 2005 Chevrolet Equinox

1 Answer

How to install window weather strip on a 57 chevy 2 door hardtop? Where is the best place to start, quarter glass or front door?


start at front of car and work your way back DO NOT stretch the weather strip when driving water comes from the front right? Also if it's a hard top change the window flap springs before the install good luck thats my fav. car of all CJ

May 11, 2010 | Chevrolet Chevy Cars & Trucks

1 Answer

Electric window only goes down half way


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal. It sounds like the guide rails may be loose and snagging the window. Or your regulator may be broken (not likely)

Sep 22, 2009 | 1994 Honda Accord

1 Answer

Drivers side window sticks have way up


Something inside is broken, obviously. If you can identify it from the picture you should be able to order that part (bring the diagram)
Diagram is power and manual.
9a3a68d.jpg

Sep 19, 2009 | 2000 Chevrolet Cavalier

2 Answers

1990 Honda Accord rear door window, wont go up last 2 inches


the motor is attached to a regulator.The regulator is basically a pulley with cable control.Have a look and see if the cable is binding or jump off the roller

Sep 16, 2009 | 1990 Honda Accord

2 Answers

Driver's window won't roll up all the way


If you have power windows it should be a broken cable, If its manual then it should be the crank asm. or the white plastic trac, it may torn at the end.

Apr 24, 2009 | 2002 Pontiac Grand Am

1 Answer

Replace window


what do you need to know? the small passanger window or door window?
if you are replacing the door window then you need to remove the doos cover on the inside of the car. Then remove the old window base from the tracks. Slowly slide the new window in ( removing the weather stripping on one side) once the window is in roll the windoe all the way down and replace the weather stripping

Feb 02, 2009 | 1996 Mercury Grand Marquis

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...